Instrukcja obsługi Tripp Lite SRCABLETRAY

Streszczenie treści zawartej na stronie nr. 1

Owner’s Manual
™
SmartRack Accessories
Models: SRCABLETRAY, SRCABLETRAYEXP
1 – Introduction 2
1-1 Parts List 2
1-2 Tools Required
2
2 – Important Safety Instructions 2
3 – SRCABLETRAY Installation 3
4 – SRCABLETRAYEXP Installation
3
4-1 One Expansion Section 3
4-2 Two Expansion Sections 4
5 – Storage and Service
4
6 – Warranty and Warranty Registration
4
1111 W. 35th Street, Chicago, IL 60609 USA
+1.773.869.1234 • www.tripplite.com
Copyright © 2008 Tripp Lite. All trademarks are the sole propert

Streszczenie treści zawartej na stronie nr. 2

1 – Introduction SRCABLETRAY provides roof-mounted cable routing and power/data cable segregation for Tripp Lite’s SmartRack Enclosures. SRCABLETRAYEXP provides vertical expansion for SRCABLETRAY. (SRCABLETRAY also provides secure mounting points for Tripp Lite’s SRCABLELADDER accessory, sold separately. SRCABLELADDER allows cable bundles to span aisles and/or spaces between enclosures. See the SRCABLELADDER manual for more information.) 1-1 Parts List SRCABLETRAY SRCABLETRAYEXP A1 Trough Se

Streszczenie treści zawartej na stronie nr. 3

3 – SRCABLETRAY Installation Note: You can remove the roof panel to aid installation, but this step is not required. 1 2 Assemble the cable tray by attaching the support sections A to Insert the tabs C at one side of the cable tray into the matching the trough section B with the included screws. Note: The support roof panel slots D . (Several sets of slots are compatible, allowing sections should be attached inside the fl anges of the trough you to adjust the cable tray’s position to match yo

Streszczenie treści zawartej na stronie nr. 4

4 – SRCABLETRAYEXP Installation (continued) 4-2 Two Expansion Sections 1 2 Place the fi rst expansion section A on the cable tray B as shown. Place the second expansion section C on the fi rst expansion section as shown. Align the screw holes of the cable tray and A expansion sections, then connect the expansion sections to the cable tray with the included screws. C A A B 1 2 5 – Storage and Service Storage The unit must be stored in a clean, secure environment with a temperature less than 4