Streszczenie treści zawartej na stronie nr. 1
instruction manual
PC Presenter
Computer Control
Streszczenie treści zawartej na stronie nr. 2
AMX Limited Warranty and Disclaimer AMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three (3) years from the date of purchase from AMX Corporation, with the following exceptions: • Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch overlay components that are warranted for a period of one (1) year. Disk drive mechanisms, pan/tilt heads, power supplies, MX Series products, a
Streszczenie treści zawartej na stronie nr. 3
Table of Contents Table of Contents Introduction ...............................................................................................................1 TXC-MS(L) Transmitter ..................................................................................................... 2 TXC-MS(L) controls ................................................................................................................. 3 TXC-MS(L) mouse controls.....................................................
Streszczenie treści zawartej na stronie nr. 4
Table of Contents Programming Transmitter Pushbuttons .......................................................................... 21 Exiting program mode............................................................................................................ 22 Programming the PC Presenter for Use With an Axcess Central Controller .................. 23 Creating a buffer for keyboard input....................................................................................... 23 Send_Commands ..
Streszczenie treści zawartej na stronie nr. 5
Introduction Introduction The PC Presenter PC is a wireless PC keyboard and mouse controller that can be used as a standalone unit or as an bus device connected to a Central Controller via AXlink; controlling PC keyboard and mouse functions, and devices connected to the AXlink bus. The PC Presenter transmitter is available with a built-in laser pointer (TXC-MSL), or without the laser pointer (TXC-MS). The PC Presenter (FIG. 1) consists of a TXC-MS(L) wireless transmitter and an AXR-MSE Wirel
Streszczenie treści zawartej na stronie nr. 6
Introduction TXC-MS(L) Specifications Dimensions (HWD) 8.50" x 2.00" x 1.56" (21.59 cm x 5.08 cm x 3.96 cm) Power 3.0 VDC (two AA alkaline batteries - supplied) Enclosure Molded black matte plastic DIP switch 8-position sets IR or RF mode and radio mode Pushbuttons Up to 26 pushbuttons (with custom overlay) Mouse controls • 16-position mouse disc (two speeds), left and right mouse buttons Trigger switch operates left mouse button on TXC-MS Range RF: 1-way @ 200 ft (60.96 m) and 2-way @ 500 f
Streszczenie treści zawartej na stronie nr. 7
Introduction TXC-MS(L) controls The TXC-MS(L) is available in configurations with up to 26 pushbuttons and PC mouse controls (mouse disc and left and right mouse buttons). The TXC-MS(L) includes a custom engraved overlay with text as desired by the customer. TXC-MS(L) mouse controls The TXC-MS(L) mouse disc affords you 360° control of cursor direction and speed. The two pushbuttons located on either side of the mouse disc replace those found on any standard ® Microsoft compatible mouse. ® T
Streszczenie treści zawartej na stronie nr. 8
Introduction FIG. 4 Laser Radiation warning AXR-MSE Wireless Mouse and Keyboard Controller The AXR-MSE is the receiver/processor component of the PC Presenter. The AXR-MSE receives RF or IR signals from the TXC-MS(L) transmitter using the attached RF receiving antenna or an external IR sensor. The AXR-MSE connects between the PC keyboard and mouse cables, and the keyboard and mouse ports on the PC CPU. The AXR-MSE uses a standard four-pin captive wire AXlink connector to connect to an AMX C
Streszczenie treści zawartej na stronie nr. 9
Introduction AXR-MSE Specifications (Cont.) Rear Panel TNC RF antenna Accepts the flexible RF receiving antenna (up to 6 feet of RG-58 coax cable for remote antenna set up can also be used). KEYBOARD IN/OUT Two PS/2 style keyboard connectors are used to connect the AXR-MSE to the PC keyboard and CPU. The top connector, labeled "TO PC" connects the AXR-MSE to the CPU with a PS/2 style cable (included). Plug the PC keyboard into the bottom connector. MOUSE IN/OUT Two PS/2 style mouse connector
Streszczenie treści zawartej na stronie nr. 10
Introduction 6 PC Presenter
Streszczenie treści zawartej na stronie nr. 11
Pre-Installation Pre-Installation Setting the TXC-MS(L) transmitter DIP switch The TXC-MS(L) transmitter transmits IR or RF signals, according to how you set position 1 on the 8-position DIP switch. The DIP switch is located under the battery cover, on the back of the TXC-MS(L), as shown in FIG. 6. To open the battery compartment, slide the cover down and remove. 8-position DIP switch Battery compartment FIG. 6 Location of 8-position DIP switch and battery compartment locations FIG. 7
Streszczenie treści zawartej na stronie nr. 12
Pre-Installation Radio Code Settings Each pushbutton on the TXC-MS(L) transmitter represents an Axcess channel number. All of the pushbuttons on the transmitter represent a group of channel numbers. This grouping is known as a radio code. Use the transmitter DIP switch to assign a unique radio code to this transmitter. Radio codes are important in applications that use more than one transmitter, because each transmitter must be assigned its own unique radio code. This is necessary to avoid i
Streszczenie treści zawartej na stronie nr. 13
Pre-Installation 8 1 15 16 2 9 3 10 17 24 25 27 30 29 28 26 4 11 18 5 12 19 6 13 20 7 14 21 22 23 FIG. 9 TXC-MS(L) pushbutton configuration Setting the Device DIP switch The eight-position Device DIP switch located on the front panel of the AXR-MSE as shown in FIG. 10 sets the AXlink device number for the AXR-MSE. Each device on the AXlink bus must have a unique AXlink device number. DEVICE MOUSE KEYBOARD DATA AXlink ON Device DIP switch FIG. 10 AXR-MSE device DIP swi
Streszczenie treści zawartej na stronie nr. 14
Pre-Installation The device can be 1 of the 255 devices in an Axcess, Axcent, Axcent2, Axcent3, AXB-MPE, or AXB-EM232 system. The device number must match the device assignment in the Axcess program. AMX assigns device numbers into the following three segments: Cards - 1 through 95 Boxes - 96 through 127 Panels - 128 through 255 The device number takes effect only on power-up. Set the device number by setting the device DIP switch. The device number is the total of all of the switches in t
Streszczenie treści zawartej na stronie nr. 15
Pre-Installation SW3 SW2 Top front view FIG. 11 AXR-MSE internal circuit board showing the location of the SW2 and SW3 slide switches FIG. 12 shows a close-up view of the SW2 and SW3 internal slide switches. SW3 SW2 PS2 mouse NO PC Serial PC mouse FIG. 12 Close-up view of SW2 and SW3 internal slide switches 1. Discharge the static electricity from your body and the screwdriver. 2. Unplug all connectors from the rear panel of the AXR-MSE. 3. Remove the four Phillips-head screws
Streszczenie treści zawartej na stronie nr. 16
Pre-Installation For keyboard use with a PC, slide the SW2 switch to the "PC" position as shown in FIG. 14. SW2 NO PC PC FIG. 14 Switch setting for keyboard use with PC connected Setting Mouse Mode The PC Presenter supports PS2 mice by default. If you prefer to use a serial mouse you must set internal slide switch SW3 for this mode (FIG. 15). Serial mice typically have a 9 pin D-sub connector. An adapter will be required to plug it into the mouse connector on the AXR-MSE. For us
Streszczenie treści zawartej na stronie nr. 17
Pre-Installation Wiring guidelines The AXR-MSE requires 65 mA @ 12 VDC power to operate properly. The Central Controller supplies power via the AXlink cable. The maximum wiring distance between the Central Controller and AXR-MSE is determined by power consumption supplied voltage, and the wire gauge used for the cable. The following wiring guidelines table lists wire sizes and the maximum lengths allowable between the AXR-MSE and the Central Controller. The maximum wiring lengths for using A
Streszczenie treści zawartej na stronie nr. 18
Pre-Installation 14 PC Presenter
Streszczenie treści zawartej na stronie nr. 19
Installing the PC Presenter Installing the PC Presenter This section describes how to connect the AXR-MSE to the PC and to the Central Controller. Before installation, check to verify that the Device DIP switch on the front panel of the AXR-MSE is set correctly. Setting the Device DIP switch is described in the previous section (Setting the TXC- MS(L) transmitter DIP switch section on page 7). The PC Presenter can be set up for either stand-alone operation, or connected to a Central Controlle
Streszczenie treści zawartej na stronie nr. 20
Installing the PC Presenter G N D G N D IR IN O U T IR X -S M + o r E x te rn a l I R S e n s o O u tp u t o n A X R -M S E IR X -D M + A U X A U X O U T P W R + 1 2 V FIG. 17 IRX-SM+ or IRX-DM+ external IR sensor wiring diagram Installing the PC Presenter for AXlink Operation To use the PC Presenter as an integrated AXlink device, connect the AXR-MSE to the PC keyboard/mouse and a Central Controller. As an AXlink device, the PC Presenter controls PC keyboard/mouse functions as well as t
