Streszczenie treści zawartej na stronie nr. 1
Operating Instructions US
Personal Audio
Mode d’emploi FR
Docking System
Manual de ES
instrucciones
RDP-XA700iP
Streszczenie treści zawartej na stronie nr. 2
Streszczenie treści zawartej na stronie nr. 3
Streszczenie treści zawartej na stronie nr. 4
Streszczenie treści zawartej na stronie nr. 5
Keep the lithium battery out of the reach of children. Owner’s Record Should the battery be swallowed, immediately The model and serial numbers are consult a doctor. located on the bottom of the unit. Record these numbers in the space Dispose of used battery promptly. Keep away from provided below. Refer to them children. whenever you call upon your Sony dealer regarding this product. The dating code and the nameplate are located on the Model No. Serial No.
Streszczenie treści zawartej na stronie nr. 6
8) Do not install near any heat sources such as Declaration of Conformity radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce Trade Name: SONY heat. Model No.: RDP-XA700iP 9) Do not defeat the safety purpose of the polarized Responsible Party: Sony Electronics Inc. or grounding-type plug. A polarized plug has Address: 16530 Via Esprillo, San two blades with one wider than the other. A Diego, CA 92127 USA grounding type plug has two blades and a third
Streszczenie treści zawartej na stronie nr. 7
For customers in Canada This device complies with Industry Canada licence- exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Ca
Streszczenie treści zawartej na stronie nr. 8
Table of Contents Overview of this Personal Audio Docking System .....................................................5 Guide to Parts and Controls ..........................6 Main unit .................................................6 Remote control ........................................9 Getting Started Preparing the Unit and the Remote Control ...................................................10 Connecting to an AC power source .......10 Preparing the remote control .................10
Streszczenie treści zawartej na stronie nr. 9
Overview of this Personal Audio Docking System iPod You can enjoy sound from an iPod, iPhone or iPad by setting it on the Docking Tray of this unit, while charging it at the same time (page 16). AirPlay You can enjoy sound from an iPhone/iPod touch/iPad or iTunes with this unit anywhere in your home (page 17). You will need to set your iPhone/iPod touch/iPad to a Wi-Fi network, and connect this unit to that network. Portable Audio Player, etc. You can listen to sound from an optional compo
Streszczenie treści zawartej na stronie nr. 10
Guide to Parts and Controls Main unit Top/Front A Docking Tray Green (flashing): The unit is being turned Press the Docking Tray on the front of the on. unit to open or close it. Red: The unit is in the standby mode. Set your iPod on the Docking Tray when Amber: The unit is in the network standby you want to operate it on the tray or charge mode. it (page 16). Tips � When the unit is in the network standby mode B Remote sensor (inside) and receives a command to playback on an C Reaction indi
Streszczenie treści zawartej na stronie nr. 11
E “iPod,” AUDIO IN buttons, indicators Selects a source device (page 16, 19). Lights up amber when the unit is in the iPod/AUDIO IN mode. F “AirPlay” indicator Lights up green when the unit is in the “AirPlay” mode. G LINK indicator Indicates the connection status of the wired/Wi-Fi network. Green (lit): Wi-Fi connection has been established. Green (flashing): Wi-Fi connection is being established. Amber (lit): Wired connection has been established. Amber (flashing): Wired connection is
Streszczenie treści zawartej na stronie nr. 12
Rear A WPS button Use to connect the unit to your Wi-Fi network, refer to the supplied “AirPlay via Wi-Fi Network Setup” for details. B LAN port Connect a network (LAN) cable (not supplied, page 12). C ALL RESET button Press and hold to reset the unit to the factory default settings (the ?/1 indicator starts flashing). Use a thin object, such as a small pin. D DC IN 19.5 V jack Connect the supplied AC adaptor (page 10). E AUDIO IN jack Connect to the line output jack of an external compon
Streszczenie treści zawartej na stronie nr. 13
Remote control A “iPod,” AUDIO IN buttons V (Up)/v (Down) button Selects a source device (page 16, 19). Selects a menu item or track for playback. Bu (Play/Pause) button E VOL (Volume) +/– button Starts playback of iPod. Press repeatedly to Adjusts the volume. pause/resume playback. > (Forward) button Go to the next track. Press and hold to locate a desired point. . (Backward) button Go back to the previous track. During playback, this operation returns to the beginning of the current track. T
Streszczenie treści zawartej na stronie nr. 14
Preparing the remote control Getting Started Before using the remote control for the first time, remove the insulation film. Preparing the Unit and the Remote Control Connecting to an AC power source To replace the battery of the remote control 1 Connect the supplied AC power If the remote control stops working, replace cord to the supplied AC the battery (CR2025) with a new one. adaptor. 2 Connect the AC adaptor to the DC IN 19.5 V jack on the unit. j the e side facing up Note on the AC
Streszczenie treści zawartej na stronie nr. 15
Turning on the unit Press the ?/1 button The ?/1 indicator starts flashing. You can operate the unit when the ?/1 indicator stops flashing and lights up green. The LINK indicator also starts flashing. You can set up or use the “AirPlay” function when it stops flashing. It may take a while for these indicators to stop flashing. Note After playback of the connected device has finished, if no operation is performed for about 20 minutes, the unit will automatically enter standby/network stan
Streszczenie treści zawartej na stronie nr. 16
Connecting Your Network See the following descriptions to determine the correct way to set up. Connecting to a Wi-Fi network Connecting to a wired network Option 1: Wi-Fi Connection using Option 4: Wired Connection WPS Push Button Configuration Connect the unit and a wireless LAN router/ Method access point by network (LAN) cable (not Setup device: Wireless LAN router/access supplied). Then turn this unit on. point The LINK indicator lights up amber when the connection is established (about
Streszczenie treści zawartej na stronie nr. 17
For Mac Option 3: Wi-Fi Connection Start Safari and select [Bonjour] under [Bookmarks], then select [RDP- using Access Point Scan XA700iP]. 1 Prepare for the following For PC Start the browser and input either of the devices. following URLs into the browser’s � This unit address bar. �Mac or PC � Wireless LAN router/access point • When using a network (LAN) cable � Network (LAN) cable (not supplied) if needed 2 Have your wireless network name (SSID) and Security Key (if applicable) availa
Streszczenie treści zawartej na stronie nr. 18
For Windows 7 7 Select the SSID of the wireless Turn on PC. LAN router/access point, then Click icon on the bottom of the screen. input the Security Key (if Select [RDP-XA700iP_Setup] from the network applicable). list. For Windows Vista Turn on PC. Click icon on the bottom of the screen. Click [Connect to a network]. Select [RDP-XA700iP_Setup] from the network list. 5 Perform steps 4 to 8 above. SSID The unit restarts automatically, then the LINK indicator lights up green when the
Streszczenie treści zawartej na stronie nr. 19
Note About the LINK indicator Once you press and hold the ALL RESET button, the settings of the unit are reset to the factory default settings. Lights up green. The Wi-Fi network connection is established. (Green) Flashes green. This unit is in the process of connecting to the Wi-Fi network. (Green) Please wait. Lights up amber. The wired network connection is established. (Amber) Flashes amber. This unit is in the process of connecting to the wired network. (Amber) Please wait. Flashes
Streszczenie treści zawartej na stronie nr. 20
� Do not carry the unit with an iPod set on the Docking Tray. Doing so may cause a malfunction. Enjoying the Audio Content � When placing or removing the iPod, hold the Docking Tray securely. � Before disconnecting the iPod, pause playback. Listening to iPod � If the battery of your iPod is extremely low, charge it for a while before operation. 1 Press the Docking Tray on the � Sony cannot accept responsibility in the event that data recorded to an iPod is lost or damaged when front of the
