Streszczenie treści zawartej na stronie nr. 1
Gas Grill
Built-In Natural Gas Grill Installation Guide
™
s-460
™
s-660
# 43270
YoU mUSt rEad tHIS owNEr’S GUIdE
m warNING: follow all leak-check
bEforE opEratING YoUr GaS GrILL. procedures carefully in this manual prior
to barbecue operation. do this even if the
barbecue was dealer-assembled.
m daNGEr
If you smell gas:
NotICE to INStaLLEr: these instructions
1. Shut off gas to the appliance.
must be left with the owner and the owner
2. Extinguish any open flames.
should keep them for fu
Streszczenie treści zawartej na stronie nr. 2
2 warNiNGs m do not attempt to disconnect any gas fitting while your m daNGEr barbecue is in operation. f ailure to follow the dangers, warnings and Cautions m Keep any electrical supply cord and the fuel supply hose contained in this o wner’s manual may result in serious away from any heated surfaces. bodily injury or death, or in a fire or an explosion causing ® m do not use this weber tank enclosure kit unless all damage to property. parts are in place. the unit must be properly as
Streszczenie treści zawartej na stronie nr. 3
3 built-iN cutout DimeNsioNs “ISLaNd” S tr UCtUrE CoNfIGUratIoN optIoNS 2 3 There are many available options for locating the major components of your Island structure.Your major components are: A 1) The Built in Grill 2) Gas supply enclosure 3) Optional Side burner accessory 3 The 3 common options (A, B, C) are illustrated in the “Island Structure Configuration 1 Options” table. note: Gas line limitation The gas supply hose from grill manifold to gas supply bulkhead must not exceed 58" (1
Streszczenie treści zawartej na stronie nr. 4
4 built-iN cutout DimeNsioNs bUILt-IN S tr UCtUrE CUtoUt dImENSIoNS built-iN cutout DimeNsioNs aLL dImENSIoNS arE to fINISHEd SUrfa CES. S-460™ S-660™ t oLEraNCES m warNING: all countertop finished surfaces must be 1 1 1 1 1 30 / " (768.35 mm) 38 / " (971.55 mm) + / " - / " (6.35mm) 4 4 4 4 constructed of a noncombustible material. 3 3 1 1 2 34 / " (873.13 mm) 34 / " (873.13 mm) + / " - / " (6.35mm) 8 8 4 4 1 1 3 23" (584.2 mm) 23" (584.2 mm) + / " - / " (6.35mm) 4 4 1 d 1 1 1 4 2 2 5
Streszczenie treści zawartej na stronie nr. 5
5 Parts list ™ s-460 5 Lid - 1 Left door - 1 Cookbox - 1 right door - 1 warming rack - 1 oR ™ s-660 Lid - 1 right Enclosure p anel - 1 Cookbox - 1 Left Enclosure panel - 1 f ront f rame rail - 1 f ront Vent panel - 1 r ear f rame rail - 1 r ear panel a ssembly - 1 r ear Vent - 1 bottom Shelf - 1 Corrugated Gas Line - 1 ® www.weber.com
Streszczenie treści zawartej na stronie nr. 6
6 Parts list ® flavorizer bars Smoker bar - 1 ™ - 8 s-460 ™ - 12 s-660 1/2 inch bolts (¼-20 x 1/2 inch bolt) - 10 Stainless Steel Cooking Grates ™ - 2 s-460 ™ - 3 s-660 Nylon washer - 10 Collection t ray - 1 Hinge pin - 2 Catch-pan Holder - 1 Hair pin Cotter - 2 #10-24 x 1 inch Steel Screw - 2 Catch-pan - 1 Locking washer - 2 disposable drip p ans - 2 #10-32 x 1/4 inch Steel Screw - 5 battery Housing - 1 ¼-20 x 1/2 inch t russ Head Screw - 2 #10 Sheet metal Screw - 3 right f ront Vent Clip - 1
Streszczenie treści zawartej na stronie nr. 7
7 assemblY 7 1 door Stop bracket (a) should be positioned as shown. A m attENtIoN! do not attach rear support screws and washers until Step #6. 2 ® www.weber.com
Streszczenie treści zawartej na stronie nr. 8
8 assemblY 3 m attENtIoN! do not fully tighten screws. Clips should slide freely when installed. 4 ® www.weber.com
Streszczenie treści zawartej na stronie nr. 9
9 assemblY 9 5 6 back ® www.weber.com
Streszczenie treści zawartej na stronie nr. 10
10 assemblY 7 ® www.weber.com
Streszczenie treści zawartej na stronie nr. 11
11 assemblY ® m CaUtIoN: Use two people to lift and install the Summit built-In frame assembly. 11 a) Lift the frame assembly into the “island” structure opening. Make sure the frame is resting level on the finished surface of the structure. b) Adjust the Front Vent to rest squarely on ground. 8 1 1 1 b A a 1 1 1 a B clearaNces 24" (610 mm) Any Surface 1 Grill Frame a Note: For a countertop treatment: Recommended 19.1 mm (3/4˝ inch) over- b hang. Notch front edge for frame to fully slide in
Streszczenie treści zawartej na stronie nr. 12
12 assemblY 9 1 / " (6.35 mm) 4 drill bit 10 S-460™ S-660™ ® www.weber.com
Streszczenie treści zawartej na stronie nr. 13
13 assemblY 13 11 a) Apply a bead of silicone sealant (1) around the perimeter and front edges of the grill that are in contact with the “island” structure. This will prevent moisture seepage. The sealant you use must have a temperature rating above A 120°F (48.8° C). 1 m attENtIoN! before applying any silicone sealant make sure the cookbox is flush with the front of the grill frame. ® www.weber.com
Streszczenie treści zawartej na stronie nr. 14
14 assemblY S-660™ S-460™ 12 3 - 2 1 2 1 4 batterY housiNG wiriNG 3 1 BLACK WIRE 4 2 GREEN WIRE 3 RED WIRE 3 4 RED WIRE m warNING: make sure that all control knobs are turned to the off position before connecting the gas supply and operating the grill. ® www.weber.com d
Streszczenie treści zawartej na stronie nr. 15
15 assemblY Requires 3 “D” alkaline batteries (included). Use alkaline batteries only. Do not mix old and new batteries or different types 15 of batteries (standard, alkaline or rechargeable). 13 14 Note: Secure wire to side panel. 1 2 3 ® www.weber.com
Streszczenie treści zawartej na stronie nr. 16
16 assemblY 15 1 2 3 16 S-460™ S-660™ 17 2 1 ® www.weber.com
Streszczenie treści zawartej na stronie nr. 17
17 assemblY 17 S-460™ S-660™ 18 A B match Holder C ® www.weber.com
Streszczenie treści zawartej na stronie nr. 18
assemblY 18 19 m attENtIoN! before drilling any holes for 1 the rear vent / " (6.35 mm) 4 make sure the drill bit cookbox is flush with the front of the grill frame. s-460™ s-660™ 20 ® www.weber.com
Streszczenie treści zawartej na stronie nr. 19
19 assemblY ™ ™ s-460 s-660 19 21 ™ ™ s-460 s-660 22 s-460™ s-660™ 23 ® www.weber.com
Streszczenie treści zawartej na stronie nr. 20
20 assemblY s-460™ s-660™ 24 ® www.weber.com
