Streszczenie treści zawartej na stronie nr. 1
USER
MANUAL
MODEL 3088RC
RocketLink-G NTU
Rack Mount G.SHDSL
Modem Card
Part# 07M3088RC-UM SALES OFFICE
Doc# 03325U2-002, Rev. A
(301) 975-1000
Revised 5/20/08
TECHNICAL SUPPORT
(301) 975-1007
Streszczenie treści zawartej na stronie nr. 2
1.0 Warranty Information ................................................................. 5 1.1 Compliance................................................................................... 5 EMC Compliance:......................................................................... 5 Safety Compliance: ...................................................................... 5 PSTN Regulatory:......................................................................... 5 1.2 FCC Part 68 (ACTA) S
Streszczenie treści zawartej na stronie nr. 3
3.7 Configuring the X.21 Rear Card ................................................. 26 Model 1001RCM11545& 1001RCM115TB Strap Settings......... 26 DTE Shield (DB-15 Pin 1) & FRGND (JB3) ......................... 27 SGND & FRGND (JB4) ....................................................... 27 3.8 Configuring the E1 Rear Card .................................................... 27 DIP Switch Configuration............................................................ 27 Switch S1-1 : Line Co
Streszczenie treści zawartej na stronie nr. 4
How to Disconnect .............................................................. 49 Differences in Local and Remote Control Session Behavior...... 50 5.4 Software Upgrade....................................................................... 51 5.5 Reset Configuration to Factory Default....................................... 52 A Specifications ........................................................................... 53 A.1 Clocking modes ................................................
Streszczenie treści zawartej na stronie nr. 5
1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 3088RC components to be free from defects, and willat our optionrepair or replace the product should it fail within one year from the Þrst date of the shipment. This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse or unauthorized modiÞcation. If this product fails or does not performs as warranted, your sole recourse shall be repair or replacement as descri
Streszczenie treści zawartej na stronie nr. 6
1.2 FCC PART 68 (ACTA) STATEMENT This equipment complies with Part 68 of FCC rules and the requirements adopted by ACTA. On the bottom side of this equipment is a label that containsamong other informationa product identiÞer in the format US: AAAEQ##TXXXX. If requested, this number must be provided to the telephone company. The method used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements ado
Streszczenie treści zawartej na stronie nr. 7
into a different AC outlet (such that the computing equipment and receiver are on different branches). 1.4 INDUSTRY CANADA NOTICE This equipment meets the applicable Industry Canada Terminal Equip- ment Technical SpeciÞcations. This is conÞrmed by the registration num- ber. The abbreviation, IC, before the registration number signiÞes that registration was performed based on a Declaration of Conformity indicat- ing that Industry Canada technical speciÞcations were met. It does not i
Streszczenie treści zawartej na stronie nr. 8
1.6 AUTHORIZED EUROPEAN REPRESENTATIVE D R M Green European Compliance Services Limited. Oakdene House, Oak Road WatchÞeld, Swindon, Wilts SN6 8TD, UK 1.7 SERVICE All warranty and non-warranty repairs must be returned freight prepaid and insured to Patton Electronics. All returns must have a Return Materi- als Authorization number on the outside of the shipping container. This number may be obtained from Patton Electronics Technical Services at: Tel: +1 (30
Streszczenie treści zawartej na stronie nr. 9
1.8 SAFETY WHEN WORKING WITH ELECTRICITY • This device contains no user serviceable parts. The equipment shall be returned to Patton Electronics for repairs, or repaired by qualified service personnel. • Hazardous network voltages are present in WAN ports regardless of whether power to the unit is ON or OFF. To avoid electric shock, use caution when near WAN ports. When detaching the cables, detach the end away from WARNING the device first. • Do not work on the system or connect or dis
Streszczenie treści zawartej na stronie nr. 10
2.0 GENERAL INFORMATION Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warranted for One Year parts and labor. If any questions arise during installation or use of this product, please contact Patton Electronics Technical Support at: (301) 975-1007. 2.1 FEATURES Symmetrical high data rate DSL (G.SHDSL) Data rates up to 4.6Mbps in 64-kbps intervals Serial V.35 (DCE only) , X.21 (selectable DCE or D
Streszczenie treści zawartej na stronie nr. 11
2.3 SERIAL INTERFACE TYPES The Model 3088RC versions listed below provide the following types of built-in serial interfaces: 3088RC/A/I provides a V.35 interface on an M/34 female connector 3088RC/C/AI provides a Ethernet interface on an RJ45 connector 3088RC/D/V/V provides a X.21 interface on a DB-15 female connector 3088RC/K/K provides a E1 interface on either an RJ48-C connector or dual BNC 11
Streszczenie treści zawartej na stronie nr. 12
3.0 CONFIGURATION This section describes the location and orientation of the Model 3088RCs conÞguration switches and jumpers, and provides detailed instructions for all possible settings. Each 3088RC model has different conÞguration requirements, depending on the cards serial interface. You can conÞgure the 3088RC using either the software (CLI via a 1001CC port) or the hardware (via DIP switches). 3.1 ABOUT SOFTWARE (CLI) CONFIGURATION To use software conÞguration
Streszczenie treści zawartej na stronie nr. 13
If you attempt to modify any conÞguration parameters via the EOC (by changing (EOC variables), the RocketLink-G will not execute your changes. 3.3 CONFIGURING THE DIP SWITCHES (V.35, X.21, and Ethernet Models) The Model 3088RC is equipped with three sets of DIP switches, which you can use to conÞgure the RocketLink-G for a broad range of applica- tions. This section describes switch locations and discusses the conÞgu- ration options available. Note By default, the RocketLi
Streszczenie treści zawartej na stronie nr. 14
S1-1 through S1-7: Data Rate Switches S1-1 through S1-7 deÞne both the DSL data rate and the serial data rate. Data Rate S1-1 S1-2 S1-3 S1-4 S1-5 S1-6 S1-7 (kbps) OFF ON ON ON ON ON ON 64 ON OFF ON ON ON ON ON 128 OFF OFF ON ON ON ON ON 192 ON ON OFF ON ON ON ON 256 OFF ON OFF ON ON ON ON 320 ON OFF OFF ON ON ON ON 384 OFF OFF OFF ON ON ON ON 448 ON ON ON OFF ON ON ON 512 OFF ON ON OFF ON ON ON 576 ON OFF ON OFF ON ON ON 640 OFF OFF ON OFF ON ON ON 704 ON ON OFF OFF ON ON ON 768 OFF ON
Streszczenie treści zawartej na stronie nr. 15
Data Rate S1-1 S1-2 S1-3 S1-4 S1-5 S1-6 S1-7 (kbps) OFF ON ON ON OFF ON 2240 OFF ON ON OFF ON ON OFF ON 2304 OFF ON OFF ON ON OFF ON 2368 ON OFF OFF ON ON OFF ON 2432 OFF OFF OFF ON ON OFF ON 2496 ON ON ON OFF ON OFF ON 2560 OFF ON ON OFF ON OFF ON 2624 ON OFF ON OFF ON OFF ON 2688 OFF OFF ON OFF ON OFF ON 2752 ON ON OFF OFF ON OFF ON 2816 OFF ON OFF OFF ON OFF ON 2880 ON OFF OFF OFF ON OFF ON 2944 OFF OFF OFF OFF ON OFF ON 3008 ON ON ON ON OFF OFF ON 3072 OFF ON ON ON OFF OFF ON 3136 ON OF
Streszczenie treści zawartej na stronie nr. 16
S1-8: TX Clock S1-8 Setting Description ON Normal TD sampled on falling edge of TX clock. OFF Inverted TD sampled on rising edge of TX clock. S2-1: Front Panel Switches The 3088RC uses front panel switches to control test modes. They may be disabled so that the 3088RC ignores them. S2-1 Front Panel Switches ON Disabled OFF Enabled S2-2: Line Probe Line probe is a mechanism that determines the highest rate (192K to 2304K) that the DSL link can reliably support. This takes place
Streszczenie treści zawartej na stronie nr. 17
S2-4 through S2-5: Clock Mode The RocketLink-G can operate in one of three clock modes: internal, external, or receive-recover. S2-4 S2-5 Clock Mode Description ON Internal The on-board oscillator in ON the 3088RC provides clock for both serial and DSL lines. OFF ON External 3088RC uses the RX clock from the serial interface as the clock for the DSL link. ON OFF Receive- 3088RC uses the RX clock Recover from the DSL line as the clock for the serial interface
Streszczenie treści zawartej na stronie nr. 18
S2-6: DTE Loops The V.35 interface provides two pins, one to request an LAL and the other to request an RDL. If DTE loops are enabled, the 3088RC/A/I will start a local loopback or a remote loopback when these pins are asserted. If DTE loops are disabled, these requests will be ignored. S2-6 Setting ON Enabled OFF Disabled S2-7: DTE Interface Type The DTE interface type needs to be set based on the rear module. Set to E1 if using the /K model. Set to normal if using any other
Streszczenie treści zawartej na stronie nr. 19
Software Upgrades The software is upgraded by waiting for the Reset Mode message. Then, the user can send an Intel HEX Þle supplied by Patton. After the VT100 emulator has Þnished sending this Þle, the 3088RC will respond with a mes-sage stating how many errors were detected. The user may then set the DIP switches to the desired conÞguration and power cycle the unit to run the upgraded software. ConÞguration Reset to Factory Defaults To recover from a forgotten pass
Streszczenie treści zawartej na stronie nr. 20
Data Rate: Both the serial/E1 and DSL data rates are set by specifying the number of 64k timeslots. Annex: Either G.991.2 Annex A or Annex B. DTE Interface Type: Either E1 or a normal serial interface. DSL Error Monitor Max Interval Errors: The number of errors allowed in an interval before considering the interval errored. A value of 0 disables the DSL error monitor. DSL Error Monitor Interval Time: The length in seconds of an interval. DSL Error
