Streszczenie treści zawartej na stronie nr. 1
ZT2350A
ZT2350A
ZT2350A
23 HP – 50” CUT
CELEBRATING OVER 60 YEARS OF INNOVATION
1945 - 2007
1602 CORPORATE DRIVE, P.O. BOX 67, WARRENSBURG, MISSOURI 64093
Made In The
PHONE 660-747-8183 FAX 660-747-8650
Manufacturing quality lawn care equipment since 1945
USA
OWNER’S MANUAL
STARTING SERIAL # L506-017001
12890 Rev. 07-191
Streszczenie treści zawartej na stronie nr. 2
LIMITED WARRANTY The manufacturer’s warranty to the original consumer purchaser is: This product is free from defects in materials and workmanship for a period of two (2) years from the date of purchase by the original consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to materials or workmanship. This warranty is subject to the following limitations and exclusions: 1) Engine Warranty All engines utilized on our products have a se
Streszczenie treści zawartej na stronie nr. 3
CONTENTS LIMITED WARRANTY………… 2 OPERATION………………..…16 INTRODUCTION………………4 Features……………………… 16 General………………………… 4 Starting…………………………19 Before Operating……………… 4 Grass Height of Cut…………… 19 Uncrating & Assembly………… 5 Controls………...……..……… 20 SYMBOLS & DECALS………6 SERVICE & ADJUSTMENTS 21 SAFETY INSTRUCTIONS…… 8 Adjusting Deck Height………… 21 General use and safety rules…8 Deck Level…………………… 21 Slope Operation………………10 Deck Belt Replacement………22 Children Safety………………… 10 Hydro Belt Replacement……… 23 SP
Streszczenie treści zawartej na stronie nr. 4
INTRODUCTION Congratulations Thank you for purchasing a Swisher Zero Turn mower. This machine is built for the greatest efficiency and rapid mowing of large areas. Conveniently located controls and dual commercial grade hydrostatic transmissions regulated by steering levers, contribute to the machine’s performance. This manual is a valuable document. Following the instructions for use, service, maintenance, etc. can greatly increase the life-span of your machine . General In this operator
Streszczenie treści zawartej na stronie nr. 5
INTRODUCTION Uncrating & Assembly TOOLS REQUIRED: 2 - ½” Wrenches or ½” Socket with drive ratchet Tire pressure gauge Nail bar or claw hammer Wire snips To Remove The Mower From The Crate Dispose of top and side panels of the crate. Remove loose parts and packing material Cut any banding or strapping that may be holding the mower to the crate. Disengage spark plug wire and place where it cannot make a connection. Raise the mower deck to its highest position.. Disengage the parking brak
Streszczenie treści zawartej na stronie nr. 6
SYMBOLS & DECALS OD45- Warning Decal Swisher Flag U.S.A.– OD39 Notice Do Not Alter Wiring Decal– OD74 Flying Debris Decal – OD43 Operator Must Be Seated Decal– OD73 Triangle Danger Decal – OD55 No Step Decal – OD11 6 6
Streszczenie treści zawartej na stronie nr. 7
SYMBOLS & DECALS cont. Key/PTO Decal - 10273 Hydro Release - 10280 Throttle/Choke Decal - 10271 Danger/Warning Decal - 10276 7 7
Streszczenie treści zawartej na stronie nr. 8
SAFETY INSTRUCTIONS These instructions are for your safety. Read them carefully. This Safety Alert Symbol indicates important messages in this manual. When you see this symbol, carefully read the message that follows and be alert to the possibility of personal injury. General Use Read all instructions in this operator’s manual NOTE: and on the machine before starting it. Ensure that If you have never used a Zero you understand them and then abide by them. Turn mower before, refer to t
Streszczenie treści zawartej na stronie nr. 9
SAFETY INSTRUCTIONS General Use Continued Remember Always look around before and during reversing maneuvers. The operator is responsible Slow down before turning. for avoiding dangers or accidents. Shut down the mower deck when not mowing. Be careful when rounding fixed objects, so that the blades do not hit them. WARNING Only operate the machine in daylight or other well-lit conditions. When using the Keep the machine a safe distance from holes machine, approved or other irregular
Streszczenie treści zawartej na stronie nr. 10
SAFETY INSTRUCTIONS Slope Operation Remove obstacles such as stones, tree branches, etc. Mow up and down, not side to side. Never drive the rider on terrain that slopes more than 10 degrees. Avoid starting or stopping on a slope. If the tires begin to slip, shut down the blades and drive slowly down the slope. Remember Always drive evenly and slowly on slopes. The operator is Make no sudden changes in speed or direction. responsible for Avoid unnecessary turns on slopes, and if it p
Streszczenie treści zawartej na stronie nr. 11
SPECIFICATIONS GASOLINE CAPACITY DUAL 2.0 GAL TANKS AND TYPE UNLEADED REGULAR OIL TYPE (SPI-SF-SJ): SEE ENGINE MANUAL SPARK PLUG SEE ENGINE MANUAL GROUND SPEED 0 – 6 mph TIRE SIZE FRONT: 4.10x3.5-5 5/8 Bearing REAR: 18 X 9.5 - 8 TIRE PRESSURE FRONT: 50 psi Max REAR: 22 psi Max BATTERY 12V / Heavy Duty 275 CCA Type U1L HYDRO Bolt Torque 27 + - 3 ft. lbs BLADE BOLT TORQUE 35 ft. lbs CUTTING HEIGHT 1.5” – 5” CUTTING WIDTH 50” – 3 Mulching Blade System PARKING BRAKE Spring Assisted FRONT AXLE P
Streszczenie treści zawartej na stronie nr. 12
CUSTOMER RESPONSIBILITIES Operator Presence System Be sure the operator presence and interlock systems are working properly. If your mower does not function as described, repair the problem immediately. The engine should not start unless the parking brake is engaged, the PTO (Blade Engagement – See OPERATION FEATURES section of this manual) switch is disengaged (pressed down), and the operator is on the seat. When the engine is running, any attempt by the operator to leave the seat withou
Streszczenie treści zawartej na stronie nr. 13
CUSTOMER RESPONSIBILITIES Blade Maintenance CAUTION Stop engine and remove ignition key for safety. Disconnect spark plug wire. Wear heavy, thick gloves when holding onto blade. Avoid the sharp edge of the blade. For best results, mower blades must be kept sharp. Replace bent or damage blades. Safely raise front of mower. SEE WARNING WARNING Hold or block blade from turning. When it is necessary to raise Loosen blade nut and remove blade. the mower for any repair or Replace blade, (SE
Streszczenie treści zawartej na stronie nr. 14
CUSTOMER RESPONSIBILITIES V-Belts Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. Replace belts if they begin to slip from wear. SEE SPECIFICATION for belt part numbers and SERVICE section of this manual for instructions on how to replace the belt. Engine REFER TO YOUR ENGINE OWNERS MANUAL Overall Unit Care Reduce the risk of fire by removing grass, leaves, and other debris that may have accumulated on the machine. Allow the machine time to
Streszczenie treści zawartej na stronie nr. 15
CUSTOMER RESPONSIBILITIES MAINTENANCE SCHEDULE Before Each 8 Hours 25 Hours 50 Hours 100 Hours Season Before Use Storage Check Brake XX Operation Check Tire XX Pressure Check Operator X Presence Parking Brake X Check for Loose XX X Fasteners Sharpen/Replace X3 Mower Blades Check Battery XX Clean Battery & XX Terminals Check Belts X Check Engine Oil XX Change Engine Oil X1,2 w/ filter Change Engine Oil X1,2 w/o filter Replace Oil Filter X1,2 Clean Air Filter X2 Inspect Muff
Streszczenie treści zawartej na stronie nr. 16
OPERATION FEATURES 9 7 10 6 12 1. Throttle Control – Used to control 7. Control Levers – Sets the speed of the Engine Speed mower in both the forward and reverse directions and also turns the mower. 2. Hour Meter – Indicates hours of operation 8. Hydro Bypass – Engages transmissions for normal operation and disengages 3. Choke Control – Used when starting transmissions for pushing or pulling the unit a cold engine 9. Fuel Tanks – Dual 2.0 gal fuel tanks 4. PTO Switch – Used to engage or d
Streszczenie treści zawartej na stronie nr. 17
OPERATION FEATURES 9 7 13 1. Throttle Control – Used to control 7. Control Levers – Sets the speed of the Engine Speed mower in both the forward and reverse directions and also turns the mower. 2. Hour Meter – Indicates hours of operation 8. Hydro Bypass – Engages transmissions for normal operation and disengages 3. Choke Control – Used when starting transmissions for pushing or pulling the unit a cold engine 9. Fuel Tanks – Dual 2.0 gal fuel tanks 4. PTO Switch – Used to engage or diseng
Streszczenie treści zawartej na stronie nr. 18
OPERATION FEATURES Left Control Panel Right Control Panel 6 3 4 1 2 5 8 11 Rear of Unit 1. Throttle Control – Used to control 7. Control Levers – Sets the speed of the Engine Speed mower in both the forward and reverse directions and also turns the mower. 2. Hour Meter – Indicates hours of operation 8. Hydro Bypass – Engages transmissions for normal operation and disengages 3. Choke Control – Used when starting transmissions for pushing or pulling the unit a cold engine 9. Fuel Tanks – Dua
Streszczenie treści zawartej na stronie nr. 19
OPERATION Starting Operator must be sitting in the seat. Control handles must be in the neutral (outward) position. Parking Brake on. PTO must be in the disengage position (pushed down). Set choke (if needed), turn key and release as soon as engine starts. Adjust throttle to half and shut choke off. Release the Parking Brake. Be sure all people are clear of the area. Engage blades and set RPM to maximum. NOTE: If you have never used a Zero Turn mower before, refer to the Operation
Streszczenie treści zawartej na stronie nr. 20
OPERATION Controls Be familiar with all controls, their functions and how to operate them before starting the machine. Motion control levers on each side of the console control the direction of movement. SEE FIGURE BELOW Control Handles Neutral Position Slow Forward Fast Forward 90 Degree Right Turn 90 Degree Left Turn Slow Reverse NOTE: If you have never used a Zero Turn mower before, refer to the Operation Controls section of this manual before attempting to operate one for the first
