Instrukcja obsługi PYLE Audio PWLB008

Streszczenie treści zawartej na stronie nr. 1

Monitor Monitor Plate Plate Attachment Attachment
If the monitor is VESA compliant, bolt the Monitor Plate directly to the monitor,
as described in Step 3.
If the monitor is not VESA compliant, bolt the Monitor Plate to the Adaptor
Plate (sold separately) using the following mounting pattern (fig. 6):
Caution: Caution: Never force screws into the monitor, as damage may occur. NEVER
use an electric drill to secure screws.
Complete the installation as per Steps 4 & 5.
Fig. 6
A
Flat Panel Fixed Mou

Streszczenie treści zawartej na stronie nr. 2

Parts: Optional Optional Installations Installations Qty Description Letter In addition to being used as a flat panel wall mount, the mount can also be used in conjunction with other products. 1 1 Monitor Plate 1 2 1 Wall Plate When used between a Cantilever and a flat panel display, this mount 3 2 Safety bolt creates a quick disconnect mount. 2 A 4 M4X12 bolt W Wa all ll Plate Plate Attachment Attachment B 4 M4X25 bolt Install the Wall Plate onto the other product using one of the following C 4

Streszczenie treści zawartej na stronie nr. 3

Step Step 1 1 Determine Determine the the d desir esired ed location location for for t the he monitor monitor.. I Note: Note: When mounting to wooden studs, the Wall Plate can be offset up to 2” in either direction from stud center (+/-2”) by utilizing the offset mounting holes. ( Fig. 1) GH , Important: Important: Make sure there is adequate mounting space available for the monitor, considering the monitor dimensions. The mount is supplied with the necessary hardware for either Wooden Stud Mou

Streszczenie treści zawartej na stronie nr. 4

Step Step 2 2 Step Step 3 3 W Wooden ooden Stud Stud Mounting Mounting This mount Monitor Plate is VESA compliant, and supports the following VESA Patterns ( Fig. 3): Using an electronic stud finder, locate the center of the wooden stud. Position the Wall Plate (2) in desired mounting location over stud. A: VESA 75 (75mm x 75mm) Level the Wall Plate, and then using the Wall Plate as a template, mark B: VESA 100 (100mm x 100mm) mounting hole locations over the center of the stud. C: VESA 200 (100