Streszczenie treści zawartej na stronie nr. 1
STIGA PARK
PRO 18
PRO 16
PRESIDENT
CLASSIC
8211-0211-06
Streszczenie treści zawartej na stronie nr. 2
7. Park Classic-President 11. 12. Park Classic-President 8. Park Pro16-Pro18 9. Park President 13. Park Pro16-Pro18 10. Park Pro16-Pro18 14. Park President
Streszczenie treści zawartej na stronie nr. 3
15. Park Pro16-Pro18 20. Park Pro16-Pro18 16. Park Pro16-Pro18 21. Park Classic-President 17. 18. 22. Park Pro16-Pro18 23. 19. Park Classic-President
Streszczenie treści zawartej na stronie nr. 4
27. Park President-Pro16-Pro18 31. Park President 28. Park Classic-President 32. Park Pro16-Pro18 29. Park Classic 33. Park Pro16-Pro18 30. Park Classic 34.
Streszczenie treści zawartej na stronie nr. 5
24. Park Classic 25. Park President 26. Park Pro16-Pro18
Streszczenie treści zawartej na stronie nr. 6
9 10 1 11 4 7 8 13 2 3 1. Park Classic 2. Park Classic 12 9 1 11 15 2 14 7 6 13 85 3 3. Park President-Pro16 4. Park President-Pro16 17 19 9 16 18 12 14 15 20 5 11 13 2 3 5. Park Pro18 6. Park Pro18
Streszczenie treści zawartej na stronie nr. 7
GB ENGLISH Classic: GENERAL The engine is provided with automatic governor This symbol indicates WARNING. Per- control. This means that the engine speed increases sonal injury and/or damage to property under load. For this reason, you must disengage the may result if the instructions are not forward drive before braking the machine. followed carefully. Press both the brake and clutch pedals when you You must read these instructions for want to brake or stop the machine. Never brake the
Streszczenie treści zawartej na stronie nr. 8
GB ENGLISH 6. DISENGAGING LEVER (President - 10. GEAR LEVER (Classic) Pro16 - Pro18) A lever for selecting one of the five forward gears in the gearbox (1-2-3-4-5), neutral (N), or reverse A lever for disengaging the variable transmission. (R). Enables the machine to be moved by hand without the help of the engine. (Note that, on the Pro16- The clutch pedal must be kept depressed when Pro18, the lever is on the left-hand side.) There are changing gear. two positions: NOTE! You must make su
Streszczenie treści zawartej na stronie nr. 9
GB ENGLISH 2. Drive position (without symbol). 1. Press the upper part of the switch - the lifter will be lowered to the working position. 3. Start position - the electric starter motor START is activated when the key is turned to the 2. Press the lower part of the switch - the lifter will spring-loaded start position. Once the en- be raised to the transport position. gine has started, allow the key to return to 19. EL. CUTTING HEIGHT ADJUST- the drive position. MENT (Pro18) A spare key is
Streszczenie treści zawartej na stronie nr. 10
GB ENGLISH 5. Grass and leaf transport Fill or top up with petrol only outdoors, and never smoke when filling or top- Using dump cart 13-1979 (Standard) or ping up. Fill with petrol before starting 13-1988 (Maxi). the motor. Never remove the filler cap 6. Fertiliser spreading or fill with petrol while the motor is running or still warm. Using fertiliser spreader 13-1987. Can also be used for spreading grass seed. CHECK THE ENGINE OIL LEVEL 7. Sand spreading On delivery the crankcase is fille
Streszczenie treści zawartej na stronie nr. 11
GB ENGLISH lever (only US and Canada) choke position). In order to start the machine the following are nec- 5b. Pro16-Pro18: essary: Put the throttle control at full throttle. Starting cold - gear lever in neutral (only Classic) engine - pull the choke control out fully. Starting - brake pedal depressed warm engine - do not touch the choke control. - driver sitting on seat 6. Depress the brake pedal fully. - power take-off engagement lever at lowest setting (i.e. power take-off disengaged)
Streszczenie treści zawartej na stronie nr. 12
GB ENGLISH “FULL”). der high pressure, do not point the jet directly at the transmission. Be careful when driving on slopes. No sudden starting or stopping when mov- CHANGING ENGINE OIL ing up or down a slope. Never drive Classic-President: across a slope. Move from the top and Change the oil for the first time after 5 hours run- down, and from down to the top. ning and then after every 50 hours running or once The machine, equipped with original a year. Change oil when the engine is war
Streszczenie treści zawartej na stronie nr. 13
GB ENGLISH Check the oil every time when topping up. The transmission. level should come up to the “FULL” mark. 7. Connect the hose to the oil reservoir. CHANGING THE TRANSMISSION 8. Finally, fill the oil reservoir with oil. OIL (President - Pro16 - Pro18) AIR BLEEDING (President - Pro16 - Change the oil the first time after 50 hours of oper- Pro18) ation, and then after every 250 hours or operation or once a season. After filling with oil, it may be necessary to bleed the transmission.
Streszczenie treści zawartej na stronie nr. 14
GB ENGLISH 25 hours running (fig 17 - 18). 2. Wash the pre-cleaner in liquid detergent and wa- ter. Squeeze dry. Pour a little oil on the filter and All plastic bearings should be lubricated twice squeeze in the oil. each season. 3. Loosen and remove the nut which hold the paper Apply universal grease to the steering chain a cou- filter. Lift our the paper filter and thoroughly clean ple of times each season. If the steering chain is re- the air filter housing to prevent dirt from entering
Streszczenie treści zawartej na stronie nr. 15
GB ENGLISH fan.) ADJUSTING POWER TAKE - OFF CABLE (not Pro18) 6. Remove the v-belt from the upper belt groove N on the engine belt pulley. If the v-belt between the engine belt pulley and centre belt pulley slips when the power take-off is 7. Replace the v-belt and assemble in the reverse engaged, the power take-off cable can be tensioned order. by means of the two cable adjusters K (fig 23). ADJUSTING GEAR POSITIONS REPLACING THE V - BELTS (Classic) You can replace the v-belts while the
Streszczenie treści zawartej na stronie nr. 16
GB ENGLISH er side. Classic: Adjust the brake cable on the cable adjusters V so 5. Tighten the pedal stop locking nut. that the brake arm is about 1 mm from the stop The forward movement of the drive when the brake pedal is in the released position pedal must not be restricted by the end (figs 24 and 29 - 30). position of the transmission, otherwise Slacken the lock nut and screw in the adjusting nut serious damage may arise. X (fig 30). Tighten the lock nut. 6. Then adjust the pedal stop u
Streszczenie treści zawartej na stronie nr. 17
GB ENGLISH EC - DECLARATION OF CONFORMITY Model: Park Type: P401 Art. no.: 13-1258, 13-1358, 13-1458, 13-1818, 13-1442, 13-1443, 13-1446, 13-1448 Serial no.: See machine Manufact.: STIGA AB, P.O. Box 1006, S-573 28 Tranås, Sweden Product: Lawn mower with combustion engine This product complies with the following: - Electromagnetic Compatibility Directive 89/336/EEC - Machine Directives 89/392/EEC, 91/386/EEC and 93/44/EEC with particular reference to Annex 1 in the Directive concerning essentia
Streszczenie treści zawartej na stronie nr. 18
Park Park Park Park Classic President Pro 16 Pro 18 -1 -1 -1 -1 3400 min 3400 min 3400 min 3400 min 9.3 kW 9.3 kW 11.8 kW 13.2 kW 2 2 2 2 4.5 m/s 4.5 m/s < 2.5 m/s < 2.5 m/s 2 2 2 2 < 0.5 m/s < 0.5 m/s < 0.5 m/s < 0.5 m/s < 10° < 10° < 10° < 10° < 10° < 10° < 10° < 10° < 10° < 10° < 10° < 10° 100B: 100 dB(A) 100B: 99 dB(A) 100B: 98 dB(A) 100B: 97 dB(A) 102M: 99 dB(A) 102M: 99 dB(A) 102M: 97 dB(A) 102M: 97 dB(A) 110S: 100 dB(A) 110S: 100 dB(A) 121M: 98 dB(A) 121M: 99 dB(A) LWA 100B: 87 dB(A) 100B
Streszczenie treści zawartej na stronie nr. 19
MO W I N G AHEA D Box 1006 · SE-573 28 TRANÅS www.stiga.com
