Instrukcja obsługi Audio-Technica AT4050ST

Streszczenie treści zawartej na stronie nr. 1

AT4050ST
40 series microphones
Stereo Condenser Microphone
Operation and Maintenance
The AT4050ST requires 48V phantom power on Pins 2 and 3 of both
XLR3M-type connectors for operation. Wiring must be balanced
throughout, and all mic cables in the system must be wired consistently:
Pin 1-to-Pin 1, etc. If connecting to unbalanced inputs, good-quality
balanced line transformers must be used.
Mid-Side Operation: In M-S mode, the microphone provides independent
Mid and Side signals. This all

Streszczenie treści zawartej na stronie nr. 2

AT4050ST Specifications The output of the microphone shall be a 5-pin XLRM-type connector. A Elements Externally-polarized (DC bias) condenser 5.0 m (16.5') cable with a 5-pin XLRF-type to two standard 3-pin XLRM- Polar patterns Cardioid, Figure-of-eight type connectors shall be included. Frequency response 20-18,000 Hz Low frequency roll-off 80 Hz, 12 dB/octave The microphone shall be equipped with a switchable 10 dB pad and Open circuit sensitivity Stereo, 90º: –42 dB (7.9 mV), re 1V at 1 Pa