Streszczenie treści zawartej na stronie nr. 1
22" LCD TV
DX-LCD22-09
USER GUIDE
Streszczenie treści zawartej na stronie nr. 2
2 Contents Dynex DX-LCD22-09 22" LCD TV Contents Important safety instructions........................................................................................................................................................4 TV components .............................................................................................................................................................................6 Front..........................................................................
Streszczenie treści zawartej na stronie nr. 3
3 Contents f CHILD SAFETY It makes a difference how and where you use your flat panel display As you enjoy your new product, keep these safety tips in mind The issue The home theater entertainment experience is a growing trend, and larger TVs are popular purchases. However, TVs are not always supported on the proper stands or installed according to the manufacturer’s recommendations. We and the consumer electronics industry are committed to making home entertainment enjoyable and safe. TVs
Streszczenie treści zawartej na stronie nr. 4
4 Important safety instructions Heat The unit emits heat when in operation. Do not place any covers or blankets on the unit, this may cause overheating. Do not block ventilation holes, or set up near radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. Do not place in CAUTION:TO REDUCE THE RISK OF direct sunshine. When placing on a shelf leave 10 cm (4 inches) free ELECTRIC SHOCK, DO NOT REMOVE space around the entire unit. COVER (OR BACK). NO USER-
Streszczenie treści zawartej na stronie nr. 5
5 Important safety instructions • If your TV does not operate normally by following the operating Outdoor antenna grounding instructions. Adjust only those controls that are covered by the If an outside antenna or cable system is connected to your TV, make sure operating instructions because incorrect adjustment of other that the antenna or cable system is grounded to provide some controls may result in damage and will often require extensive protection against voltage surges and built-up s
Streszczenie treści zawartej na stronie nr. 6
6 TV components Left side TV components Front 1 2 3 1 2 4 5 # Component Description 1 Power indicator LED Lights green when your TV is turned on. 2Remote control Receives signals from the remote sensor control. Do not block. # Component Description 1 Press to tune to the next higher or CH / next lower channel in the channel list. For information about creating the channel list, see “Memorizing channels” on page 12. In menu mode, press to navigate up or down. 2 VOLUME / Press to increase
Streszczenie treści zawartej na stronie nr. 7
7 TV components Back Remote control 1 2 15 16 3 4 5 6 17 1 2 3 4 5 6 7 7 18 #Jack Description 8 19 1 HDMI/DVI IN Connect an HDMI or DVI device to this jack. To connect an DVI device, 9 20 you need to connect an HDMI-DVI cable and connect an audio cable to 10 the VGA AUDIO IN jack. 2 VGA/AUDIO IN Connect a computer with a VGA cable to this jack. Connect the audio output from a computer or DVI 11 source to the mini jack. 3 VIDEO (composite)/ Connect the composite video output S-VIDEO/AUDIO
Streszczenie treści zawartej na stronie nr. 8
8 Setting up your TV Notes: #Button Description Make sure that you match the + and – symbols on the batteries with the 6 RECALL Press to return to the last TV channel symbols in the battery compartment. viewed. Do not mix different types of batteries or old and new batteries. If you do not intend to use the remote control for an extended period of 7 VOL +/– Press to increase (+) or decrease (-) the volume. time, remove the batteries to prevent leakage. Do not try to recharge non-rechargable b
Streszczenie treści zawartej na stronie nr. 9
9 Setting up your TV An alternate method Connecting an antenna or basic cable If you subscribe to a cable TV service in which basic channels are To connect an antenna or basic cable (no cable box): unscrambled and premium channels require the use of a • Connect one end of a 75 ohm coaxial cable to the antenna or converter/descrambler box, you may want to use a signal splitter and basic cable wall jack, then connect the other end of the cable to an A/B switch box (available from the cable TV
Streszczenie treści zawartej na stronie nr. 10
10 Setting up your TV Connecting a component video device 2 Press INPUT. The Input Source menu opens. Select HDMI, then To connect a component video device: press ENTER to confirm. You can also select HDMI input directly 1 Connect a component video cable to the COMPONENT VIDEO by pressing HDMI. OUT (Y, Cb/Pb, and Cr/Pr) jacks on the component device, then Connecting a camcorder, game, or VCR connect the other end of the cable to the COMPONENT IN jacks To connect a camcorder, game, or VCR: on
Streszczenie treści zawartej na stronie nr. 11
11 Using your TV 2 Connect one end of a mini-plug audio cable to the You can also select the input source directly by pressing TV, AUDIO LINE OUT jack on the computer, then connect the other VIDEO, COMP, or HDMI. end of the cable to the VGA AUDIO IN jack on the back of your 7 Press DISPLAY to display information about the program on the TV. screen. 3 Press INPUT. The Input Source menu opens. • Digital information includes channel number, station name, 4 Select VGA, then press ENTER to confi
Streszczenie treści zawartej na stronie nr. 12
12 Using your TV Memorizing channels 2 Press or to select Channel, then press . The Channel menu opens. This TV is equipped with a channel memory feature which lets you skip channels up or down to the next channel in memory, skipping over unwanted channels. Before selecting channels in this manner, they must be programmed into the TV’s memory. To use this TV with an antenna, set the Air/Cable option to the Air mode. When shipped from the factory, this menu option is in the Cable mode. To
Streszczenie treści zawartej na stronie nr. 13
13 Using your TV In the U.S., the major channel number is usually the same for both 5 Press or to highlight Start to Scan, then press or ENTER analog and digital channels (equal to the NTSC channel number for to begin the automatic channel search. The TV begins existing broadcasters). A minor channel number of zero (0) is used for a memorizing all CATV/CADTV channels available in your area. broadcaster’s analog channel. Skipping unwanted channels For example, if the original NTSC channels f
Streszczenie treści zawartej na stronie nr. 14
14 Using your TV Creating a favorite channels list 3 Press or to select Channel, then press . The Channel To create a favorite channels list: menu opens. 1 Press MENU. The The Picture menu opens. 2 Press or to select Channel, then press . The Channel menu opens. - 4 Press to highlight Channel Label, then press or ENTER. The Channel Label editing screen opens. 5 Press or to select a character, then press or to move the cursor to the next box. 6 Press ENTER to confirm your label, or
Streszczenie treści zawartej na stronie nr. 15
15 Using your TV Receiving MTS/SAP broadcasts Option Description Your TV can receive MTS stereo programs and any SAP (Secondary Audio Tint Lets you adjust the image tint. Program) that accompanies those programs, if the station transmits Sharpness Lets you adjust the image sharpness. them. To receive MTS/SAP broadcasts: Color Mode (color Lets you select a preset color mode: •Press MTS/SAP to cycle through the available stereo modes. temperature) • Warm—Enhances red tones • Cool—Enhances blue
Streszczenie treści zawartej na stronie nr. 16
16 Using your TV 4 Press or to highlight an option, then press or to Option Description change that option. You can also press or ENTER to access the Noise Reduction Lets you select a preset noise reduction setting Option sub-menu. Available options include: to reduce snow in the picture. Options include: •Weak •Middle Option Description •Strong CC Mode Lets you select the closed caption mode. Settings •Off include: Advanced Lets you access a sub-menu where you can select • On—Turns cl
Streszczenie treści zawartej na stronie nr. 17
17 Using your TV 2 Press or to select Time, then press . The Time menu Setting up parental controls opens. Your TV is equipped with a parental lock feature, which lets parents control the TV programs that their children are permitted to watch. The parental lock reads the ratings for the programs that your TV receives (except for news, sports, unedited movies on premium channels, and Emergency System signals), then blocks programs that exceed the limits that you set. To use parental contro
Streszczenie treści zawartej na stronie nr. 18
18 Using your TV 4 Press or to highlight Change Password, then press or 4 Press or to highlight System Lock, then press or to ENTER. The Change Password menu opens. change the setting to On. To set the rating and to enable the rating you set up, you should set the System Lock to On. To disable parental controls, turn this setting to Off. 5 Press MENU to return to the previous menu or EXIT to resume normal viewing. To set parental control rating levels: 1 Press MENU. The Picture menu o
Streszczenie treści zawartej na stronie nr. 19
19 Using your TV 6 Press , , , or to navigate to the rating you want to set, Canadian French ratings then press ENTER to change the setting. A lock icon on the rating indicates that the rating is blocked. No icon indicates that the Rating Description rating is not blocked. G General audiences Age-based TV ratings 8ans+ Children 8 years and above Use these rating guidelines to prevent your children from watching certain TV programs, based on the rating limits set. 13ans+ Children 13 years an
Streszczenie treści zawartej na stronie nr. 20
20 Assembling the stand and removing the stand column Adjusting advanced VGA settings Assembling the stand and To change the advanced VGA settings: 1 Press MENU. The Picture menu opens. removing the stand column You must install your TV into the stand in order for it to stand upright on a cabinet or other flat surface. If you intend to mount your TV on a wall or other vertical surface, you must remove the stand column. Cautions: Read these instructions thoroughly before attempting this instal
