Streszczenie treści zawartej na stronie nr. 1
Streszczenie treści zawartej na stronie nr. 2
ENGLISH CONTROLS (Fig. 1) Fig. 1 1. Earphone jack (EAR) 2. Volume control (–VOL+) 3. Operation/Battery indicator (OPR/BATT) 4. Built-in microphone (MIC) 5. Pause switch (PAUSE a) 6. Record button (m REC) 7. Play button (b PLAY) 8. Fast forward/Cue and Rewind/Review switch (FFW/CUE | REW/REV) 1 TRC-540M/US 2 9/10/03, 10:37 AM n/q b m OPR/BATT STOP/EJECT PLAY REC
Streszczenie treści zawartej na stronie nr. 3
9. Stop/Eject button (n/q STOP/EJECT) 10. Tape speed switch (SPEED) 11. Battery compartment (back panel) 12. External DC 3V jack (EXT DC 3V) (left side) 13. Record mode switch (REC MODE) (left side) 14. Cassette compartment POWER SUPPLY AC adaptor Connect the optional AC adaptor (Sanyo Model No. 3CV- 120US) to the EXT DC 3V jack (Fig. 2). (The batteries are automatically disconnected.) • The center pin of the EXT DC 3V jack is positive (+). AC 120V, 60 Hz EXT DC3V Fig. 2 2 TRC-540M/US 3 9/10/0
Streszczenie treści zawartej na stronie nr. 4
Battery Install two “AA” batteries (not supplied) as shown in Fig. 3. Observe proper polarity. Fig. 3 • If you are not going to use the unit with batteries for one month or more, remove the batteries. Battery replacement When the OPR/BATT indicator does not light during opera- tion or is lit dimly, replace the batteries. • When replacing the batteries, use two new batteries of the same type. Do not mix a used battery with a new one or mix different types of batteries. IMPORTANT NOTE: SPENT OR DI
Streszczenie treści zawartej na stronie nr. 5
CONNECTIONS Earphone Connect an earphone (not supplied) to the EAR jack for private listening. (The speaker is automatically disconnected.) 4 TRC-540M/US 5 9/10/03, 10:37 AM
Streszczenie treści zawartej na stronie nr. 6
Streszczenie treści zawartej na stronie nr. 7
3. Set the SPEED switch to 2.4 or 1.2. 2.4 cm: Compatible with most single-speed microcassette recorders. 1.2 cm: For longer recordings; approximately 2 hours of recording time (total for both sides of a 60-minute cassette; MC-60). • Do not change tape speed during recording. 4. Set the REC MODE switch to DICT (Dictation) or CONF (Conference). NOTE: This switch does not affect playback. Fig. 6 5. Press the REC button. (The PLAY button is engaged simultaneously.) 6. Press the STOP/EJECT button to
Streszczenie treści zawartej na stronie nr. 8
Automatic stop system When the end of the tape is reached during recording or playing back, the tape stops automatically and the buttons are released. This system does not work in fast forward or rewind operation. Be sure to press STOP/EJECT button when the end of the tape has been reached. Example (When using MC-60 tape): Press the STOP/EJECT button after approximately 2 min- utes have elapsed under fast forward or rewind operation. Fast forwarding or rewinding In the stop mode, slide and lock
Streszczenie treści zawartej na stronie nr. 9
Quick reviewing and recording While recording, slide the FFW/CUE | REW/REV switch up and hold it (the REC button is released) until the tape has rewound to the desired point. Release the FFW/CUE | REW/ REV switch to play back your recording. Press the REC button to resume recording. Safeguards against accidental erasure (Fig. 7) To protect side A, break out tab (1). To protect side B, break out tab (2). • To erase or record a protected cassette, cover the tab openings with adhesive tape (3). Fig
Streszczenie treści zawartej na stronie nr. 10
PLAYBACK (Fig. 8) Fig. 8 1. Load the microcassette as shown in Fig. 5. 2. Set the SPEED switch to 2.4 or 1.2 to correspond with the recorded tape speed. 3. Press the PLAY button and adjust the –VOL+ control. 4. Press the STOP/EJECT button to stop playback. Cue and reviewing While playback, slide the FFW/CUE | REW/REV switch down or up and hold it. Release the button when the desired point is reached. Playback continues. 9 TRC-540M/US 10 9/10/03, 10:37 AM n/q b m OPR/BATT STOP/EJECT PLAY REC
Streszczenie treści zawartej na stronie nr. 11
MAINTENANCE To ensure continued high performance, use cotton swab (1) moistened with head cleaner to clean the heads (2, 3), pinch roller (4) and capstan (5) after about every 10 hours of use (Fig. 9). Fig. 9 10 TRC-540M/US 11 9/10/03, 10:37 AM
Streszczenie treści zawartej na stronie nr. 12
For USA SANYO SERVICE PLUS LIMITED WARRANTY DICTATION PRODUCTS ONLY OBLIGATIONS In order to obtain factory warranty service for Sanyo Dicta- tion Products, call the toll-free number below. The unit must be packed in the original carton or a well-padded sturdy car- ton in order to avoid shipping damage. Note: Do not return this unit to the retail store for service. To obtain Service Plus Warranty service, product opera- tion information or for problem resolution, call Toll Free 1-877-999-1840 Wee
Streszczenie treści zawartej na stronie nr. 13
Subject to the OBLIGATIONS above and EXCLUSIONS below, SANYO FISHER COMPANY (SFC) warrants this SANYO Dictation product against defects in materials and workmanship for the periods of LABOR and PARTS specified below. SFC will, at its option, within two business days after its receipt of any dictation product that fails to conform to this warranty at SFC’s designated facility, either (a) repair such product or any of its parts which fail to conform to this warranty or (b) ship a replacement produ
Streszczenie treści zawartej na stronie nr. 14
The foregoing is in lieu of all other expressed warranties and SFC does not assume or authorize any party to assume for it any other obligation or liability. THE DURATION OF ANY WARRANTIES WHICH MAY BE IMPLIED BY LAW (INCLUDING THE WARRANTIES OF MER- CHANTABILITY AND FITNESS) IS LIMITED TO THE TERM OF THIS WARRANTY. IN NO EVENT SHALL SFC BE LI- ABLE FOR SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM OWNERSHIP OR USE OF THIS PRODUCT, OR FOR ANY DELAY IN THE PERFORMANCE OF ITS OBLIGATIO
Streszczenie treści zawartej na stronie nr. 15
For Canada THE SANYO COMFORT WARRANTY BUSINESS SYSTEMS - DICTA RECORDERS WARRANTY APPLICATION New, unused Sanyo Dicta Recorder products purchased in Canada are warranted against manufacturing defects in ma- terials and workmanship for ONE YEAR for parts and NINETY DAYS for labour, from the date of purchase by the original retail purchaser. This warranty only applies in favour of the original retail purchaser of the warranted product. SANYO CANADA INC.’S RESPONSIBILITY During the warrant
Streszczenie treści zawartej na stronie nr. 16
ORIGINAL RETAIL PURCHASER’S RESPONSIBILITY You, the original retail purchaser, must present your original, dated bill-of-sale together with this warranty to SANYO Canada Inc. or to an authorized Sanyo Service Depot when you make a claim under this Warranty. You, the original retail purchaser, are responsible for any costs of TRANSPORTING the product to and from SANYO Canada Inc. or an authorized Sanyo Service Depot. You also are responsible for the cost of any MAINTENANCE necessary in respect o
Streszczenie treści zawartej na stronie nr. 17
STATUTORY WARRANTIES The above provisions do not preclude the operation of any applicable provincial statute which in certain circumstances may not allow some of the limitations and exclusions de- scribed in this Warranty. Where any terms of this Warranty are prohibited by such a statute, they shall be deemed null and void but the remainder of this warranty shall remain in effect. HOW TO OBTAIN WARRANTY SERVICE Please contact the Sanyo Authorized Dealer from whom the product was purchased, or c
Streszczenie treści zawartej na stronie nr. 18
Streszczenie treści zawartej na stronie nr. 19
9. Botón de Parada/Eyección (n/q STOP/EJECT) 10. Interruptor de Velocidad de Cinta (SPEED) 11. Compartimento para Pilas (panel trasero) 12. Enchufe externo CC 3 V (EXT DC 3V) (lado izquierdo) 13. Interruptor de Modo de Grabación (REC MODE) (lado izquierdo) 14. Compartimento para cassettes ENERGÍA Adaptador CA Conecte el adaptador de CA opcional (Modelo Sanyo No. 3CV-120US) a la clavija EXT DC 3V (Fig. 2). (Las pilas se desconectan automáticamente). • El conector central del enchufe EXT DC 3V
Streszczenie treści zawartej na stronie nr. 20
Pilas Instale dos pilas “AA” (no incluidas) como se indica en la Fig. 3. Fíjese bien el la posición de la polaridad. Fig. 3 • Quite las pilas si no utiliza el aparato con pilas por un período prolongado de más de un mes. Reemplazo de las pilas Reemplace las pilas cuando vea que el indicador OPR/BATT no se ilumina o se ilumina tenuemente durante el funcionamiento. • Al reemplazar las pilas utilice dos pilas nuevas del mismo tipo. No mezcle una pila usada con una nueva, ni mezcle diferentes tipos
