Instrukcja obsługi Electro-Voice ENG 618

Streszczenie treści zawartej na stronie nr. 1

ENG 618
Integrated Shotgun/
Boom-Pole Microphone
• Electret Condenser
• Collapses to 18 inches—expands
to 6 feet
• Highly Directional
• High Sensitivity
• Very Lightweight Carbon Fiber Pole
• Suspension Shockmount
• Built-in Headphone Amp
• Phantom or Battery Powered
• Low-Battery Indicator
Description Powering the ENG 618
The Electro-Voice ENG 618 is a hypercar- The ENG 618 is powered by an external
dioid-line (shotgun) back-electret condenser 12 - 52 volt phantom power supply or
micro

Streszczenie treści zawartej na stronie nr. 2

ENG 618 Integrated Shotgun/Boom-Pole Microphone The headphone jack could also be used to are the only remedies provided to the cus- Limited Warranty connect to a portable tape recorder for quick tomer. Electro-Voice shall not be liable for minimal equipment coverage. Electro-Voice products are guaranteed any incidental or consequential damages in- against malfunction due to defects in mate- cluding, without limitation, injury to persons Each segment of the telescoping boom pole rials or workmans

Streszczenie treści zawartej na stronie nr. 3

ENG 618 Integrated Shotgun/Boom-Pole Microphone ENG 618 Integrated Shotgun/Boom-Pole Microphone Figure 1—Frequency Response 5 dB per division Figure 2—Polar Response 3

Streszczenie treści zawartej na stronie nr. 4

ENG 618 Integrated Shotgun/Boom-Pole Microphone Equivalent Noise: Finish: Specifications 15 dB SPL, A -weighted Nonreflecting black Dynamic Range: Dimensions: Generating Element: 105 dB Length: Condenser, back electret Output Impedance, 1 kHz: 46 cm (18 in.) collapsed Frequency Response (see Figure 1 ): 100 ohms 180 cm (6 ft.) extended 50 - 8,000 Hz Power Requirements: Diameter: 200 Hz roll-off switch 12-to 52-V dc phantom supply or 9-V 9 cm (3.5 in.) circle Polar Pattern (see Figure 2 ): batt