Instrukcja obsługi Samson RB2030

Streszczenie treści zawartej na stronie nr. 1

RB2030
Rechargeable Battery
for use with the
EX20 and EX30
OWNERS MANUAL
and
INSTALLATION GUIDE
®

Streszczenie treści zawartej na stronie nr. 2

Introduction Thank you for purchasing the Samson RB2030 Rechargeable Battery for Expedition EX20 and EX30 cabinets. The RB2030 incorporates four 12VDC, 3.3A Gel Cells. A fully charged RB2030 should supply power to the EX20 or EX30 for 4–5 hours. With proper care, your RB2030 will operate trouble free for many years. Please read the instructions carefully and note that your battery has been shipped uncharged. M4 x 14 Parts List RB2030 Gel Cell Battery 1 M6 x 12 M4 x 14 Screws 2 M6 x 12 Screws 2 M

Streszczenie treści zawartej na stronie nr. 3

Instructions for Installation of Battery 1 With the rear of the Expedition cabinet facing you, lie the cabinet face down on a soft surface as not to scratch the front grille. (figure 1) 2 Using a phillips screwdriver, remove the two M4 x 10 lower rear panel screws (to be re-used in step 6) and pole mount thumb screw (figure 1) NOTE: If the cabinet is to be pole mounted, it should be secured to the pole at this time.You will not have access to the pole mounting screw after the battery is installe

Streszczenie treści zawartej na stronie nr. 4

If you experience any difficulties, or require further assistance, contact Samson Customer Service at 1-800-3SAMSON (1-800-372-6766) M–F 9AM to 5PM (eastern standard time). For more product information please visit our website at www.samsontech.com. Specifications Type 4 x 12VDC, 3.3 Amp/Hours Gel Cell Charging time 6–8 hours Pin out for Cable and Charger (figure 5) Pin 1 NC Pin 2 CONTB (control one pin of relay for battery supply on/off) Pin 3 CONTA (control another pin of relay for battery sup