Instrukcja obsługi Edelbrock CARBURETORS 1407

Streszczenie treści zawartej na stronie nr. 1

EDELBROCK PERFORMER SERIES CARBURETORS
®
Part #1403, 1404, 1405, 1406, 1407, 1409, 1410, 1411, 1412 & 1413
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and
procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing this installation,
it is recommended to have the installation completed by a qualified mechanic.

Streszczenie treści zawartej na stronie nr. 2

FUEL INLET for 3/8” hose (Except marine IDLE MIXTURE SCREWS models #1409 & #1410 which use a 3/8” Left screw for left side of carb inverted flare fitting) Right screw for right side of carb MARINE FUEL PUMP VENT (Not shown. #1409 & #1410 ONLY) CANISTER VAPOR VENT (#1400 Only) POWER BRAKE PORT (Except Marine Models) Rear Lower Side, 1/4 NPT IF NOT IN USE, MUST BE PLUGGED WITH 1/4 NPT PIPE PLUG (SUPPLIED) IDLE SPEED SCREW PART NUMBER STAMPING 3/16” TIMED VACUUM PCV PORT 3/16” MANIFOLD VACUUM (Exce

Streszczenie treści zawartej na stronie nr. 3

6. Do not use more than 6.5 PSI fuel pressure. Excessive fuel 9. Remove carburetor, being careful not to spill any dirt into the intake pressure may cause flooding. If your fuel pressure is too high, install manifold. Immediately place a clean rag into the intake manifold to an adjustable pressure regulator, such as Edelbrock #8190. keep foreign objects out. 7. It may be necessary to re-route the fuel line to prevent interference 10. Remove old mounting gasket and thoroughly clean mounting with

Streszczenie treści zawartej na stronie nr. 4

3. Replace all mounting nuts and washers. EnduraShine™ finish 8. Edelbrock idle compensator #8059 may be installed to raise idle carburetors should use the supplied 5/16” flat washers under any speed during air conditioning compressor operation. other washers used. Hand tighten with a short box-end wrench, 9. Install new air horn gasket and air cleaner stud (supplied). Install air alternating between diagonally opposed nuts. cleaner, making sure it does not contact the carburetor linkage or CAUT