Instrukcja obsługi Metra Electronics 99-9100

Streszczenie treści zawartej na stronie nr. 1

INSTALLATION INSTRUCTIONS FOR PART 99-9100
APPLICATIONS
AUDI
A4/A6/A8 1996-1999
TT 2001-2006
99-9100
KIT FEATURES
• DIN Mount Radio Provision
KIT COMPONENTS
A) Trim Plate “A” • B) Trim Plate “B”
A
B
TOOLS REQUIRED:
Small Flat Blade Screwdriver • Panel Removal Tool
• 86-9001-Head Unit Removal Keys
www.metraonline.com
1-800-221-0932
© COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORATION

Streszczenie treści zawartej na stronie nr. 2

99-9100 TABLE OF CONTENTS Dash Disassembly - A4 1996-1999 . . . ............................................ 1 - A6 1996-1999 . . . ............................................ 1 - A8 1996-1999 . . . ............................................ 1 - TT 2001-2006. ..... ............................................ 1 Kit Assembly - DIN Mount Radio Provision . . ............................... ...... 2 Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Streszczenie treści zawartej na stronie nr. 3

99-9100 DASH DISASSEMBLY AUDI A4/A6/A8 1996-1999 TT 2001-2996 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 2 Insert the long ends of Metra's 86-9001 into the slots in the factory head unit and pull the unit out. Disconnect the wiring. (Figure A) Continue to kit assembly. 1

Streszczenie treści zawartej na stronie nr. 4

99-9100 KIT ASSEMBLY DIN MOUNT RADIO PROVISION WITH POCKET *Note: Refer also to the instructions included with the aftermarket radio. A 1 Slide the DIN cage into the radio open- ing and secure by bending the metal locking tabs outward. (Figure A) 2 Make wire connections as described on the next page. 3 Slide the radio into the DIN cage until it snaps into place. (Figure B) 4 Attach the trim plate to the front of the radio. (Figure C) B C 2

Streszczenie treści zawartej na stronie nr. 5

99-9100 WIRING WIRING A (A) Strip wire ends back 1/2" B B) Twist ends together C) Solder D) Tape C D 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individ- ually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. FINAL WIRING CONNECTIONS Make wiring connections using the EIA color code chart

Streszczenie treści zawartej na stronie nr. 6

99-9100 NOTES 4

Streszczenie treści zawartej na stronie nr. 7

99-9100 NOTES 5

Streszczenie treści zawartej na stronie nr. 8

99-9100 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV. 12/11/07 © COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORATION INST99-9100