Instrukcja obsługi Edelbrock PERFORMER-PLUS 2182

Streszczenie treści zawartej na stronie nr. 1

PERFORMER-PLUS
Camshaft/Lifters/Lube Kit
®
CATALOG #2182
MODEL: 351-Windsor Ford V8
• PLEASE study these instructions carefully before installing your new camshaft. If you have any questions or problems, do not hesitate to call our
Technical Hotline at: 1-800-416-8628.
� CAMSHAFT: Edelbrock Performer-Plus camshafts are ground specifically for use with the corresponding Performer manifold. The Performer
manifold #2181 or #3781, and Performer-Plus camshaft #2182, are designed to work as a team t

Streszczenie treści zawartej na stronie nr. 2

12. Disconnect fuel pump outlet line from fuel pump; remove fuel pump. � VALVE ADJUSTMENT Remove front cover bolts and cut oil pan gasket flush with cylinder 1. Turn the engine over block. Remove front cover and water pump as an assembly. until the No. 1 cylinder NOTE: The front cover oil seal should be replaced before the front exhaust lifter starts to cover is re-installed. move up. At this point 13. Rotate engine until timing marks are aligned as shown in install pushrod and Figure 1. adjusti

Streszczenie treści zawartej na stronie nr. 3

� CAMSHAFT/LIFTER RUN-IN � SPECIAL INSTRUCTION CAUTION: Change the engine oil and filter before start-up and again With the Edelbrock manifold and camshaft package plus a header after break-in. Do not allow the engine to run under 2500 rpm for the installation, a carburetor jet change may be required for best first 1/2 hour. Vary engine speed between 2500 and 3000 rpm. Slow performance. Due to the varied applications of year and model of idle speeds will result in severe cam and lifter wear. St

Streszczenie treści zawartej na stronie nr. 4

CAMSHAFT: Performer-Plus Hydraulic CAMSHAFT: Performer-Plus Hydraulic ® ® CATALOG #2182 CATALOG #2182 ENGINE: Ford 351-Windsor V8 ENGINE: Ford 351-Windsor V8 RPM RANGE: Idle-5500 RPM RANGE: Idle-5500 CAUTION: Do not use dual valve springs. CAUTION: Do not use dual valve springs. Use only recommended stock or Edelbrock Sure Seat Valve Springs Use only recommended stock or Edelbrock Sure Seat Valve Springs #5882 or #5982 #5882 or #5982 Use stock ratio rocker arms only. Use stock ratio rocker arms