Instrukcja obsługi Atlas GUARDIAN PRO MLGS180B

Streszczenie treści zawartej na stronie nr. 1

TEST
ON-TIME
Put the ON-TIME switch on the
bottom of the sensor in the TEST
position.
10 5 1 TEST
™
AUTO
GUARDIAN PRO
ON-TIME
Put the ON-TIME switch in the 1,
MOTION SENSOR
5, or 10 minute position.
10 5 1 TEST
Models MLGS180B
MANUAL MODE
MLGS180W
Manual mode only works at night
because daylight returns the sen-
sor to AUTO.
Features
• Turns on lighting when motion is detected.
Flip the light switch off for one
• Automatically turns lighting off.
1 Second OFF
second then back on to toggle
• Phot

Streszczenie treści zawartej na stronie nr. 2

❒ After screwing the sensor into the wall plate, INSTALLATION connect the junction box wires to the Light For under eave installation, the sensor head Control wires by twisting together and securing must be rotated as shown in the next two steps for with wire connectors. proper operation and to avoid the risk of electrical shock. Red Sensor Wire to Black Lamp Wire White to White For eave mount only: Junction ❒ Swing the sensor head towards the clamp Box screw. Controls Clamp Screw Lamp Holders B

Streszczenie treści zawartej na stronie nr. 3

❒ Loosen the clamp screw in Clamp TEST AND ADJUSTMENT the sensor ball joint and Screw ❒ Turn on the circuit breaker and light switch. gently rotate the sensor. 1 ❒ Walk through the cover- NOTE: Sensor has a 1 /2 minute calibration Ball age area noting where you period before it will detect motion. When Joint 1 are when the lights turn on first turned on, wait 1 /2 minutes. (also, the LED will flash ❒ Turn the RANGE control to the mid position and several times when motion the ON-TIME control to

Streszczenie treści zawartej na stronie nr. 4

TROUBLESHOOTING GUIDE If you experience a problem with your Light Control, first follow this guide. For additional assistance write to: Atlas Lighting Products, Inc. • Customer Service Department • P.O. Box 2348 • Burlington, NC 27216 SYMPTOM POSSIBLE CAUSE SYMPTOM POSSIBLE CAUSE Lights will not 1. Light switch is turned off. Lights stay on 1. A lamp is positioned too close to the sensor come on. 2. Light is loose or burned out. continuously. or pointed at nearby objects that cause heat 3. Fuse