Instrukcja obsługi NEC PlasmaSync PX-42XM2A/S

Streszczenie treści zawartej na stronie nr. 1

PlasmaSync Plasma Monitor
Model Information
For the operation of your plasma monitor,
refer to “Operation Manual”.
NEC Solutions (America), Inc.

Streszczenie treści zawartej na stronie nr. 2

IMPORTANT SAFETY INSTRUCTIONS (42XM2A/S) Read before operating equipment 1. Read these instructions. 17. Tilt/Stability - All televisions must comply with 2. Keep these instructions. recommended international global safety standards for 3. Heed all warnings. tilt and stability properties of its cabinets design. 4. Follow all instructions. • Do not compromise these design standards by 5. Do not use this apparatus near water. applying excessive pull force to the front, or top, of 6. Clean only wit

Streszczenie treści zawartej na stronie nr. 3

PRÉCAUTIONS IMPORTANTES DE SÉCURITÉ (42XM2A/S) A lire avant de faire fonctionner l’appareil 1. Lire ces instructions. 17. Tous les téléviseurs doivent être conformes aux normes 2. Garder ces instructions. inter-nationales de sécurité préconisées pour les 3. Respecter tous les avertissements. propriétés de sta-bilité et d’inclinaison dans la conception 4. Suivre toutes les instructions. des meubles. 5. Ne pas utiliser cet appareil près de l’eau. • Ne pas compromettre ces normes de conception en 6

Streszczenie treści zawartej na stronie nr. 4

Important Information Warning NOTE: Not for use in a computer room as defined in the Standard When you connect a computer to this monitor, use an RGB for the Protection of Electronic Computer/ Data Processing cable including the ferrite core on both ends of the cable. Equipment ANSI/NFPA 75. And regarding DVI and power cable, attach the supplied ferrite cores. If you do not do this, this monitor will not Models: PX-42XM2A conform to mandatory FCC standards. This equipment has been tested and fo

Streszczenie treści zawartej na stronie nr. 5

Recommandations importantes Avertissement Attention Ne pas utiliser dans une salle d’ordinateurs telle que définie Le 42XM2A/S est destiné à être utilisé uniquement avec les dans la Norme pour la protection des ordinateurs unités optionnelles suivantes. Toute utilisation avec d’autres électroniques/appareils de traitement des données ANSI/ unités optionnelles peut entraîner l’instabilité du placement. NFPA75. Nom du fabricant: NEC Plasma Display Corporation Support: PX-ST1U,PX-ST1U/S,PX-42VM1U-S

Streszczenie treści zawartej na stronie nr. 6

Specifications Screen Size 36.1"(H)
20.4"(V) inches 918(H)
518(V) mm 1.38" diagonal 42" 2.13" (35) 40" (1018) (54) Aspect Ratio 16 : 9 Resolution 1024(H)
768(V) pixels 36.1" (918) Pixel Pitch 0.036"(H)
0.027"(V) inches 0.897(H)
0.675(V) mm Color Reproduction 256 levels, 16,770,000 colors Signals Synchronization Range Horizontal : 15.5 to 110 kHz (automatic : step scan) Vertical : 50.0 to 120.0 Hz (automatic : step scan) 3.5" (89) Input Signals RGB, NTSC (3.58/4.43), PAL (B,G,M,N), 1 1 1 42XM2A:

Streszczenie treści zawartej na stronie nr. 7

Table of Signals Supported Supported resolution 2, 4 • When the screen mode is NORMAL, each signal is converted to a 768 dots
768 lines signal. (Except for * * ) • When the screen mode is FULL, each signal is converted to a 1024 dots
768 lines signal. Computer input signals supported by this system Sync Polarity Presence Screen mode Vertical Horizontal RGB Dots
lines Model 5 Memory frequency frequency Horizontal Vertical Horizontal Vertical NORMAL FULL select* DVI Signal Type (Hz) (kHz)

Streszczenie treści zawartej na stronie nr. 8

*1 Only when using a graphic accelerator board that is capable of displaying 852
480. *2 Display only 640 lines with the screen center of the vertical orientation located at the center. *3 The picture is displayed in the original resolution. The picture will be compressed for other signals. *4 Aspect ratio is 5:4. This signal is converted to a 720 dots
768 lines signal. *5 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, se