Instrukcja obsługi Edelbrock 770769

Streszczenie treści zawartej na stronie nr. 1

GLIDDEN VICTOR SC-1 CYLINDER HEADS
®
For Ford Windsor Engines
Catalog #770769
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and
procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing this installation,
it is recommended to have the installation completed by a qualified mechanic. If you have any questions,

Streszczenie treści zawartej na stronie nr. 2

ACCESSORIES We highly recommend that premium quality hardware be used with your new heads. � HEAD BOLTS OR STUDS: High quality 1/2” head studs or head � EXHAUST HEADERS: Any header designed for Yates heads will fit bolts with hardened washers must be used to prevent galling of the the Edelbrock Glidden Victor SC-1 cylinder head. Fel-Pro exhaust aluminum bolt bosses. The head bolt boss heights and required bolt gaskets #1433 or equivalent are recommended. Check in-car lengths are listed in the “S

Streszczenie treści zawartej na stronie nr. 3

Early production heads will need to be drilled at these locations if the auxiliary head bolt provisions are to be used. Later model heads have these holes pre-drilled, and must use the supplied plugs 3 9 1 7 5 10 2 4 8 6 FIGURE 1 - CONVENTIONAL TEN (10) BOLT TORQUE SEQUENCE Bolts should be tightened to 100-110 ft/lbs in three intermediate steps. Applications using the eight (8) auxiliary bolt provisions should consult their engine block manufacturers instructions for the correct torque sequence.