Instrukcja obsługi Home Automation 10A11-1

Streszczenie treści zawartej na stronie nr. 1

Model 10A11-1, Rev C
Two-Way Audio/Voice Alarm Module
DESCRIPTION

The Model 10A11-1, Rev C Two-Way Audio/Voice Alarm Module allows two-way communication with a central station after an
alarm, paging and listening from an on-premises or remote phone, annunciation of alarm and zone by voice, and voice messaging.
The Model 10A11-1, Rev C also provides a line-level audio output that can be tied into an amplifier or whole home audio system, and
a page output that is activated whenever

Streszczenie treści zawartej na stronie nr. 2

28A00-1, 28A00-2, 33A00-4 CONSOLE, MODEL 10A11-1, REV C 33A00-20 KEYPAD, OR TWO-WAY AUDIO/VOICE ALARM MODULE SPEAKERS / MICROPHONES + SPKR1 (SPEAKER #1 OUTPUT) TWISTED PAIR 8 OHM - SPKR1 (SPEAKER #1 COMMON) SPEAKER + SPKR2 (SPEAKER #2 OUTPUT) - SPKR2 (SPEAKER #2 COMMON) TWISTED PAIR 8 OHM SPEAKER TWO-WIRE + + MIC1 (MICROPHONE #1 INPUT) ELECTRET _ MICROPHONE - MIC1 (MICROPHONE #1 COMMON) TWISTED PAIR WITH SHIELD + MIC2 (MICROPHONE #2 INPUT) TWO-WIRE + ELECTRET - MIC2 (MICROPHONE #2 COMMON) _ MI

Streszczenie treści zawartej na stronie nr. 3

Figure 2 - OmniLT Installation Figure 3 - Omni II, OmniPro II, Lumina, and Lumina Pro Installation CONTROLLER SETUP When using a Model 10A11-1, Rev C for two-way communication with a central station, the Two-Way Voice option must be enabled. From the Installer Setup menu, select the 3 (DCM) key. Press the down arrow ( ) key until you reach the Two-Way Audio option: TWO-WAY AUDIO: 0 0=NO 1=YES ↓ Press 1 (YES), and then press ' # ' to enable two

Streszczenie treści zawartej na stronie nr. 4

CENTRAL STATION OPERATION When an alarm occurs, the communicator first sends the appropriate report to the central station. After the transmission of the alarm to the central station, the operator can talk and listen to people and sounds at the premises. After the report is received by the central station operator, the Two-Way Audio Module is switched on. The central station operator can now listen to the premises. The module is always first switched on in the listen mode. The ope