Instrukcja obsługi Test Products International 505

Streszczenie treści zawartej na stronie nr. 1

TM 505
The Value Leader
www.tpi-thevalueleader.com
PHOTO / CONTACT
TACHOMETER
505 Instruction Manual
Instruction Manual
Test Products International, Inc.
9615 SW Allen Blvd
Beaverton, OR 97005-4814 USA
Ph: 503-520-9197 Fax: 503-520-1225
Test Product International Ltd.
342 Bronte Street South, Unit 9
Milton, Ontario L9T 5B7
Ph: 905-693-8558 Fax: 905-693-0888
Test Products International UK Ltd.
Longley House, East Park
Crawley, West Sussex RH10 6AP
Ph: +44 (0) 1293 561212 Fax: +44 (0) 1293 8134

Streszczenie treści zawartej na stronie nr. 2

OPERATION SPECIFICATIONS WARNING Function Range Accuracy Read instructions before operating: Be sure these instructions accompany the tool Photo Tach 6 - 30,000 RPM ± 0.1% of FS + 1 digit when passed from one user to a new or inex- Contact Tach 6 - 20,000 RPM ± 0.1% of FS + 1 digit perienced user. Rotating equipment can cause flying particles Surface Speed 0.9 - 3,046 m/min ± 0.1% of FS + 1 digit Wear Safety Goggles (User and bystanders). 2.0 - 9,990 ft/min ± 0.1% of FS + 1 digit Flying p

Streszczenie treści zawartej na stronie nr. 3

PHOTO TACH OPERATION BATTERY REPLACEMENT Measurement Procedure: Measurement Procedure: 1. Unscrew contact collar from optical end of 505 (if attached). 1. Remove the screw holding the battery compart- 2. Attach a piece of reflectIive tape on the rotating ment cover in place on the back of the 505. object to be measured. 2. Slide the cover off of the unit. 3. Depress and hold the START button and then 3. Remove the 2 each “AA” alkaline batteries and press the Photo button (lower right) on

Streszczenie treści zawartej na stronie nr. 4

SURFACE SPEED OPERATION CONTACT TACH OPERATION Measurement Procedure: Measurement Procedure: 1. Screw the shaft assembly to the optical end of 1. Screw the shaft assembly to the optical end of the 505. the 505. 2. Insert the cone or concave wheel that more 2. Insert the large wheel to the end of the shaft closely matches the end of the component to assembly. be measured on the shaft assembly. 3. Press and hold the START button and then 3. Press and hold the START button and then press the