Instrukcja obsługi Audiovox CMOLF

Streszczenie treści zawartej na stronie nr. 1

Model CMOLF
License Plate Rearview Camera
with Selectable Normal/Reverse Image
CMOLF FEATURES:
• Built Into License Plate Frame
• High Resolution, 1/4” CMOS Color Camera
• Compact Zinc Alloy Die Cast Body
• Waterproof Housing
• Waterproof Microphone
O
• 130 Wide Angle View
• Selectable Normal/Reverse Image
1
128-8104
1 of 8

Streszczenie treści zawartej na stronie nr. 2

CONTENTS ITEM FIGURE QUANTITY LICENSE PLATE WITH 1 CAMERA CAMERA ANGLE 1 ADJUSTMENT WEDGE THEFT-PROOF SCREWS 2 THEFT-PROOF SCREWS 2 FUSE (1A) 1 CAMERA MOUNTING BOLT 2 ANTI-THEFT ALLEN KEY 1 EXTENSION CABLE 1 2 128-8104 2 of 8

Streszczenie treści zawartej na stronie nr. 3

Color Camera View: Cable Connector End View: Normal/Reverse Image Jumper: The jumper is located at the camera cable connector. With jumper installed in the harness, the camera image will be normal. When the jumper is removed from the harness, the camera image will be reversed. 3 128-8104 3 of 8

Streszczenie treści zawartej na stronie nr. 4

Installation. 1. Locate suitable location near the vehicles rear license plate to route the camera cable. The camera cable can be routed through an existing grommet or use a location where a 5/8” hole can be drilled. Be sure to check behind intended drilling location. Check for camera interference with license plate lights, hatch release switch and/or mechanism. 2. Remove the screws holding the rear license plate to the vehicle and remove plate. 3. Place the license plate into the camera license

Streszczenie treści zawartej na stronie nr. 5

5. Connect the Camera cable to the extension cable (supplied). Route the extension cable up to the intended monitor. Connect as follows: a. Black wire- connect to chassis ground b. Red wire- connect to 12V accessory wire c. Yellow RCA- connect to Video input d. Red RCA- connect to audio input (if equipped) 6. Disregard step 5 if connecting to Audiovox 4-pin camera cable. View angle adjustment: This camera frame is designed for universal application. The angle of the image of the installed frame

Streszczenie treści zawartej na stronie nr. 6

Camera Installation 1. LICENSE PLATE 2. CAMERA ANGLE ADJUSTMENT WEDGE 3. CAMERA 6 128-8104 6 of 8

Streszczenie treści zawartej na stronie nr. 7

Specifications: 1. Power source : DC12V 2. Current: 50mA 3. Signal System: NTSC. 4. Image Device : 1/4” CMOS Sensor. 5. Horizontal Resolution: 420 lines. 6. Video Output:1.0Vp-p Composite (75 ohm load). 7. Minimum Illumination: 0.3LUX 8. Image Display: Normal or Reverse (Selectable). 9. Wide Angle View : Diagonal 150° (natural state lens declination 40 degrees) 10. Camera Outer Dimensions: 25mm(w) x 30mm(H) x 62mm(D) 7 128-8104 7 of 8

Streszczenie treści zawartej na stronie nr. 8

© 2006 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-8104 8 128-8104 8 of 8