Streszczenie treści zawartej na stronie nr. 1
SyncMaster 753DFX / 755DFX / 753DF / 755DF
Streszczenie treści zawartej na stronie nr. 2
2 User’s Manual Index Main Page On-Screen Display Safety Instructions Troubleshooting Power Check List Installation Q & A Cleaning Self-Test Feature Check Other Specifications Introduction General Specifications Unpacking Preset Display Modes Front PowerSaver Rear Bottom Setup Information Connecting Your Monitor Service Installing the Video Driver Terms Regulatory Windows 2000 Authority Other Operating System Tilt/Swivel Base Installation
Streszczenie treści zawartej na stronie nr. 3
3 User’s Manual Safety Instructions Warning / Caution Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Notational Conventions Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric shock
Streszczenie treści zawartej na stronie nr. 4
4 User’s Manual Safety Instructions Power When not used for extended periods of time, set your PC to DPMS. If using a screen saver, set it to the active screen mode. If the size of your monitor is small, or if the same image is present for long periods of time, you may see afterimages due to damage to the flourescent substance on the inside of the CDT. Do not use a damaged or loose plug. This may cause an electric shock or fire. Do not pull the plug out by the wire nor touch the plug wit
Streszczenie treści zawartej na stronie nr. 5
5 User’s Manual Safety Instructions Disconnect the plug from the outlet during storms or lightening or if it is not used for a long period of time. Failure to do so may cause an electric shock or fire. Do not connect too many extension cords or plugs to an outlet. This may cause a fire.
Streszczenie treści zawartej na stronie nr. 6
6 User’s Manual Safety Instructions Installation Do not cover the vents on the monitor cabinet. Bad ventilation may cause a breakdown or fire. Put your monitor in a location with low humidity and a minimum of dust. An electric shock or fire could result inside the monitor. Do not drop the monitor when moving it. This may cause damage to the product or human body. Place the monitor on a flat and stable surface. The monitor can cause injury by falling. Set down the monitor carefully. It
Streszczenie treści zawartej na stronie nr. 7
7 User’s Manual Safety Instructions Cleaning When cleaning the monitor case or the surface of the CDT, wipe with a slightly moistened, soft fabric. Do not clean Flat monitor with water. Use a water-diluted mild detergent. (Some detergents contain significant amounts of alcohol-based solvents, which can damage (color change) or crack the monitor case. The antiglare/anti-static surface coating on the CDT may also be affected.) Dilute the detergent (1:10 ratio) with water before using. Do not s
Streszczenie treści zawartej na stronie nr. 8
8 User’s Manual Safety Instructions Other Do not remove cover(or back). No user serviceable parts inside. This may cause an electric shock or a fire. Refer servicing to qualified service personnel. If your monitor does not operate normally - in particular,if there are any unusual sounds or smells coming from it - unplug it immediately and contact an authorized dealer or service. This may cause an electric shock or a fire. Do not place any heavy objects on the monitor. This
Streszczenie treści zawartej na stronie nr. 9
9 User’s Manual Safety Instructions Do not move the monitor right or left by pulling only the wire or the signal cable. This may cause a breakdown, electric shock or a fire due to damage to the cable. Never insert anything metallic into the monitor openings. This may cause an electric shock, fire or injury. Keep the monitor away from any magnetic substances. This may cause discoloring or distortion of the image.
Streszczenie treści zawartej na stronie nr. 10
10 User’s Manual Introduction Unpacking Monitor and Stand Power Cord Stand Quick Setup Guide (Some models include a stand attached.) Please make sure the following items are included with your monitor. If any items are missing, contact your dealer. Warranty card (Not available in all locations) User's Guide and Driver Installation CD USB Hub(Option)
Streszczenie treści zawartej na stronie nr. 11
11 User’s Manual Introduction Front 1. Exit button : Use this button to Exit the active menu or the OSD. 2,3 Adjust buttons : These buttons allow you to highlight and adjust items in the menu. 4. Menu button : Use this button to open the OSD and activate a highlighted menu item. 5. Power indicator : This light glows green during normal operation, and grows green when you are making adjustments. 6. Power button : Use this button to turn the monitor on and off. Note: See PowerSaver described in
Streszczenie treści zawartej na stronie nr. 12
12 User’s Manual Introduction Rear 1. Power port : Connect the power cord for your monitor to the power port on the back of the monitor. 2.Signal cable :Connect the end of the signal cable to your computer's video port (video board,video card or graphics card). Note See Connecting Your Monitor for further information regarding cable connections. (The configuration at the back of the moniter may vary from product to product.) Bottom 1. Signal cable : Connect the end of the signal cable to y
Streszczenie treści zawartej na stronie nr. 13
13 User’s Manual Setup Connecting Your Monitor 1. Connect the power cord for your monitor to the power port on the back of the monitor. Plug the power cord for the monitor into a nearby outlet. 2. Connect the end of the signal cable to your computer's video port (video board, video card or graphics card). 3. If you are using a Macintosh computer, connect the cable to a Macintosh adapter, and set the pins on your adapter(Adapter not included). A PC-compatible computer does not need an adapter.
Streszczenie treści zawartej na stronie nr. 14
Setup When prompted by the operating system for the monitor driver, insert the CD-ROM included with this monitor. Driver installation is slightly different from one operating system to another. Follow the directions as appropriate for the operating system you have. Prepare a blank disk and download the driver program file at the Internet web site shown here. Internet web site : http://www.samsung-monitor.com/ (Europe) http://www.samsungmonitor.com/ (USA) http://www.sec.co.kr/ (Korea) http:/
Streszczenie treści zawartej na stronie nr. 15
Setup Windows XP/2000 1. Insert CD into the CD-ROM driver. 2. Click "Windows XP/2000 Driver". 3. Choose your monitor model in the model list, then click the "OK" button. 4. Click the "Install" button in the "Warning" window. 5. If you can see following "Message" window, then click the "Continue Anyway" button. Then click "OK" button. This monitor driver is under certifying MS logo,and this installation don't damage your system.The certified driver will be posted on Samsung Monitor Homepage h
Streszczenie treści zawartej na stronie nr. 16
Setup When prompted by the operating system for the monitor driver, insert the CD-ROM included with this monitor. Driver installation is slightly different from one operating system to another. Follow the directions as appropriate for the operating system you have. Prepare a blank disk and download the driver program file at the Internet web site shown here. Internet web site : http://www.samsung-monitor.com/ (Europe) http://www.samsungmonitor.com/ (USA) http://www.sec.co.kr/ (Korea) http:/
Streszczenie treści zawartej na stronie nr. 17
Setup 5. Click "Update Driver.." and select "Install from a list or.." then click "Next" button. 6. Select "Don't search ,I will.." then click "Next" and then click "Have disk". 7. Click the "Browse" button then choose A:(D:\Driver) and choose your monitor model in the model list and click the "Next" button. 8. If you can see following "Message" window, then click the "Continue Anyway" button. Then click "OK" button.
Streszczenie treści zawartej na stronie nr. 18
Setup Thi This monit itor d driiver iis und der certif tifyiing MS MS llogo,and d thi this iinsttall llati tion d don't 't d damage your system.The certified driver will be posted on Samsung Monitor Homepage http://www.samsung-monitor.com/. 9. Click the "Close" button then click "OK" button continually. 10. Monitor driver installation is completed. ® ® Microsoft Windows 2000 Operating System When you can see "Digital Signature Not Found" on your monitor, follow these steps. 1. Choose "OK
Streszczenie treści zawartej na stronie nr. 19
Setup ® ® Microsoft Windows Millennium Operating System 1. Click "Start" , "Setting" , "Control Panel". 2. Double click "Display" icon. 3. Select the "Settings" tab and click "Advanced Properties" button. 4. Select the "Monitor" tab. 5. Click the "Change" button in the "Monitor Type" area. 6. Choose "Specify the location of the driver". 7. Choose "Display a list of all the driver in a specific location.." then click "Next" button. 8. Click the "Have Disk" button 9. Specify A:\(D:\driver)
Streszczenie treści zawartej na stronie nr. 20
Setup 7. Continue choosing "Close" button and "OK" button until you close the "Display 7 C ti h i "Cl "b tt d"OK" b tt til l th "Di l Properties" dialogue box. ® ® Microsoft Windows NT Operating System 1. Click Start, Settings, Control Panel, and then double-click Display icon. 2. In Display Registration Information window, click Settings Tab and then click All Display Modes. 3. Select a mode that you wish to use (Resolution, Number of colors and Vertical frequency) and then click OK. 4.
