Streszczenie treści zawartej na stronie nr. 1
UHF-24
Dual Channel Receiver
UHF Wireless Microphone System
SERVICE INFORMATION
(U.S.) If you are experiencing operation problem with your system, check out the support
page on the Nady website: www.nady.com for help and for contacting the Nady Service
Department. Should your wireless System require service, you must contact the Nady Service
Department at (510) 652-2411 for a Return Authorization (R/A) Number and a service quote
(if out of warranty). Make sure the R/A Number is clearly mark
Streszczenie treści zawartej na stronie nr. 2
TABLE OF CONTENTS SPECIFICATIONS OVERALL SYSTEM SPECIFICATIONS TABLE CONTENTS ....................................................................................................... 2 Frequency Response .............................................................................................20Hz-20kHz, -3dB INTRODUCTION ........................................................................................................... 2 Dynamic Range ..................................................
Streszczenie treści zawartej na stronie nr. 3
TIPS SYSTEM FEATURES • The receiver antennas should be kept away from any metal surface. UHF-24 Receiver • If the Volume Control of the receiver is set too high, it may over-drive the input of the mixer, caus- • Two discrete UHF wireless receivers in one housing, for simultaneous operation of two transmit- ing distortion. Conversely, if the output is set too low, the overall signal to noise ratio of the system ters may be reduced. Adjust the output level of the receiver such that highest sound
Streszczenie treści zawartej na stronie nr. 4
CAUTIONS AND TROUBLESHOOTING UHF-24 RECEIVER Rack-mounting the Receiver Feedback There are two options available for rackmounting the UHF-24 Dual Channel Receiver: single or Observe care in selecting P.A. volume, transmitter location and speaker placement so that the side-by-side with another UHF-24 receiver. acoustic feedback (howling and screeching) will be avoided. Please also note the pickup pattern a. Single mounting: Remove the SIDE MOUNT CLIPS (1) from each side of the receiver and char
Streszczenie treści zawartej na stronie nr. 5
LINK 4™ PLUG-IN TRANSMITTER UHF-24 RECEIVER Receiver Volume Controls Adjust The volume controls work only for the 1⁄4” sum output. Turn Volume controls on the UHF-24 Connecting Audio Outputs receiver clockwise to near full gain. Adjust Volume up or down so that no audio distortion is present The UHF-24 receiver provides both a fi xed mic level balanced audio output XLR for each channel when amplifi er or mixer is set at their usual levels. At full gain, the system gain is approximately and an
Streszczenie treści zawartej na stronie nr. 6
LINK 4™ PLUG-IN TRANSMITTER UHF-24 RECEIVER internal Tone Squelch defeat feature. Contact your Nady dealer or Nady Systems Customer Service Transmitters Set Up for details.) The LINK-4 transmitter requires a single 9V battery to operate. To open the battery compartment, slide BATTERY DOOR (31) downward to open the cover, exposing the BATTERY HOLDER (32). Note: Insert a fresh 9V battery according to the correct polarity as indicated on the transmitter body. Slide • Even though your system h
Streszczenie treści zawartej na stronie nr. 7
UB-4 BODYPACK TRANSMITTER UH-4 HANDHELD TRANSMITTER Transmitters set up The UH-4 transmitter requires a single 9V battery to operate. To open the battery compartment, INPUT SELECTOR unscrew the BATTERY COVER (16) with a counter-clockwise turn and remove the cover, exposing SWITCHES the BATTERY HOLDER (17). Insert a fresh 9V battery according to the correct polarity as indicated 30 23 HL on the transmitter body. Screw cover back onto the microphone. Make sure the cover is screwed on Instrume
Streszczenie treści zawartej na stronie nr. 8
UH-4 HANDHELD TRANSMITTER UB-4 BODYPACK TRANSMITTER The UB-4 is equipped with two INPUT SELECTOR SWITCHES (27) located under the cover on the circuit board for selecting the type of audio input you will be supplying to the transmitter. Select from the choice of three positions: INSTRUMENT (for guitar, bass, etc.)/ HEADWORN MIC/ LAVALIER MIC. (G/H/L). There are two switches, one with selectable position G, H, L and the other with G, HL. To select inputs: (see chart on page 10) A. Instrument — bot
