Instrukcja obsługi Califone R-2000

Streszczenie treści zawartej na stronie nr. 1

CAUTION
R
1.Since use of an antenna extremely influences efficiency of the wireless microphone
system, proper selection and set-up are necessary. The shorter the better is the R R--1 10 00 00 0//R R--2 20 00 00 0
R-1000/R-2000
most important rule to keep distance between the microphone and the receiiving
antenna.
WIRELESS MICROPHONE SYSTEM
Operating Manual
2 In case of multi-channel operation, proper selection of non-interference channels is
of utmost importance.
3 Remove batteri

Streszczenie treści zawartej na stronie nr. 2

GENERAL OPERATION OF THE OVERALL SYSTEM OUTLINE 1. Turn volume control of the receiver as well as the mixer or the equipment to be R-1000 / R-2000 is a VHF high-band non-diversity system with quartz controlled fixedfrequency design. The receiver must be combined with Califone's Q- and M- used to the minimum then switch on the receiver. The pilot LED of the receiver will light up and the AF signal indicator will give a flash. series of wireless microphone. COMPOSITION 2. When a

Streszczenie treści zawartej na stronie nr. 3

OPERATION INSTRUCTIONS OF OVERALL SYSTEM REAR PANEL The overall system is a combination of a receiver and a wireless microphone. The combination for R-1000 or R-2000 could be selected as the following. BASIC COMBINATION SYSTEM BASIC COMBINATION SYSTEM R-1000 / R-2000 matches Q-1000 M-1000 USED AS MULTI-CHANNEL SYSTEM When two or more wireless microphone are used carriers must be different from the others in order to avoid mutual interference. INSTALLATION OF THE SYSTEM To make sure that the syst

Streszczenie treści zawartej na stronie nr. 4

INSTALLATION OF THE RECEIVER 2.Connect a power adapter to the DC power supply input socket then plug the USED AS A STAND ALONE SYSTEM 1.Install an antenna perpendicularly to the antenna input jack at the rear panel adapter to an appropriate AC outlet with caution to the correct voltage under both of the receiver as shown in Fig. 1. AC outlet and adapter marked. as shown in Fig. 3. CONNECT 1.Connect the AF output of the receiver from unbalanced output jack to input