Instrukcja obsługi Edelbrock Honda XR250R

Streszczenie treści zawartej na stronie nr. 1

INSTRUCTION SUPPLEMENT FOR

1. Install the throttle cables into the
1996-2004 HONDA XR250R
supplied throttle housing and place

onto clean handlebar end.

2. Remove the rubber carburetor
Removing stock carburetor and cables
alignment tabs from the manifold using

a razor blade or sharp cutters. This

should be done with the rag left in the
1. Remove seat and gas tank. Make
manifold. Be very careful not to
sure fuel petcock is in “off” position.
damage the manifold or your h

Streszczenie treści zawartej na stronie nr. 2

9. Adjust pull cable until wide-open throttle any more than 5 times as throttle is achieved. Adjust return this may flood engine!! cable to take up the slack. Note: 17. Once pump is primed, get motor to When throttle cables are adjusted TDC and kick through without properly, there should be approx. opening throttle. If Motor will not 1/8” of free play in the throttle. fire with a few kicks, open idle cable 10. After throttle cables have been ½ turn and repeat starting process. adjuste