Streszczenie treści zawartej na stronie nr. 1
LCD Digital Colour TV
Operating Instructions
KDL-52EX1
KDL-46EX1
KDL-40EX1
For useful information about Sony products
4-115-568-11(1)
© 2008 Sony Corporation 4-115-568-11(1)
Printed in Spain
KDL-52EX1/KDL-46EX1/KDL-40EX1 KDL-52EX1/KDL-46EX1/KDL-40EX1
4-115-568-11(1) 4-115-568-11(1)
Streszczenie treści zawartej na stronie nr. 2
2. TV wireless system can only be used in the following countries: Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, NOTICE FOR CUSTOMERS Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Liechtenstein, Lithuania, Luxembourg, IN THE UNITED KINGDOM Malta, The Netherlands, Norway, Poland, Portugal, Slovak Republic, Romania, Slovenia, Spain, Sweden, Switzerland, Turkey, A moulded plug complying with BS1363 is fitted to this equipment and The Unit
Streszczenie treści zawartej na stronie nr. 3
Table of Contents Start-up Guide 4 Safety Information.......................................................................................................................... 12 Precautions..................................................................................................................................... 14 Remote and Unit Controls/Indicators........................................................................................... 15 Watching TV Watching TV....................
Streszczenie treści zawartej na stronie nr. 4
Start-up Guide 1: Checking the unit and 2: Connecting an aerial/Set accessories Top Box/recorder (e.g. DVD recorder) to the media Monitor (1) receiver Connecting a Set Top Box/recorder (e.g. DVD recorder) with SCART Media receiver (1) Mains lead for monitor (1) Media receiver Mains lead for mains adaptor (1) Mains adaptor for media receiver (1) Scart lead Mains lead holder (1) Screws (PSW 4×8) (2) Remote RMF-ED001W (1) Set Top Box/recorder (e.g. DVD recorder) Size AA batteries (R6 type) (2)
Streszczenie treści zawartej na stronie nr. 5
Start-up Guide Connecting a Set Top Box/recorder (e.g. DVD recorder) with HDMI 3: Preventing the monitor from toppling over IN Media receiver HDMI cable Set Top Box/recorder (e.g. DVD recorder) ~ � You can also connect equipment to the HDMI input on the left side of the monitor. 1 Install a wood screw (4 mm in diameter, not supplied) in the monitor stand. 2 Install a machine screw (M6 x 12-15, not supplied) into the screw hole of the monitor. 3 Tie the wood screw and the machine screw wit
Streszczenie treści zawartej na stronie nr. 6
4: Connecting the mains 5: Performing the initial set- lead up ~ Inserting batteries into the remote � Make sure to secure the mains lead. � To ensure compliance with current EMC Push and lift the cover to open. legislation, ensure the following conditions are met. � Fix the mains lead holder (supplied) after checking the mains lead is in the groove of the mains lead holder (supplied) to avoid scratching the mains lead. 1 ~ � Observe the correct polarity when inserting batteries. � Do not
Streszczenie treści zawartej na stronie nr. 7
Start-up Guide POWER button ~ � If the remote does not work, press F/f/G/g/ on the media receiver (page 18) to select the language. 2 Select “OK” then press . Monitor 2 Check the LINK indicator on the media Next, the Media Receiver Initial Set-up will start. receiver. Please make sure the Media Receiver is on. If wireless communication between the OK media receiver and monitor is established, this indicator lights up. LINK indicator 3 Press F/f to select the country in which you will oper
Streszczenie treści zawartej na stronie nr. 8
6 Press F/f to select “Antenna” or “Cable”, ~ then press . � When a digital broadcast channel cannot be received, or when selecting a country in which If you select “Cable”, the screen for there are no digital broadcasts in step 3, the time selecting the scan type appears. See “To must be set after performing step 7. tune the unit for Cable connection” (page 8). To tune the unit for Cable connection The unit starts searching for all available 1 Press . digital channels, followed by all a
Streszczenie treści zawartej na stronie nr. 9
Start-up Guide 4 Press F/f to select “IR Blaster Set-up”, then press . 6: Operating optional The “IR Blaster Set-up” screen appears. equipment using the remote IR Blaster Set-up Connecting IR Blaster to the optional Inputs Type Make Code equipment AV1 - - - AV2 - - - Turn the power of the media receiver off HDMI 1 Blu-ray Disc Sony 1 HDMI 2 - - - before connecting the IR Blaster. HDMI 3 - - - Component - - - Attach the IR Blaster near the remote sensor (
Streszczenie treści zawartej na stronie nr. 10
Using optional equipment Item Description For details, refer to the operating instructions 1 BD/DVD �./>: Goes to the supplied with the connected equipment. Some operating beginning of the previous/ buttons may not work depending on the buttons next title/chapter/scene/ connected equipment. track. � / : Replays the scene/ 1 Press HDMI 1, HDMI 2, HDMI 3, AV1, briefly fast forwards the AV2 or COMPONENT. scene. 2 Press EXT. �m/M: Fast reverses/fast forwards the disc when 3 While the EXT bu
Streszczenie treści zawartej na stronie nr. 11
Start-up Guide Detaching the Table-Top Attaching the Stand for Stand from the Monitor Media Receiver Disconnect the mains lead from the monitor The media receiver can also be used vertically before detaching the Table-Top Stand. with the supplied stand. 1 Match the lug on the centre of the stand ~ � Remove the screws guided by the arrow marks and the hole on the right side of the media of the monitor. receiver. Do not remove the Table-Top Stand for any reason other than listed below. – To
Streszczenie treści zawartej na stronie nr. 12
Ventilation s Never cover the ventilation holes or insert anything in the Safety cabinet. s Leave space around the TV set as shown below. s It is strongly recommended that you use a Sony wall-mount Information bracket in order to provide adequate air-circulation. Monitor Installed on the wall Installation/Set-up Install and use the TV set in accordance with the instructions below 30 cm in order to avoid any risk of fire, electrical shock or damage and/or injuries. 10 cm 10 cm Installation s
Streszczenie treści zawartej na stronie nr. 13
When not in use Air circulation is Air circulation is s If you will not be using the TV set for several days, the TV set blocked. blocked. should be disconnected from the mains for environmental and safety reasons. s As the TV set is not disconnected from the mains when the TV set is just turned off, pull the plug from the mains to disconnect the TV set completely. s However, some TV sets may have features that require the TV Wall Wall set to be left in standby to work correctly. For child
Streszczenie treści zawartej na stronie nr. 14
RF Remote s If wireless equipment using the same frequency (2.4GHz band) Precautions as the unit is working near the unit, the remote may not operate properly. Viewing the TV Also, microwave ovens or radio equipment may cause interference. Keep 2.4 GHz band wireless equipment away s View the TV in moderate light, as viewing the TV in poor light from the unit. or during long period of time, strains your eyes. s When using headphones, adjust the volume so as to avoid excessive levels, as he
Streszczenie treści zawartej na stronie nr. 15
Remote and Unit Controls/Indicators Remote As the unit and the supplied remote communicate by radio frequency, you can operate the unit without aiming the remote at the unit. TV Button Description 1 1 TV "/1 Press to turn the unit on and off from standby HDMI 1 HDMI 2 HDMI 3 EXT (TV standby) mode. 2 COMPO- MONITOR NENT HDMI AV1 AV2 2 EXT Press to operate equipment with the IR Blaster attached, by the remote (page 10). 3 Press to change the subtitle language SYNC MENU 3 (Subtitle (page 36) (i
Streszczenie treści zawartej na stronie nr. 16
Button Description TV 9 HOME Press to display the media receiver Home menu in the media receiver mode (page 29), HDMI 1 HDMI 2 HDMI 3 EXT COMPO- or monitor Home menu in the monitor mode MONITOR NENT HDMI AV1 AV2 (page 38). 0 Coloured When the coloured buttons are available, an buttons operation guide appears on the screen. SYNC MENU Follow the operation guide to perform a DIGITAL/ THEATRE AUDIO ANALOG selected operation (page 21, 22, 23). qz Number In TV mode: Press to select channels. For
Streszczenie treści zawartej na stronie nr. 17
Button Description wj TV wa ANALOG/ Press to display the analogue or digital wf DIGITAL channel that was last viewed. HDMI 1 HDMI 2 HDMI 3 EXT wh COMPO- MONITOR NENT HDMI ws THEATRE You can set Theatre Mode to on or off. When AV1 AV2 Theatre Mode is set to on, the optimum audio wg output (if the unit is connected with an audio system using an HDMI cable) and picture wd SYNC MENU quality for film-based contents are DIGITAL/ ws THEATRE AUDIO ANALOG automatically set. z wa � If you turn the u
Streszczenie treści zawartej na stronie nr. 18
Media Receiver Buttons and Unit Indicators Monitor 1 2 3 4 5 67 Media Receiver 2 PROG LINK HOME PROG LINK HOME 7 6 8 9 0 qa qs Item Description 1 Remote control sensor Receives IR signals from the remote (if using an IR remote, not supplied). Do not put anything over the sensor, as its function may be affected. 2 1 (Power) Turns the unit on or off. ~ � To disconnect the unit completely, pull the plug from the mains. 3 Light Sensor Do not put anything over the sensor, as its function may be affe
Streszczenie treści zawartej na stronie nr. 19
Item Description 5 (Picture Off indicator) Lights up in green when the picture is switched off (page 43). 6 1 (Standby indicator) Lights up in red when the unit is in standby mode. 7 " (Power indicator) Lights up in green when the unit is turned on. 8 LINK indicator Lights up when the wireless connection between the media receiver and monitor is stable. 9 HOME (HOME) Displays the media receiver Home menu in the media receiver mode (page 29), or monitor Home menu in the monitor mode (page 38).
Streszczenie treści zawartej na stronie nr. 20
Watching TV 1 Press 1 on the media receiver or monitor to switch on. Watching TV ~ � When either unit is switched on, the other is 1 also switched on in tandem. When the unit is in standby mode (the 1 (standby) indicator on the unit (front) is red), press TV "/1 on the remote to switch on the unit. 2 Press DIGITAL/ANALOG to toggle between digital mode and analogue mode. The channels available vary depending on the mode. 1 3 Press the number buttons or PROG +/– to select a TV channel. To
