Instrukcja obsługi Chamberlain RIFMS2

Streszczenie treści zawartej na stronie nr. 1

®
Model RIFMS2
Wireless Flush Mount Intercom
Overview
Channel Button: Press the Channel button to set
The Intercom has up to a 1000' range and allows
intercom to one of four secure channels or the paging
multiple simultaneous conversations, using a
channel. The default channel for the intercom is the
900 Mhz secure digital radio link. The intercoms form
paging channel where all four channel lights are lit.
an exclusive network and respond only to other
An intercom on a channel can only hear an

Streszczenie treści zawartej na stronie nr. 2

Programming Intercom The intercom must be programmed to at least one Add to an Existing Network other intercom to become a network or it can be programmed into an existing network. Create New Network Press and hold both buttons on the new intercom for 5 seconds. An initial beep will be heard followed by a second beep. The channel lights will flash. Within 10 seconds put any networked intercom into Learn Mode Press and hold both buttons on the intercom for (refer to table below). 5 seconds. An

Streszczenie treści zawartej na stronie nr. 3

Installation Step 1 Step 3 Choose mounting locations where both intercoms will work when tested. NOTES: • The wall location should be clear of beams and other obstructions inside the wall. • Do not mount intercoms within 6' of each other. • Do not mount intercom near any electrical wiring or electrical devices. 6 1/8" Place the frame in the hole 4 1/2" and tighten screws. NOTE: Place frame in wall so that the two small slots are on the top and the larger single slot is on the bottom. Cut a hole

Streszczenie treści zawartej na stronie nr. 4

Troubleshooting Need to clear intercom’s memory. Intercom does not function. Press and hold both buttons. Two beeps will be heard It is normal for LEDs to go out if intercom has been and the channel lights will begin to cycle. Continue to inactive for 5 minutes. The LEDs should light after a hold until a third beep is heard (about 15 seconds). button is pressed or a signal is received. Ensure other intercoms are not activated during this Check batteries in Intercom. time. Intercoms in the netw