Instrukcja obsługi Husqvarna 965969501

Streszczenie treści zawartej na stronie nr. 1

40cm Petrol Wheeled Rotary
Lawnmower
Original Instructions
For all customer enquiries or for replacement parts, contact:-
☎ 01325 300303
www.flymo.com
customer.services@husqvarna.co.uk
IMPORTANT INFORMATION
Read before use
& retain for future reference

Streszczenie treści zawartej na stronie nr. 2

Carton Contents Brake lever Cable tie Powerdrive lever (If fitted) Cord guide nut Upper Handle Cable tie Cord guide Handle knob Cord guide washer x2 Cord guide nylock nut Lower handle plug x2 Handle knob Grassbox Upper washer Lower Handle screws x2 Lower Handle Grassbox Lower Instruction manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd. Customer Service Department direct Telephon

Streszczenie treści zawartej na stronie nr. 3

Safety Precautions If not used properly this lawnmower can be dangerous! This lawnmower can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this lawnmower. The operator is responsible for following the warning and safety instructions in this manual and on the lawnmower. Never use the mower unless the grassbox or guards provided by the manufacturer are in the correct position. 9. Mowing o

Streszczenie treści zawartej na stronie nr. 4

Assembly Instructions A1 A2 Lower Handles 1. Insert the lower handle into the deck as shown in Fig. A1 2. Push the handle firmly down until it is located se- curely into the deck. 3. Insert the screw into the hole using a pozidrive screw- driver and tighten fully. (A2). Repeat for other side Lower Handle Plug A3 1. Insert the two lower handle plugs into the top of each of the lower handles (A3). B1 B2 Upper Handles When viewing product from the rear the yellow Warn- ing labels should be facing u

Streszczenie treści zawartej na stronie nr. 5

Assembly Instructions cont’ Grassbox Assembly D1 1. Position the two grassbox halves together (D1) and press each location point into position without fully connecting the clips. 2. When the location points are matched correctly firmly press the grassbox together until all clips are securely connected. D2 (D2) Cutting Height Adjustment Cutting Height E1 E2 The cutting height can be adjusted by removing the front and back wheels on the product. 1. Remove the wheel by turning the wheel hub in an

Streszczenie treści zawartej na stronie nr. 6

Starting and Stopping Please note:- When starting the engine for the first time, F2 F1 fill with oil and petrol as described above in the Engine Notes section. PUSH LAWNMOWER 1. Connect the spark plug lead. Starting the cold engine Push primer bulb firmly 3 times before starting cold engine. (F1) (Also, if the engine has stopped because it has ran out of fuel, refuel engine and push primer 3 times). Starting the warm engine NOTE: Priming is usually unnecessary when restarting a 0 0 warm engine.

Streszczenie treści zawartej na stronie nr. 7

Maintenance cont’ Transport Service Recommendations Remove the spark plug lead Your product is uniquely identified by a silver and black Loosen the wire/cable from the handle before carefully product rating label. folding it. Avoid damaging the wire/cable. We strongly recommend that your product is serviced at least Empty the petrol tank. The machine must be drained of oil every twelve months, more often in a professional application. and fuel when moving it by public transport. Engine Mainten

Streszczenie treści zawartej na stronie nr. 8

Environmental Information ENVIRONMENTAL INFORMATION Husqvarna UK Ltd. are manufactured under an Do NOT dispose of used fuels/oils with Environmental Management System (ISO 14001) using, household waste where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling Waste fuels/oils are harmful, but can be at the end of the products’ life. recycled and should be disposed of through • Packaging is rec