Instrukcja obsługi Stiga TURBO 8211-0208-08

Streszczenie treści zawartej na stronie nr. 1

D
DEUTSCH
Turbo
8211-0208-08

Streszczenie treści zawartej na stronie nr. 2

S SVENSKA B 1. 2. D F E 3. 4. 5. 6. 7.

Streszczenie treści zawartej na stronie nr. 3

S SVENSKA FULL ADD 0,15 l. 8. Briggs & Stratton LS 45 9. Briggs & Stratton ES 45, XTE 50 FULL/MAX 3x ADD/MIN 10. Honda GCV 11. Briggs & Stratton LS 45 3x 12. Briggs & Stratton ES 45 13. Briggs & Stratton XTE 50 G I* B 14. Honda GCV 15. ADD FULL ADD FULL STOP

Streszczenie treści zawartej na stronie nr. 4

S SVENSKA X Y 16. 17. 18. 19. Vänster / Left 20. Höger / Right 21. Briggs & Stratton LS 45 22. Briggs & Stratton ES 45, XTE 50 Briggs & Stratton : 0,76 mm 0,75 mm Honda: 0,7-0,8 mm 23. Honda GCV 24.

Streszczenie treści zawartej na stronie nr. 5

S SVENSKA 25. 26. S S 27. 28. T U 40 Nm 29. 30. 31.

Streszczenie treści zawartej na stronie nr. 6

GB ENGLISH SYMBOLS 3 2 The following symbols are displayed on the ma- chine in order to remind you about the safety pre- cautions and attention necessary when using the 1 machine. 5 The symbols mean: Warning! Read the Instruction Book and Safety Manual before using the machine. 4 Type II Warning! Keep spectators away. Beware of objects being flung out. 3 2 Warning! Do not put hands or feet under the cover of the machine when it is run- ning. 1 Warning! Before starting any repair work, remove the

Streszczenie treści zawartej na stronie nr. 7

GB ENGLISH 3. Tighten the locking nuts to the lower part of the BATTERY (*) handle. When these are tightened, the height of Electrolyte in the battery is toxic and the handle can be adjusted by tightening the corrosive. It can cause serious corrosion screws B with the enclosed wrench (fig. 2). damage etc. Avoid all contact with skin, eyes and clothing. ENGINE BRAKE CABLE Before starting the mower the first time, you Fit the engine brake cable to the engine brake, should charge the battery for 24

Streszczenie treści zawartej na stronie nr. 8

GB ENGLISH Note that you should always remember that petrol 3. Open the petrol tap (figs. 14). is a perishable commodity. Never buy more petrol 4. Set the throttle control B to the choke position than you can use up 30 days. . Note! A warm engine does not need to be choked (fig. 15). STARTING THE ENGINE (Briggs & Stratton) 5. Press in the Start/Stop clamp G towards the handle. Note! The Start/Stop clamp G must be 1. Place the lawn mower on flat, firm ground. Do kept pressed in to prevent the eng

Streszczenie treści zawartej na stronie nr. 9

GB ENGLISH Clean the silencer and the surrounding SPEED (*) area regularly to remove grass, dirt and Do not touch the variator control when flammable waste products. the motor is not operational. This can Take off the transmission cover by removing the have an adverse effect on the variator's screws S (fig. 28) and clean the area around the performance. transmission (*) and drive belt (*) using a brush or Set a suitable speed by moving the variator lever compressed air. Clean once or twice a yea

Streszczenie treści zawartej na stronie nr. 10

GB ENGLISH Briggs & Stratton LS 45 (fig. 21): Carefully re- BATTERY (*) move the air cleaner so that no dirt falls down into Electrolyte in the battery is toxic and the carburettor. Take out the foam-plastic filter and corrosive. It can cause serious corrosion wash it in liquid detergent and water. Dry the filter. damage etc. Avoid all contact with skin, Pour a little oil on the filter and squeeze it in. Refit eyes and clothing. the air cleaner. In normal use during the season, the battery is Cl

Streszczenie treści zawartej na stronie nr. 11

GB ENGLISH 3. When the clutch loop is Always check the blade(s) after an impact. First pressed in approx. 2 cm (posi- disconnect the ignition cable. If the blade system tion 1) there should be some has been damaged the defective parts must be resistance when moving the changed. Always use genuine spare parts. mower backwards. With the To replace the blade, slacken the screw (fig. 30). clutch loop fully pressed in Fit the new blade so that the stamped logotype is (position 2) it should not be tur