Streszczenie treści zawartej na stronie nr. 1
Streszczenie treści zawartej na stronie nr. 2
Your Local Agent/Dealer Your Local Agent/Dealer 9-52 Ashihara-cho, 9-52 Ashihara-cho, Nishinomi Nishinomiy ya, Ja a, Jap pan an Tele Telep phone : hone : 0798-65-2111 0798-65-2111 Telefax : Telefax : 0798-65-4200 0798-65-4200 FIRST EDITION : FIRST EDITION : SEP. SEP. 1995 1995 A All ri ll rig ghts reserved. hts reserved. Printed in Japan Printed in Japan U : U : JUN. JUN. 03,2002 03,2002 PUB.No. PUB.No. OME-43740 OME-43740 *00080733901* *00080733901* *00080733901* *00080733901*
Streszczenie treści zawartej na stronie nr. 3
SAFETY INSTRUCTIONS "DANGER", "WARNING" and "CAUTION" notices appear throughout this manual. It is the responsibility of the operator and installer of the equipment to read, understand and follow these notices. If you have any questions regarding these safety instructions, please con- tact a FURUNO agent or dealer. This notice indicates a potentially hazardous situation which, if not avoided, will result in death or DANGER serious injury. This notice indicates a potentially hazardous situation w
Streszczenie treści zawartej na stronie nr. 4
SAFETY INFORMATION FOR THE OPERATOR CAUTION WARNING Do not place liquid-filled containers on Do not open the cover of the the top of the equipment. equipment. Fire or electrical shock can result if a This equipment uses high liquid spills into the equipmtnt. voltage electricity which can shock, burn or cause death. Do not place heater neat the equipment. Only qualified person- nel should work inside the Heat can melt the power cord, which can equipment. result in fire or electrical shock. Do
Streszczenie treści zawartej na stronie nr. 5
4. NAVIGATION PLANNING TABLE OF 4.1 Registering Waypoints ...................... 4-1 CONTENTS 4.2 Editing Waypoints............................. 4-4 4.3 Deleting Waypoints........................... 4-5 4.4 Registering Routes............................ 4-5 4.5 Deleting Route Waypoints ................ 4-6 FOREWORD ............................iii 4.6 Replacing Route Waypoints.............. 4-7 4.7 Deleting Routes ................................ 4-7 SYSTEM OVERVIEW ...............1 5. STARTING F
Streszczenie treści zawartej na stronie nr. 6
8.5 Receiving Data from Personal Computer .......................................... 8-8 8.6 DGPS Settings ................................ 8-10 8.7 Displaying GPS Monitor Displays . 8-12 9. MAINTENANCE & TROUBLESHOOTING 9.1 Clearing the Memory ........................ 9-1 9.2 Preventative Maintenance................. 9-2 9.3 Error Messages ................................. 9-2 9.4 Troubleshooting ................................ 9-4 9.5 Self Tests .........................................
Streszczenie treści zawartej na stronie nr. 7
• Man overboard feature records latitude and FOREWORD longitude coordinates at time of man over- board and provides continuous updates of range and bearing to that point • DGPS capability—with built-in DGPS A Word to GP-80 Owners beacon kit, or accepts DGPS correction data from external DGPS beacon receiver Congratulations on your choice of the • Menu-driven operation FURUNO GP-80 GPS Navigator. We are con- • Bright 122 x 92 mm LCD with tempera- fident you will see why the FURUNO name ture compe
Streszczenie treści zawartej na stronie nr. 8
This page is intentionally left blank.
Streszczenie treści zawartej na stronie nr. 9
SYSTEM OVERVIEW 1. Menu Tree Display selection menu DISPLAY Select Display (Plotter 1, Plotter 2, Highway, Navigation and Data displays) SEL Main menu MENU 1. DISPLAY SETUP ESC 2. TRACK/MARK SETUP 3. ERASE TRACK/MARK 4. ALARM SETTINGS 1/2 ALARM SETTINGS 2/2 5. MANUAL CALCULATION 6. 7. GPS MONITOR SATELLITE MONITOR BEACON RCVR MONITOR STATION MESSAGE 8. SELF TESTS 1. MEMORY, I/O PORT TEST 2. KEYBOARD TEST 3. TEST PATTERN
Streszczenie treści zawartej na stronie nr. 10
Waypoint, route menu WPT 1. Cursor RTE 2. MOB/Event Position 3. Own Ship Position 4. Waypoint List WAYPOINT LIST 5. Route Planning ROUTE LIST GOTO menu GOTO 1. Cursor 2. MOB/Event Position 3. Waypoint List GOTO "Waypoint List" 4. Route List GOTO "Route List" 5. Cancel 2
Streszczenie treści zawartej na stronie nr. 11
2. System Configuration ANTENNA UNIT Receives GPS signals. BEACON ANTENNA UNIT Receives GPS correction data from DGPS reference station. DISPLAY UNIT Receives and processes GPS signals to fix position and display it in latitude/longitude or LOP. Ship's Mains 10.2 to 31.2 VDC 3
Streszczenie treści zawartej na stronie nr. 12
3. Operation Flow Chart Select display mode • Plotter 1 (own ship's track and data) • Plotter 2 (own ship's track) • Highway (ship's track overlaid on navigation lane) • Navigation (graphic navigation data display for steering) • Data (alphanumeric navigation data) Set destination temporarily Register waypoints • By latitude and longitude • By LOP Register routes Set destination Display steering data Set alarms Perform other operations as required. (Position correction, geodetic chart to use
Streszczenie treści zawartej na stronie nr. 13
1. OPERATIONAL OVERVIEW 1.1 Control Description Cursor keys Shift display and cursor. MENU NU/CU Opens/closes menu; Selects display orientation; ESC ENT quits current operation. registers selections on menus. EVENT DISPLAY Inscribes event mark at Selects display mode. 6 1 MOB SEL ship's position; marks man overboard position WPT GOTO Registers waypoints Sets destination. 2 RTE 7 and routes. PLOT MARK Inscribes mark on Turns recording and plotting 3 ON/OFF 8 the display. of ship's track on/off. Z
Streszczenie treści zawartej na stronie nr. 14
When turning on the power the following oc- 1.2 Turning On and Off the curs: Power 20 seconds after turning on the power, accu- The GP-80 takes about two minutes to find rate position (in latitude and longitude) ap- position when turned on for the very first time. pears on the display. Thereafter it takes about 20 seconds to find If position could not be found, "NO FIX" ap- position each time the power is turned on. pears at the GPS receiver condition window. When PDOP value exceeds 6 in the 3D
Streszczenie treści zawartej na stronie nr. 15
Note 1: When PDOP value exceeds 6 in the 1.4 Selecting the Display 3D mode, the position fixing method is automatically changed to 2D. Mode Note 2: The "DEMO" icon appears when the 1) Press the [DISPLAY SEL] key. The dis- display is in the demonstration mode. To return play shown in Figure 1-4 appears. to normal mode, turn off the power and turn it on while pressing and holding down the [NU/ CU ENT] key. Select Display Note 3: Refer to page 10-2 about HDOP and Plotter 1 Plotter 1 PDOP. Plotter 2
Streszczenie treści zawartej na stronie nr. 16
Plotter 1 display Plotter 2 display Bearing from own ship Cursor position or lighthouse to destination waypoint data, when cursor is on Ship's position appears when cursor is off Course GPS receiving Own ship's bar condition track Own ship Alarm 34° 23.456´ N 135° 45.678´ E DGPS 3D mark range 30 [01] 34° 23.456´ N 135° 45.678´ E DGPS 3D 30 BRG 40 50 [01] 44° H CSE 40 32° 50 20 H BRG TO + WGS84 2.00 nm 123° RNG TO + 20 Figure 1-6 Plotter 2 display WGS84 nm 11.5 2.00 nm Highway display Horizont
Streszczenie treści zawartej na stronie nr. 17
2) With autopilot connection, automatic Navigation display mode 1) No autopilot connection Cross track Bearing from own DGPS 3D TO; 012 error meter ship to destination SPD E waypoint Bearing kt Destination Speed 12.3 scale Velocity To waypoint no. N Destination VTD BRG: 10.3 kt 63° DGPS 3D CSE: TO; 012 S RNG E SPD 123° 0.1nm 0.1nm 123 nm 12.3 kt N VTD TRIP Auto Pilot Hdg Str BRG 789 10.3 nm kt Auto 123° P 23° 63° CSE S RNG 123° 0.1nm 0.1nm 123 Auto mode nm Heading Rudder angle Rudder
Streszczenie treści zawartej na stronie nr. 18
Data display (Window assignment and size of characters are user-definable) Position in latitude and longitude or LOPs Fixing date and time* Cursor SEP 12, 1995 23:59'59" U DGPS 3D POSITION 12° 23.456' N 123° 23.456' E WGS84 TO : 001 RNG BRG MARINE 223.4° nm 31.23 POINT1 NEXT : 002 SPD CSE MARINE 12.3 kt 123.4° POINT2 User-defined User-defined Current destination waypoint display data #1 display data #4 Next destination waypoint User-defined User-defined display data #3 display data #2 User-def
Streszczenie treści zawartej na stronie nr. 19
2.3 Shifting the Cursor 2. TRACK The cursor can be shifted with the cursor keys. 1) Press the [CURSOR ON/OFF] key to turn 2.1 Enlarging/Shrinking the on the cursor. Display 2) Press the cursor keys. You may enlarge and shrink the display on The cursor moves in the direction of the cur- the Plotter 1 and Plotter 2 displays, with the sor key pressed. When the cursor reaches the [ZOOM IN] and [ZOOM OUT] keys. The edge of the display, the display shifts in the horizontal range is available among 0.2
Streszczenie treści zawartej na stronie nr. 20
Cursor turned off 2.5 Centering Cursor Position Ship's position (in latitude and longitude or LOPs), speed and course appear on the dis- 1) Press the [CURSOR ON/OFF] key to turn play. on the cursor. Own ship 2) Press the cursor keys to position the cur- Own ship position mark in latitude and longitude sor. 3) Press the [CENTER] key. 34° 23.456´ N 135° 45.678´ E DGPS 3D BRG 2.6 Centering Own Ship's 234° Position CSE 345° 1) Press the [CURSOR ON/OFF] key to turn off the cursor. RNG 123 nm 2) Press
