Instrukcja obsługi Lightolier Lighting Systems IS-EC2

Streszczenie treści zawartej na stronie nr. 1

Lighting Systems IS-EC2











10”

We reserve the right to change details of design, materials and finish.

Streszczenie treści zawartej na stronie nr. 2

Lighting Systems IS-EC2 48” or 96” 48” or 96” Junction Box (By Others) Canopy Canopy Power Canopy Power Cord Figure 1 S. R. L. Cord (Optional) #8 Screws Cover Male Plug 1/4-20 Bolt Cable Gripper S. R. L. Cord (Optional) Female Plug Figure 2 S. R. L. (Optional) Screw End-Cap (Do Not Over Tighten) 1/4-20 Bolt We reserve the right to change details of design, materials and finish.

Streszczenie treści zawartej na stronie nr. 3

Lighting Systems IS-EC2 Step 1. Installing the Suspension Cables A. B. Step 2. Installing the First Fixture A. B. Step 3. Installing the Remaining Fixtures A. B. F. Step 4. End of Row A. B. We reserve the right to change details of design, materials and finish.

Streszczenie treści zawartej na stronie nr. 4

E S E M d f ed Mas e C Slave CS o i i t r Lighting Systems IS-EC2 Step 1. Modifying Master Unit A. B. F. NOTE: In some instances some of the wires in the fixture are required to remain uncut. (DALI, SHARING DAYLIGHT SENSOR , ETC.) In this case cut plug from secondary power cord and only cut and tap into the hot and neutral wires in the thru-harness. Power Cord 1st Power Drop 2nd Power Drop Master Slave Slave Modified Master Slave Slave 96" 96" 96" 96"

Streszczenie treści zawartej na stronie nr. 5

Lighting Systems IS-EC2 Installing the ECS400T Ground Common (White) (Green) Hot (Black) Ground (Green) Ground (Green) Building’s Electrical ECS400T System White Relay Common Black Common Red Installing the ECS100L +24V in Red N.O. Figure 4 Common (White) Common (White) Ground (Green) Hot (Black) Hot (Black) Ground (Green) Ground (Green) Building’s Electrical System ECS100L Low S. R. L. Low ECS Line Voltage Voltage Voltage Cord Power Cord Wi