Streszczenie treści zawartej na stronie nr. 1
MICRO COMPONENT SYSTEM
UX-P7R — Consists of CA-UXP7R and SP-UXP7.
COMPACT
DIGITAL AUDIO
CD-R/R W PLA YBACK
STANDBY / ON
MICRO COMPONENT SYSTEM UX·P7R
CLOCK
STANDBY / ON
CD TAPE FM/AM MD/AUX
/
STANDBY/ON
AHB PRO VOLUME
DIMMER DISPLAY SLEEP SOUND TIMER
MD/AUX
PROG RANDOM REPEAT
SOUND AUTO
FM MODE FM/AM
MODE PRESET
TAPE
CD
CD
REV .MODE
CANCEL MULTI KEY SET
DISPLAY PTY
MODE /EON
REC
REC
AUTO REVERSE
AHB PRO PHONES
LEVEL
VOLUME
RM-SUXP7R REMOTE CONTROL
SP-UXP7 CA-UXP7R SP-UXP7
INSTRUCTIONS
For Custom
Streszczenie treści zawartej na stronie nr. 2
Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug REPRODUCTION OF LABELS fitted is not suitable for the power points in your home or the 1 CLASSIFICATION LABEL, PLACED ON REAR ENCLOSURE cable is too short to reach a power point, then obtain an appro- priate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. CLAS
Streszczenie treści zawartej na stronie nr. 3
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and inter
Streszczenie treści zawartej na stronie nr. 4
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging from the wall outlet, always pull the This manual is organized as follows: plug, not the AC power cord. • The manual mainly explains operations using the DO NOT handle the AC power cord with wet hand
Streszczenie treści zawartej na stronie nr. 5
Contents Location of the Buttons and Controls ....................... 3 Playing Back CDs (CD/CD-R/CD-RW) .................. 14 Front Panel ................................................................. 3 Playing Back the Entire CD — Normal Play ........... 14 Remote Control .......................................................... 5 Basic CD Operations ................................................ 14 Programming the Playing Order of the Tracks Getting Started..............................
Streszczenie treści zawartej na stronie nr. 6
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel Front Panel q 1 COMPACT w DIGITAL AUDIO CD-R/R W PLA YBACK e r t STANDBY / ON MICRO COMPONENT SYSTEM UX·P7R 2 CLOCK y STANDBY / ON CD TAPE FM/AM MD/AUX u / 3 AHB PRO VOLUME SOUND TIMER 4 i 5 o 6 7 8 REV .MODE ; a REC REC s AUTO REVERSE PHONES 9 d p – 3 – EN01-13.UX-P7R[B] 3 01.3.14, 1:27 PM
Streszczenie treści zawartej na stronie nr. 7
Continued Display Window 2 1 3 4 [ ] DAILY REC SLEEP REC RDSEON TA NEWS INFO CLOCK PRGM RANDOM ALL BASS SOUND MONOST 5 6 7 8 9p See pages in the parentheses for details. Front Panel Display Window 1 Remote sensor 1 Tape operation indicators 2 (STANDBY/ON) button and STANDBY/ON lamp •2 3 (tape direction) and (reverse mode) (9, 16, 21) indicators 3 AHB (Active Hyper Bass) PRO + / – control (10) 2 Timer indicators 4 SOUND button (10) • (timer), DAILY, REC and SLEEP indicators 5 CD 3/8 (play/pa
Streszczenie treści zawartej na stronie nr. 8
Remote Control Remote Control 1 REPEAT button (16) 2 DIMMER button (10) 3 DISPLAY button (9) 4 PROG (program) button (15) 1 5 RANDOM button (16) 2 STANDBY/ON 6 SOUND MODE button (10) 7 AUTO PRESET button (11) t 8 CD 0 (disc tray open/close) button (14) DIMMER DISPLAY SLEEP y Pressing this button also turns on the unit. 3 MD/AUX PROG RANDOM REPEAT 9 CD 3/8 button (9, 14, 15) 4 u Pressing this button also turns on the unit. 5 SOUND AUTO FM/AM MODE PRESET FM MODE p4 (reverse search) button (11 – 14
Streszczenie treści zawartej na stronie nr. 9
Continued Getting Started Supplied Accessories Connecting Antennas Make sure that you have all the following items. FM antenna The number in the parentheses indicates the quantity of the pieces supplied. • AM loop antenna (1) • FM antenna (1) FM antenna (supplied) • Remote control (1) • Batteries (2) • Speaker cords (2 sets) If anything is missing, consult your dealer immediately. Putting the Batteries into the Remote Control 1 Attach the FM antenna to the FM 75 W Insert the batteries — R6(SUM-3
Streszczenie treści zawartej na stronie nr. 10
AM (MW/LW) antenna Connecting Speakers 2 ] ] 1 3 ANTENNA Vinyl-covered wire (not supplied) Gray Red 1 AM EXT AM LOOP RIGHT LEFT RIGHT LEFT MAIN SPEAKERS SUBWOOFERS FM 75 SPEAKER SPEAKER COAXIAL IMPEDANCE IMPEDANCE MIN 6 MIN 6 Blue Black Speaker cords Speaker cords 2 AM loop antenna (supplied) 1 Connect the AM loop antenna to the AM Black Blue Black Blue LOOP terminals as illustrated. Red Gray Red Gray • If the AM loop antenna wire is covered with Right Speaker Left Speaker vinyl, remove the viny
Streszczenie treści zawartej na stronie nr. 11
To remove the speaker grilles To connect audio equipment with an optical digital The speaker grilles are removed as the illustrations below. input terminal You can record CD sound onto the connected digital equipment. Holes Projections Protective plug OPTICAL DIGITAL OUT Speaker grille Before connecting the other equipment, remove the protective plug from the terminal. Audio equipment with an optical digital input To optical digital input To remove the speaker grille, inserting your fingers at t
Streszczenie treści zawartej na stronie nr. 12
Common Operations Turning On the Power 2 Press ¢ or 4 to adjust the hour, then press CLOCK. When you press the play button — CD 3/8, TAPE 2 3, or The minute digits start flashing on the the source selecting button — FM/AM, and MD/AUX, the display. unit automatically turns on and starts playback if the source is CLOCK ready. To turn on the unit, press (STANDBY/ON). CLOCK The STANDBY/ON lamp lights green. STANDBY/ON STANDBY/ON 3 Press ¢ or 4 to adjust STANDBY/ON the minute, then press CLOCK. The
Streszczenie treści zawartej na stronie nr. 13
Adjusting the Volume Reinforcing the Bass Sound You can adjust the volume level only while the unit is turned You can reinforce the bass sound to maintain rich, full bass at on. The volume level can be adjusted between “VOLUME 0” low volume. This function only affects the playback sound, and “VOLUME40.” but does not affect your recording. When using the remote control, When using the remote control, press AHB PRO LEVEL VOLUME press VOLUME + to increase the AHB PRO LEVEL + to increase the bass vo
Streszczenie treści zawartej na stronie nr. 14
Listening to FM and AM (MW/LW) Broadcasts Tuning in a Station 3 Repeat steps 1 and 2 to store stations for the other band. 1 Press FM/AM. FM/AM The unit automatically turns on and tunes in the previously tuned station (either FM or AM When you cannot automatically store stations you want — MW/LW). Stations with weak signals cannot be detected with this automatic • Each time you press the button, the band presetting. To store such a station, use the manual presetting. alternates between FM and AM
Streszczenie treści zawartej na stronie nr. 15
Continued Receiving FM Stations with RDS RDS (Radio Data System) allows FM stations to send an Searching for Programs by PTY Codes additional signal along with their regular program signals. (PTY Search) For example, the stations send their station names, as well as information about what type of program they broadcast, such One of the advantages of RDS is that you can locate a as sports or music, etc. particular kind of program by specifying the PTY codes. When tuned to an FM station which prov
Streszczenie treści zawartej na stronie nr. 16
Switching to a Program Type of Your Choice How the EON function actually works: Temporarily CASE 1 By receiving EON (Enhanced Other Networks) data sent by If there is no station broadcasting the program you FM RDS stations, the EON function allows the unit to switch have selected temporarily to a broadcast program of your choice (TA, The unit continues tuning in the current station. NEWS, and INFO) from a different station. Ç • The EON function only works when you are listening to a When a stati
Streszczenie treści zawartej na stronie nr. 17
Continued Playing Back CDs (CD/CD-R/CD-RW) This unit has been designed to playback the following CDs: 3 Press CD 3/8. CD •CD The disc tray automatically closes and the first • CD-R track of the CD starts playing. • CD-RW Continued use of irregular shape CDs (heart-shape, octagonal, etc.) can damage the Track number Elapsed playing time unit. • The CD automatically stops when the last track of the CD has finished playing. General Notes To stop playing, press 7. In general, you will have the best
Streszczenie treści zawartej na stronie nr. 18
To check the program contents Programming the Playing Order of the Tracks PROG You can check the program contents by — Program Play pressing PROG on the remote control. The programed tracks are shown in the You can arrange the order in which tracks play before you programed order. start playing. You can program up to 20 tracks. To modify the program 1 Load a CD. CANCEL Before or after playing, you can erase the last • If the current playing source is not the CD player, press programed track by p
Streszczenie treści zawartej na stronie nr. 19
Playing at Random — Random Play Prohibiting Disc Ejection — Tray Lock The tracks will play in no particular order when you use this You can lock the disc tray and prohibit to eject the CD. mode. • This is possible only while the unit is turned on. On the remote control ONLY: On the unit ONLY: RANDOM To use Random play mode, press RANDOM To prohibit disc ejection, press before or during playing. (STANDBY/ON) while holding 7. (If the The RANDOM indicator lights up on the display. disc tray is open
Streszczenie treści zawartej na stronie nr. 20
Playing Back Tapes You can play back type I, type II, and type IV tapes without To stop playing, press 7. changing any settings. To fast-wind to the left or to the right, press ¢ or 4 while the tape is not running. The tape direction indicator (3 or 2) starts flashing quickly Playing Back a Tape on the display. To remove the cassette, press 0 for cassette deck. 1 Press 0 for cassette deck. To play both sides — Reverse Mode You can set the deck to play just one side of a tape, both sides once, or
