Streszczenie treści zawartej na stronie nr. 1
Outdoor Gas Barbeque/Grill
Assembly manual and Use and Care
MODEL
FG50057
! WARNING! DANGER!
!
IF YOU SMELL GAS:
Hazardous Fire or Explosion may result
1. Shut off gas supply to the appliance.
2. Extinguish any open flame.
if these instructions are ignored.
3. Open lid.
It is your responsibility to see that your new
4. If odor continues, keep away from the
barbeque is assembled, installed, maintained
appliance and immediately call your gas
and cared for properly. Failing to carefully supplier or
Streszczenie treści zawartej na stronie nr. 2
Please retain this manual for the lifetime of your THANK YOU FOR barbeque after recording the serial and model number in the appropriate space allocated on the PURCHASING THIS BARBEQUE front cover. We are dedicated to creating the ultimate • The serial number can be found on the silver barbeque experience by providing you with rating plate located on left side of the barbeque base all the right tools, starting with this manual. or the back of the centre beam. Serial numbers are 8 digits long e
Streszczenie treści zawartej na stronie nr. 3
GETTING FAMILIAR WITH YOUR BARBEQUE FAILURE TO ENSURE THE ABOVE MAY RESULT Fig. 1 ! IN A HAZARDOUS FIRE OR EXPLOSION 10mm CASTING CAUSING SERIOUS BODILY INJURY WARNING AND/OR PROPERTY DAMAGE. BEFORE YOU USE THIS APPLIANCE • Your barbeque is properly assembled. • There are no leaks in the gas supply system (see L 'eak Testing section). • The burner is properly assembled with the venturi tubes seated VENTURI over the valve outlets (Figure 1 below) and there are no blockages VALVE TUBE present in
Streszczenie treści zawartej na stronie nr. 4
CARING FOR YOUR EQUIPMENT PROVIDING POWER TO YOUR BARBEQUE ELECTRICAL CAUTION To provide power to the barbecue, plug grounded electrical cord into • If any accessory installed on this barbeque requires an external electrical rear electrical box as shown. (Fig.15) power source, it must be electrically grounded in accordance with local laws or in the absence of local laws, with the Canadian Electrical Code Plug electrical cord into properly grounded CSA C22.1 or in the U.S., with the National E
Streszczenie treści zawartej na stronie nr. 5
TRANSPORTATION AND STORAGE: Although it is safe when used properly, ! careless handling of the propane gas cylinder could result in fire, explosion, and/or serious WARNING injury. PROPANE GAS IS HEAVIER THAN AIR, AND WILL COLLECT IN LOW AREAS, INCREASING THE ABOVE RISKS. THEREFORE: • ALWAYS use the cylinder cap provided with your cylinder whenever the cylinder is not connected to your barbeque. (Figure 4) • DO NOT store in a building, garage or any other enclosed area. Store in a well-ventila
Streszczenie treści zawartej na stronie nr. 6
NOTE: IMPROPER LIGHTING PROCEDURES CAN CAUSE THE FLOW CONTROL TO ACTIVATE, RESULTING IN REDUCED HEAT OUTPUT. IF THIS IS SUSPECTED, RESET THE FLOW CONTROL BY SHUTTING OFF ALL BURNER CONTROLS AND THE CYLINDER VALVE. WAIT 30 SECONDS, THEN TURN THE CYLINDER VALVE HOSE & REGULATOR ON EXTREMELY SLOWLY - WAIT 5 SECONDS AND TURN THE BURNER VALVE ON AND LIGHT AS NORMAL. WARNING: INDICATES AN POTENTIALLY ! HAZARDOUS SITUATION WHICH, IF NOT AVOIDED, • Never connect a propane gas barbeque to an unregulated
Streszczenie treści zawartej na stronie nr. 7
CLEANING & MAINTENANCE To keep your barbeque working at its peak efficiency HOW TO DO THE TESTING: 1. With the barbeque console control knobs in the ‘OFF’ position, twist the valve as well as contribute to the safe operation of this on your propane cylinder 1 turn, or the main natural gas valve on. unit, perform all of the operations below at least DO NOT IGNITE THE BURNERS WHILE PERFORMING THE LEAK CHECK. once a year -- preferably at the start of each cooking 2. Brush your soap and water soluti
Streszczenie treści zawartej na stronie nr. 8
CASTING INTERIOR AND WARMING RACK: CLEANING OTHER PARTS OF At least once a year remove all components from inside your barbeque. Loosen any cooking residue with a scraping tool for large particles and a YOUR APPLIANCE brass barbeque brush for smaller particles. Scrub with hot water and a General Grill Cleaning: Do not mistake brown or black accumulation strong detergent, then rinse thoroughly or spray barbeque degreaser liberally of grease and smoke for paint. Interiors of gas grills are not pai
Streszczenie treści zawartej na stronie nr. 9
USING YOUR APPLIANCE CORRECTLY Fig. 9A WARNING: ENSURE SIDE BURNER LID IS UP BEFORE LIGHTING SIDE BURNER. *INTERNAL LIGHT LEFT BURNER *ROTISSERIE BURNER CENTER BURNER IGNITOR MODEL MAY NOT BE EXACTLY AS SHOWN. *SIDE BURNER *PARTS OPTIONAL (READ WARNING) DEPENDING ON MODEL PURCHASED RIGHT BURNER GETTING FAMILIAR DO NOT LIGHT SIDE BURNER WITH LID DOWN. ! FAILURE TO DO SO MAY CAUSE SERIOUS BODILY WITH THE CONTROLS WARNING INJURY AND/OR PROPERTY DAMAGE. Prior to lighting your barbeque, ensure you b
Streszczenie treści zawartej na stronie nr. 10
IF LIGHTING MAIN BURNERS ONLY, LIGHTING ! Prior to lighting your barbeque,visually check all hoses before each ENSURE SIDE BURNER KNOB IS IN THE OFF use for nicks, cracking, abrasions or cuts. If the hose is found to be CAUTION POSITION. damaged in any way, DO NOT USE YOUR BARBEQUE . A replacement hose and regulator is required (see ‘ PARTS LIST ’ in Assembly Brochure). IMPORTANT HIGH • Always raise the barbeque lid before lighting. • Do not lean over the barbeque when lighting the burner. L
Streszczenie treści zawartej na stronie nr. 11
SIDE BURNER (OPTIONAL) USING THE IGNITOR 1. Raise side burner lid. 2. Push in and turn the side burner control knob to 'HIGH'. 3. Depress ignitor. Repeat if necessary (see Figure 12A). 4. If burner does not light immediately (within five 3. seconds), turn the burner control knob off, and wait 5 minutes to clear the gas. 5. Repeat steps 1 to 4. If burner still fails to light, refer to the Troubleshooting Guide to determine cause and 2. solution, or try the match lighting procedure below. 1. D
Streszczenie treści zawartej na stronie nr. 12
Fig. 12C REAR ROTISSERIE 1. (OPTIONAL) BURNER USING THE IGNITOR 1. Open the lid before lighting. 2. Push in and turn the rotisserie control knob to 'HIGH'. 3. Depress ignitor. Repeat if necessary (see Figure 12C). 4. If burner does not light immediately (within five seconds), turn the burner control knob off, and wait 5 minutes to clear the gas. 5. Repeat steps 1 to 4. If burner still fails to light, refer to the 2. Troubleshooting Guide to determine cause and solution, or try the match light
Streszczenie treści zawartej na stronie nr. 13
Use of a Rotisserie motor is one of the fastest growing barbeque COOKING TECHNIQUES cooking techniques, especially if your barbeque is equipped with a rear rotisserie burner. Just imagine, cooking restaurant style PREHEATING THE BARBEQUE rotisserie meat in your own backyard! Rotisserie cooking allows the The cooking system and grids require heating prior to adding food. food to self-baste while turning on the motorized spit, sealing in the 1.Light your barbeque as outlined in the ‘LIGHTING’ inst
Streszczenie treści zawartej na stronie nr. 14
PROVIDING POWER TO YOUR BARBEQUE To provide power to the barbecue, plug grounded electrical cord into rear electrical box as shown. (Fig.15) Plug electrical cord into properly grounded GFI (Ground Fault Interrupt) receptacle. If use of an extension cord is required, be sure that it is a minimum 16 AWG, TRANSFORMER BOX 3 wire well insulated cord, marked for OUTDOOR USE ONLY and properly Fig. 14 grounded. (Fig.14) CAUTION: To ensure continued protection against risk of electric shock, connect
Streszczenie treści zawartej na stronie nr. 15
TROUBLE SHOOTING GUIDE PROBLEM POSSIBLE CAUSES CORRECTION Burner Will Not Light (match or ignitor) • Blocked venturi tubes • Clean out blockage (Page 5) or Burners Not Hot Enough • Cylinder or gas supply valve turned off • Open cylinder or gas supply valve • Venturi tubes not properly seated over valve • Ensure proper venturi assembly (Page 2) orifices • Clean/replace burner (Page 5) • Burner ports blocked PROPANE BARBEQUES ONLY • Refill cylinder • Low or out of propane • Follow correct lighting
Streszczenie treści zawartej na stronie nr. 16
7 YEAR PLATINUM LIMITED WARRANTY 1. LIMITED WARRANTY COVERAGE Blue Ember gas barbeque owners have the benefit of a Platinum limited warranty from the date of purchase against any and all defects in materials and workmanship during the period of warranty coverage specified. This limited warranty is extended to the original customer/purchaser only and is not transferable. Your Fiesta / Blue Ember barbeque (and related equipment) have been certified for use in by the applicable certifying authoriti
Streszczenie treści zawartej na stronie nr. 17
WHEEL ASSEMBLY FIG.1 NOTE: Assembled Some grill parts shown in the assembly steps View may differ slightly in appearance from those on your particular grill model. However, the method of assembly remains the same. TOOLS REQUIRED: • Extra Common Nuts & Bolts are supplied. • Refer to diagrams to assemble your grill. • Attach wheels to bottom of base as shown. 17
Streszczenie treści zawartej na stronie nr. 18
BASE CABINET ASSEMBLY • Attach Cabinet side panels to base as shown. Assembled NOTE: Right panel has two holes located on View the top right corner for bottle opener. • Attach bottle opener to right panel as shown. SP53-16 (2) 1/4-20 NUT HEX HD FLANGED Right hand Panel SP83-18 (2) 1/4"-20X.50" CARRIAGE BOLT SP84-18 (8) 1/4-20 X .5 HEX HD BOLT SP83-18 (2) 1/4"-20X.50" CARRIAGE BOLT SP53-16 (2) 1/4-20 NUT HEX HD FLANGED SP84-18 (8) FIG.2 1/4-20 X .5 HEX HD BOLT 18
Streszczenie treści zawartej na stronie nr. 19
REAR PANEL ASSEMBLY • Attach rear panel by sliding notches over screws on side panels as shown. Tighten screws. • Install Electrical box with Screws and Nuts as shown. Ensure Electrical box is installed so outlet covers open upwards. • Install Transformer box into rear panel holes as shown. Assembled View INSTALL SO OUTLET COVERS OPEN UPWARDS SP54-21 (2) #10-24 SCREW SP43-16 (2) #10-24 NUT TRANSFORMER BOX SP46-21 (4) 1/4" X1/2" SCREW HEX HD SP84-18 (2) 1/4-20 X .5 HEX HD BOLT FIG.3 SP46-21
Streszczenie treści zawartej na stronie nr. 20
TRIM PANEL ASSEMBLY • Attach top trim panel as shown. Tighten screws. Assembled View SP53-16 (4) 1/4-20 NUT HEX HD FLANGED SP83-18 (4) 1/4"-20X.50" CARRIAGE BOLT SP53-16 (4) 1/4-20 NUT HEX HD FLANGED FIG.4 SP83-18 (4) 1/4"-20 X .50" CARRIAGE BOLT 20
