Instrukcja obsługi Holland XL-FW208-06

Streszczenie treści zawartej na stronie nr. 1

MAINTENANCE
STATIONARY
®
INSTRUCTIONS
KOMPENSA TOR
®
Stationary Kompensator for
FW8-77XX Series
FW35-77XX Series
FW7040-77XX Series
FW2040-77XX Series (obsolete)
FW3540-77XX Series (obsolete)
MAINTENANCE PROCEDURES
Failure to read, understand and follow the important information contained herein may
result in a hazardous condition or cause a hazardous condition to develop.
All maintenance must be performed by a qualified person using proper tools and safe
procedures.
All maintenance must be per

Streszczenie treści zawartej na stronie nr. 2

AS-NEEDED LUBRICATION FIGURE 2 The following should be performed before putting into Check for warn, bent, or broken use and then at least once per week or more parts. Replace with frequently as required by operating conditions. Holland parts only. Perform the following steps while in the uncoupled condition to allow correct application of lubricant. While lifting up on the fifth wheel top plate, apply grease to the: Check for cracked, 1. ...fittings on the fifth wheel top plate (see broken, or

Streszczenie treści zawartej na stronie nr. 3

Add shims (ITEM 11) and/or new bearing If disassembly is required, follow the plates (ITEM 12 or ITEM 13) when this steps below: 1 16 movement exceeds 0.060˝ ( / ˝). See Figures 1. Remove the fifth wheel top plate from 3 through 6. the Kompensator base removing the appropriate roll pins and bracket FIGURE 5 FIGURE 6 pins or cotter pins, nuts and bolts, BEARING PLATE depending upon model. SHIM 2. Remove all loose internal parts (shoes, tie rod, etc.). 3. Inspect all parts for distortion, wear a

Streszczenie treści zawartej na stronie nr. 4

Parts Breakdown 20 9 21 9 10 9 10 11 10 11 13 12 3 3 4* or 4A** 5 5 6 6 7 8 7 2 4* or 4A** 2 14 15 15 RK-01370 KIT – OPTIONAL 18 LOCKOUT PARTS 14 (BOTH SIDES) 15 15 19 17 1 16 ITEM PART NO. NO. PART NAME ITEM PART NO. NO. PART NAME ® 1 XA-45-77XX 1 Kompensator Frame 11 XA-0014 2 Shim (as required) 2 XA-0024 2 Shoes Subassembly – includes part no. (3) 12 XA-01997 1 Bearing Plate – Right Hand 3 XB-H-38-F 2 Grease Fitting 13 XA-01998 1 Bearing Plate – Left Hand 4* XB-0011 2 Rubber Cushion 14 XB-H-3