Instrukcja obsługi Metra Electronics 95-9308B

Streszczenie treści zawartej na stronie nr. 1

INSTALLATION INSTRUCTIONS FOR PART 95-9308B INSTALLATION INSTRUCTIONS FOR PART 95-9308B
APPLICATIONS
BMW X5
2000 - 2006
(non-navigation models)
95-9308B
KIT FEATURES
• DDIN Head Unit Provision
• ISO Stacked Head Unit Provision
• Painted Scratch Resistant Matte Black
KIT COMPONENTS
• DDIN Radio Trim Plate • DDIN Brackets • (4) Plastic Snaps • (8) Flush ISO Screws
TOOLS REQUIRED
• Phillips Screwdriver • Torx Screwdriver • Panel Removal Tool
• Small Flat Blade Screwdriver • Cutting Tool o

Streszczenie treści zawartej na stronie nr. 2

95-9308B 95-9308B NOTES TABLE OF CONTENTS DASH DISASSEMBLY • BMW X5 2000 - 2006 . . . . . . . . . . . . . . 1,2 KIT ASSEMBLY • BMW X5 2000 - 2006 . . . . . . . . . . . . . . . 3 *NOTE: Refer Also to the instructions included with the aftermarket radio. KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and

Streszczenie treści zawartej na stronie nr. 3

95-9308B 95-9308B DASH DISASSEMBLY NOTES BMW X5 2000-2006 1 Disconnect the negative A battery terminal to prevent an accidental short circuit. 2 Remove the volume knob. (Fig. A) 3 Using a T-10 torx-head screwdriver, turn the release lever under the shaft 90º. (Fig. A) 4 Leaving the screwdriver B in position, pull out on the bottom of the factory head unit and remove the unit. (Fig. A) 5 Disconnect the wiring. 6 Using a T-10 torx-head screwdriver, loosen (2) T-10 torx-head screws loc

Streszczenie treści zawartej na stronie nr. 4

95-9308B DASH DISASSEMBLY 95-9308B KIT ASSEMBLY BMW X5 2000-2006 BMW X5 2000-2006 1 Mount the DDIN radio to the .............Coninued from Pg. 1 C A supplied DDIN brackets us- ing the ISO screws supplied 8 With the factory radio door with the aftermarket radio open, press in on the tabs at (screws must be fl ush). either side and remove the (Fig. A) door. (Fig. C) 2 Locate the factory wiring har- 9 Cut and remove shown sec- ness in the dash. Metra rec- tion from the sub dash. ommends u