Instrukcja obsługi Dynabrade 13411 3

Streszczenie treści zawartej na stronie nr. 1

Parts Page Reorder No. PD01•40
Effective April, 2001
Supersedes PD98•17
Models:
13400 – 3,400 RPM .7 Hp Dynisher
13410 – 3,400 Versatility Kit
13411 – 3,400 Versatility Kit Air Motor and Machine Parts
Always operate, inspect and maintain this tool in accordance with the Safety Code for portable air
tools (ANSI B186.1) and any other applicable safety codes and regulations. Please refer to
!
WARNING
Dynabrade’s Warning/Safety Operating Instructions for more complete safety information.
1
Index Key

Streszczenie treści zawartej na stronie nr. 2

Important Operating, Maintenance and Safety Instructions ® Carefully read all instructions before operating or servicing any Dynabrade Abrasive Power Tool. Warning: Hand, wrist and arm injury may result from repetitive work motion and overexposure to vibration. Important: All Dynabrade rotary vane air tools must be used with a Filter-Regulator-Lubricator to maintain all warranties. Operating Instructions: Warning: Eye, face, respiratory, sound and body protection must be worn while operating pow

Streszczenie treści zawartej na stronie nr. 3

Disassembly/Assembly Instructions - Dynisher Important: Manufacturer’s warranty is void if tool is disassembled before warranty expires. Please refer to parts breakdown for part identification. Motor Disassembly: 1. Disconnect tool from power source. Remove pneumatic wheel or accessory from spindle. 2. Loosen 01678 Lock Screw and remove handle assembly. Remove flange and spacer from motor shaft. 3. Secure motor housing using padded vise with motor spindle facing upwards. 4. Using an adjustable p

Streszczenie treści zawartej na stronie nr. 4

Disassembly/Assembly Instructions (continued) 7. Slip 94523 Inlet Adapter through muffler assembly and install 95711 Retainer Ring into groove on inlet adapter. 8. Install 01565 Air Control Ring into housing. ® 9. Apply Loctite #567 to threads of 94523 Inlet Adapter and install entire muffler assembly onto housing inlet (torque 23.0 N•m/200 in. - lbs.). 10. Replace air fitting. Secure inlet adapter with a wrench before tightening air fitting. 11. Install throttle lever and 01017 Pin. Tool Assemb