Streszczenie treści zawartej na stronie nr. 1
N/DYM SERIES WIRELESS
USER GUIDE WIRELESS
MICROPHONE
GEBRAUCHSANWEISUNG
SYSTEM
MODE D’EMPLOI
INSTRUCCIONES DEL USUARIO
SYSTEME DE SISTEMA DE
DRAHT -
LOSES
MICROPHONE MICRÓFONO
MIKROFON-
SANS FIL INALÁMBRICO
SYSTEM
Streszczenie treści zawartej na stronie nr. 2
ENGLISH Table of Contents 1. Quick System setup guide 2. System Description 3. Detailed system/component setup instructions 3.1 Receiver Setup & Operation 3.2 Handheld Transmitter Setup 3.3 Beltpack Setup 4. Guidelines/Recommendations for best performance 5. Troubleshooting Guide 6. Technical Specifications 7. Certifications 8. Components & Accessories 9. Service/Warranty 1. Quick System Setup Guide Receiver Setup Operating the system 1. Plug power supply cord into the back of the receiv- 1. T
Streszczenie treści zawartej na stronie nr. 3
ENGLISH 2. System Description The Electro-Voice N/DYM Wireless is a series of 10 channel frequency agile UHF wireless systems that combine EV’s legendary quality and reliability with high value. The N/DYM Series transmitters and receivers operate in the UHF frequency range on one of ten channels between 800 and 814 MHz. The well-designed audio circuitry ensures excellent signal-to-noise ratio with accurate sound quality. System Features 10 Channel Frequency Agile UHF system operation. Choice
Streszczenie treści zawartej na stronie nr. 4
ENGLISH Figure 1. Front View Figure 2. Rear View 5. Channel change lock-out. Once the channel has Once the Transmitter has been set-up, and been set on the receiver, the N/DYM system has turned on…. the capability to deactivate or lock-out the 8. Speak into the microphone or play the guitar. Turn channel change button. This is done by up the level on the mixer or preamp until you’re depressing the set button for 10 seconds or more. able to hear the desired signal. Lock-out is active when th
Streszczenie treści zawartej na stronie nr. 5
ENGLISH 5. Unmute the audio by sliding the audio switch 3.2 Handheld Transmitter Setup (immediately below the mic element) towards the 1. Insert battery. Slide open the hinged battery windscreen. Speak or sing into the microphone compartment cover by placing your thumb on the and you should hear your voice through the indents of the battery door (at the bottom of the PA / sound system. transmitter) and gently pushing down (see Figure 6. Adjustment of the transmitter audio gain - if 3). In
Streszczenie treści zawartej na stronie nr. 6
ENGLISH 5. Connect the audio source. If using a lava- 3.3 Bodypack Transmitter Setup lier or headworn microphone, insert the con- 1. Insert battery. Open the hinged battery nector on the end of the mic wire, into the con- compartment by placing your thumb or finger nector on the Bodypack. If using a lavalier on the indent labeled OPEN on the battery mic, use the clip to attach the mic to the users door and pushing down, see Figure 6. When clothing. If using the headworn mic, place the inserti
Streszczenie treści zawartej na stronie nr. 7
ENGLISH Figure 6. 4 Guidelines/Recommendations for best performance Compatibility The receiver and transmitter must be set to the same channel to operate together. Using Multiple Wireless Systems If two or more N/DYM Wireless and/or other VHF/UHF wire- Contact your dealer or Electro-Voice for assistance, if you are less systems are being used in the same location, proper fre- planning to add more wireless systems to be operated simul- quency coordination is necessary to avoid interference. Th
Streszczenie treści zawartej na stronie nr. 8
ENGLISH 5 Troubleshooting Guide Problem Possible Causes Solutions No audio & no lights Receiver is off Make sure that power supply is on receiver properly connected and providing power to the receiver. No audio & no Tx ON Transmitter is off. Turn on transmitter power switch. light on receiver No ( or dead ) battery in Insert fresh battery in transmitter. transmitter. Faulty battery contacts in Clean contacts. transmitter. No audio Transmitter audio switch Turn on transmitter audio switch.
Streszczenie treści zawartej na stronie nr. 9
ENGLISH 6 N/DYM Wireless Series System Technical Specifications UHF Receivers: NRU and NRU-G Receivers Receiver Type Synthesized PLL Frequency Range (RF) Between 800 - 814 MHz Number of Selectable Channels 10 TM Diversity True Diversity with Secure-Phase RF Sensitivity < .8 uV for 12 dB SINAD FCC Data Approved under part 15 Audio Output, Frequency Response 50 – 15 kHz +/- 2 dB Audio Output, Balanced (XLR) -20 dBV (600 Ohm Load) 1 Audio Output, Unbalanced ( /4") adjustable 8 mv to 0.775V RMS (
Streszczenie treści zawartej na stronie nr. 10
ENGLISH 7 Certifications CERTIFICATIONS NRU, NRSCU, Certified to ETS 300 445, Conforms to European Union directives, eligible to bear CE marking. NHTU, NBPU, Certified to I-ETS 300 442 and ETS 300 445, Conforms to European Union directives, eligible to bear CE marking. Licensing of Electro-Voice equipment is the user’s responsibility and license eligibility depends on the user’s classification, and frequency selected. Changes or modifications made by the user could void the user’s authority to
Streszczenie treści zawartej na stronie nr. 11
ENGLISH ENGLISH 9. Service/Warranty Factory Service If factory service is required, ship the unit prepaid in its original carton to: Telex EVI Audio GmbH Hirschberger Ring 45 D-94315 Straubing Telephone: +49 (0) 9421 706 0 Fax: +49 (0) 9421 706 350 Enclose a note describing the problem along with any other pertinent information. Warranty (Limited) Electro-Voice products are guaranteed against malfunction due to defects in materials or workmanship for a speci- fied period, as noted in the individ
Streszczenie treści zawartej na stronie nr. 12
ENGLISH Service/Warranty – North America Factory Service If factory service is required, ship the unit prepaid in its original carton to: EV Audio Service c/o Telex Communications 8601 E. Cornhusker Highway Tel: 402/467-5321 Fax: 402/467-3279 Enclose a note describing the problem along with any other pertinent information. Warranty (Limited) Electro-Voice products are guaranteed against malfunction due to defects in materials or workmanship for a speci- fied period, as noted in the individual pr
Streszczenie treści zawartej na stronie nr. 13
R Telex Communications Inc., 12000 Portland Ave. South Burnsville, MN 55337, USA 800/328-3771, 952/884-4051, Fax: 952/884-0043 MANUAL - N/DYM Series Wireless © Telex Communications, Inc. 2000 Litho in U.S.A. PN 802989
