Instrukcja obsługi Philips MCD288/12

Streszczenie treści zawartej na stronie nr. 1

2
User Manual
1
Quick Start Guide
MCD 288
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
Component video cables (red/
Remote control with two AAA
A/V cord (R/W/Y)
blue/green)
batteries
15-pin D-Sub cable (with one
External video box FM wire antenna Quick start guide
end fixed on the main set)
AC power cord Stand User manual
MCD288 QUG_Eng-12 1 2007.7.18, 15:40

Streszczenie treści zawartej na stronie nr. 2

1 Connect the speaker (subwoofer) cables. Tips – See the User Manual for other TV 2 connection options. Connect the FM antenna. –For connecting to a Progressive Scan TV, refer to the user manual for proper 3 connections and detailed setup. Connect the A/V cord to a TV. –Never connect the AC power cord before connection of the 15-pin Sub cable to avoid causing any damage to the set. 4 Connect the power cords of the system and TV. AC power S-VIDEO IN AUDIO TV IN IN VIDEO IN 4 4 AUDIO S-VIDEO IN I

Streszczenie treści zawartej na stronie nr. 3

Setting the clock IMPORTANT! – To set clock in the Eco Power mode, press and hold STANDBY-ON/ECO POWER 2 on the set for 3 seconds or more to switch to normal standby mode first before proceeding with the procedures below. 1 In standby mode, press and hold CLOCK/RDS on the remote. 2 When the hour digits flash, press VOLUME-/+ (VOL+/- on the remote) to set the hours. 3 Press CLOCK/RDS again and the minute digits flash. Then press VOLUME-/+ (VOL+/- on the remote) to set the minutes. 4 Press CLOCK/

Streszczenie treści zawartej na stronie nr. 4

P r i n t Playing a disc 1 Insert a disc into the slot loader. ➜ Make sure the label side is facing you. ➜ Make sure you have removed any other disc from the slot loader. 2 Playback will start automatically. If not pressÉÅ. 3 To stop playback, press 9. Programming and tuning to radio stations 1 Press SOURCE (TUNER on the remote) to select tuner source. 2 Press PROGRAM for more than two seconds to program all available stations in order of waveband. 3 Press PRESET ¡ / ™ until the desired preset s