Streszczenie treści zawartej na stronie nr. 1
T TM M
ITEM / ARTICLE / ARTICULO # 271573
STAINLESS STEEL LP GAS GRILL
GRIL AU GAZ PL EN ACIER
INOXYDABLE (page 29)
PARRILLA A GAS PL DE ACERO
INOXIDABLE (página 57)
MODEL / MODÈLE / MODELO # 720-0522
WARNING WARNING
To reduce the risk of fire, burn hazard or FOR OUTDOOR USE ONLY
other injury, read the Care and Use
®
Manual carefully
Streszczenie treści zawartej na stronie nr. 2
TABLE OF CONTENTS Safety Information….…………………………………………………....………………...……..….3 Package Contents List………………………………………………………………………..……..7 Preparation……………….…………………. ……………………….…………….………………..8 Assembly Instructions…………………………………………………………….…..……..………8 Installation Instructions…………………………………………………………….....…….……...15 Operation Instructions…….…………………………………………………….…..…..……….…17 Care and Maintenance……………………………………………………………………………..22 Troubleshooting…………………………………………………………………..……….………..24 Warranty………
Streszczenie treści zawartej na stronie nr. 3
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. If you have any questions regarding the product please call customer service at 1-877-323-5263, 8 a.m. - 6 p.m., PST, Monday - Friday, 8 a.m. – 12 p.m. on Saturday. 1. Safety Symbols WARNING – Hazardous or unsafe practices which could result in severe personal injury or death. CAUTION – Hazardous or unsafe practices which could result in minor personal injur
Streszczenie treści zawartej na stronie nr. 4
WARNING Do not use the grill if the odor of gas is present. Contact customer service at 1-877-323-5263. CAUTION 1. The grill head is heavy and will require two or more people to lift and position onto grill cart. 2. Before cleaning, make sure the gas supply and control knobs are in the “OFF” position and the burners have cooled. 3. When using a match to light the grill make sure to use the attached lighting rod. 4. When using the rotisserie burner, remove the warming rack.
Streszczenie treści zawartej na stronie nr. 5
WARNING Electrical Grounding Instructions for Rotisserie Motor – This appliance (rotisserie motor) is equipped with a plug and should be plugged directly into a properly grounded receptacle. When installed, must be electrically grounded in accordance with local codes or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or the Canadian Electrical Code, CSA C22.1. DO NOT cut or remove the grounding prong from this plug. 1. To protect against elect
Streszczenie treści zawartej na stronie nr. 6
• Use a covered hand when opening the grill lid. Never lean over an open grill. • When lighting a burner, always pay close attention to what you are doing. Make certain you are aware of which burner you are lighting so that your body and clothing remain clear of open flames. • When using the grill, do not touch the grill rack, burner grate or immediate surroundings as these areas become extremely hot and could cause burns. Use only dry potholders. Moist or damp potholders on hot surfaces
Streszczenie treści zawartej na stronie nr. 7
T TM M PLACEMENT OF THE GRILL WARNING Do not install this unit into combustible enclosures. There should be a minimum clearance of 24 inches from all sides to combustible materials. Outdoor cooking appliances should not be used under overhead combustible construction. When determining a suitable location take into account concerns such as exposure to wind, proximity to traffic paths, and keeping gas supply lines as short as possible. Place the grill in wel
Streszczenie treści zawartej na stronie nr. 8
HARDWARE CONTENTS Pack Description Quantity A 5/32-in. x 10-mm Truss Head Screw 24 pcs. A B B 5/32-in. Locking Washer 24 pcs. C 1/4-in. x 15-mm Truss Head Screw 45 pcs. D 1/4-in. Locking Washer 45 pcs. E 5/32-in. x 15-mm Ladder Bolt 1 pc. C D E F Lighting Rod 1 pc.
Streszczenie treści zawartej na stronie nr. 9
Fig. 2 2. Side Panel Assembly B Loosen, but do not remove, the six 1/4-in. x 15-mm truss C head screws on the bottom panel (A) as shown in fig. 2. Insert the screw and locking washer into the keyhole slot located on the bottom of the left side panel (B). Position the left side panel flush with the rear of the bottom panel and tighten the screws. Repeat steps fo
Streszczenie treści zawartej na stronie nr. 10
Fig. 5 4. Transformer Box Assembly B Align the holes of the transformer box (A) with the holes on the back panel (B). Attach the transformer (A) to the back panel (B) A using six 5/32-in. x 10-mm truss head screws from pack A and C six 5/32-in. locking washers from pack B as shown in fig. 5. The power cord bracket (C) connects to the rear cart panel using two 5/32-in. x 10-mm truss head screws from pack A and two 5/32-in. locking washers from pack B as shown in fig.5.
Streszczenie treści zawartej na stronie nr. 11
TM T M Fig. 8 7. Door Assembly Insert hinge pin on bottom panel into hole located on bottom of door (A). Insert door hinge bracket into the cart frame (B) and align with the hole in the top B of the door. Attach the door hinge brackets to the cart frame with four 5/32-in. x 10-mm truss head screws from pack A and four 5/32-in. locking washers from pack B as shown in fig. 8. A Fig. 9 8. Liquid Propane Tank Heat Shield Assembly Attach the heat shield (A) to
Streszczenie treści zawartej na stronie nr. 12
Fig. 11 A Attach the firebox assembly (A) to the grill cart (B) using four 1/4-in. x 15-mm truss head screws from pack C and four 1/4- in. locking washers from pack D as shown in fig. 11. B Fig. 12 10. Utility Drawer Handle Assembly Attach the utility drawer handle (A) to the utility drawer using four 5/32-in. x10-mm truss head screws from pack A and four 5/32-in. locking washers from pack B as shown in fig. 12. A
Streszczenie treści zawartej na stronie nr. 13
M T TM TM TM Fig. 14 12. Searing Side Burner and Side Shelf Assembly Attach the left side shelf (A) to the grill cart (B) using Four 1/4-in. x 15mm truss head screws from pack C and Four 1/4- A in. 1/4’’Locking Washer from pack D, screw left side panel using one 5/32-in. x 10mm truss head screws from pack A and one 5/32-in locking washer from pack B as shown in fig. 14. Attach the searing side burner shelf (C) to the grill cart (B) using Four 1/4-in. x 15mm truss head screw
Streszczenie treści zawartej na stronie nr. 14
T M TM Fig. 17 15. Battery Installation Unscrew the ignition button housing (A); insert the battery from pack G into the housing with the positive terminal (+) facing outward (B). Replace the ignition button housing after the battery has been installed as shown in fig. 17. B A Fig. 18 16. Lighting Rod Installation Remove the lighting rod and one 5/32-in. x15-mm ladder bolt from pack E and F. Open the right door (A) and insert the ladder screw with
Streszczenie treści zawartej na stronie nr. 15
CLO SE Fig. 20 18. Liquid Propane Hook-Up Attach the regulator (A) to the propane cylinder (B) by B turning the regulator handle clockwise as shown in fig. 20. If the outdoor cooking appliance is not in use, the gas must be turned “OFF” at the Liquid Propane cylinder. Check all gas supply fittings for leaks before each use. Do not use the grill until all connections have been checked and do not leak (see “Leak Testing” A instructions on page 16). INSTALLATION INST
Streszczenie treści zawartej na stronie nr. 16
Remove the plastic valve cover from the Liquid Propane cylinder. Make sure the grill gas hoses do not contact the grease pan or grill firebox when the Liquid Propane cylinder is placed into the cart. CONNECTING THE LIQUID PROPANE CYLINDER Your grill is equipped with gas supply orifices for use with only Liquid Propane gas. It is also equipped with a high capacity hose/regulator assembly for connection to a standard 20-lb Liquid Propane cylinder (18-1/4 inches high, 12-1/4 inches diameter)
Streszczenie treści zawartej na stronie nr. 17
3. Apply the soap solution to all gas fittings. Soap bubbles will appear where a leak is present. 4. If a leak is present, immediately turn the gas supply “OFF” and tighten leaky fittings. 5. Turn the gas back “ON” and recheck. 6. Should the gas continue to leak from any of the fittings, turn the gas supply “OFF” and contact customer service at 1-877-323-5263. 7. If there is evidence of excessive abrasion or wear, or the hose is cut, it must be replaced prior to the outdoor cooking gas
Streszczenie treści zawartej na stronie nr. 18
Food cooked for a long time or basted with a sugar-based marinade may need a lower heat setting near the end of its cooking time. To begin: 1. Make sure the grill has been leak tested and is properly placed. 2. Remove any remaining packing materials. 3. Light the grill burners using the Lighting Instructions below. 4. Turn the control knob(s) to the “IGNITE / HI” setting, and preheat the grill for 15 minutes. The grill lid should be closed during the pre-heat period. 5. Place the foo
Streszczenie treści zawartej na stronie nr. 19
blue and stable with no yellow tips, excessive noise or lifting. Yellow flames indicate insufficient air. Noisy flames or flames that lift away from the burner indicate too much air (See the “Flame Characteristics” section on page 23). TO LIGHT THE ROTISSERIE BURNER 1. Open the lid, push and turn rear burner knob slowly to “IGNITE/ON” setting; simultaneously press the electronic ignition button to light the burner. 2. Once the burner is lit, release the electronic ignition button and k
Streszczenie treści zawartej na stronie nr. 20
Fig. 22 Searing Side Burner B 1. If you have already attempted to light the searing side burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. 2. Insert a match into the lighting rod (A) as shown in fig.22. Ignite the match and insert through the cooking grids (B) to the burner. 3. Press the control knob and rotes to the “HI” setting, continue A to press the knob until the burner ignites. The burner should light immediately. 4. If the burn
