Instrukcja obsługi Snapper 7-4375

Streszczenie treści zawartej na stronie nr. 1

DEALER SET-UP INSTRUCTIONS & PRE-SALE CHECKLIST for
EUROPEAN SNAPPER LT SERIES TRACTORS

INTRODUCTION: Snapper LT (One Piece Frame) Tractors are shipped with the steering wheel and seat
cushions removed. The following steps are required for set-up. Complete all items on the Dealer Pre-Sale
Checklist at time of purchase.

NOTE: Figure 1 shows the seat assembled to the seat

pedestal assembly. Some models are shipped
SEAT KNOB


with the seat loose and will require installation.

Streszczenie treści zawartej na stronie nr. 2

4. With cell caps removed, connect battery charger to Step 5: REDUCE TIRE PRESSURE battery terminals; RED to positive (+) and BLACK to 1. The tires are over-inflated for shipping. Reduce tire negative (-) terminal. pressure in front tires to 12 PSI and in rear tires to 12 5. If time allows, slow charge at 1 amp for 10 hours, or PSI. as an alternative, fast charge at not more than 2.5 amps for 4 hours to bring the battery to full charge. STEP 6: INSTALL OPERATOR’S SEAT NOTE: Slo

Streszczenie treści zawartej na stronie nr. 3

Step 7: CHECK INTERLOCK SYSTEM HINGE PLATE The interlock system includes a seat switch, a clutch switch and a mower blade (PTO) switch. The system INSERT HAIR PIN INTO HINGE ROD functions in the following way: BETWEEN HINGE PLATE AND SEAT A. ENGINE MUST NOT START IF: PEDESTAL. 1. The blade lever is in the ON position. 2. Clutch pedal is not completely depressed. 3. Operator is not seated on tractor. B. ENGINE MUST START ONLY WHEN: SEAT PEDESTAL 1. Blade lever is shifted

Streszczenie treści zawartej na stronie nr. 4

DEALER PRE-SALE CHECKLIST The following must be accomplished prior sale. Refer to pages 1 - 3 for detailed set-up instructions. Review this list with purchaser. Check (✓ ) items actually performed and signed on this page. CUTTING BLADE & MOWER _____ BLADE RETAINING hardware checked for proper tightness. _____ BLADE TIP CLEARANCE inside lower edge of mower checked and corrected as needed. _____ MOWER CUTTING HEIGHT settings checked and adjusted as needed (with tires properly inflated)