Streszczenie treści zawartej na stronie nr. 1
GB
D
F
DIGITAL VIDEO RECORDER
ES
SHR-3010
I
User’s Manual
To use this product safely, have to read “Important Safety Introductions”, and then
be well aware of the contents.
Streszczenie treści zawartej na stronie nr. 2
DIGITAL VIDEO RECORDER GB GB Important Safety Instructions 1. Read these instructions. CAUTION 2. Keep these instructions. RISK OF ELECTRIC SHOCK DO NOT OPEN 3. Heed all warnings. 4. Follow all instructions. CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO 5. Do not use this apparatus near water. NOT REMOVE COVER (OR BACK). NO USER 6. Clean only with dry cloth. SERVICEABLE PARTS INSIDE. REFER SERVICING 7. Do not block any ventilation openings. Install in accordance with the TO QUALIFIED SERVI
Streszczenie treści zawartej na stronie nr. 3
GB GB Contents iii Important Safety Instructions 4 IV. Record 4-1 1. Basic Record iv ~ v Contents 4-3 2. Record Lock 4-4 3. Alarm Record 4-5 4. Reservation Record 1 I. Summary 1-1 1. Introduction 5 V. Retrieval and Playback 1-2 2. Characteristics 1-3 3. Name and Function of Each Part 5-1 1. Retrieval Menu View 1-7 4. Unpacking 5-3 2. Retrieval by Data and Time 1-8 5. HDD Addition 5-4 3. Recorded Data List View 5-5 4. Alarm Record Retrieval 5-6 5. Power On/Off Status List View 2 II. Connection wi
Streszczenie treści zawartej na stronie nr. 4
GB I. Summary 1
Streszczenie treści zawartej na stronie nr. 5
DIGITAL VIDEO RECORDER GB GB Introduction Characteristics 1 2 The Digital Video Recorder SHR-3010 is a Digital Time Lapse Recorder to utilize its Upon booting the system, it recognizes automatically whether the incoming signal is NTSC or PAL signal. HDD as a recording media. How to use it is simple and therefore existing users of Adjusting screen quality in 4-steps Time Lapse VCR can also access to it since it is built with Jog/Shuttle. You can also Very High, High, Normal, Low perform con
Streszczenie treści zawartej na stronie nr. 6
DIGITAL VIDEO RECORDER GB GB Name and Function of Each Part 3 Front View 1 2 3 4 5 6 7 8 9 10 11 12 13 No Name Function No Name Function Displays system status. Used when moving cursor to the lower item of menu or 6 DOWN ( ) POWER : Checks power On. reducing values in setting-up details of menu. HDD : Checks normal access to HDD. FULL : Check if the hard disk is full. Used when temporarily stopping during play or desiring to see SET/STILL STATU
Streszczenie treści zawartej na stronie nr. 7
DIGITAL VIDEO RECORDER GB GB Rear View 1 2 3 4 5 6 7 8 9 10 11 No Name Function No Name Function ALARM IN: In the N.C. (Normally Closed) mode, the system EXTERNAL I/O 8 recognizes an alarm when a High (5V) signal is input for over PORT 1 RS232 PORT Serial Port for remote control. 0.5 seconds. In the N.O. (Normally Open) mode, the system recognizes an alarm when a Low (0V) signal is input for over 2 0.5 seconds. (Please refer to “➁ ALARM DETECT TYPE” Serial Po
Streszczenie treści zawartej na stronie nr. 8
DIGITAL VIDEO RECORDER GB GB Unpacking HDD Addition 4 5 When purchasing product, first remove packing and put it on a flat floor or at a place to use it. Mounting HDD Then, ensure all following contents are included: 1. Unfasten the SCREW-SPECIAL (BWH, M4, L8, WHT) 11 EA attached to the left, right, ◗ Main body and rear of the product, and then remove the CABINET-TOP from the product. ◗ User’s Manual 2. Unfasten the SCREW-TAPTITE (BH, M3, L6 WHT) 3 EA to remove the HDD from the ◗ 1 power cord
Streszczenie treści zawartej na stronie nr. 9
DIGITAL VIDEO RECORDER GB GB Caution Caution Please be sure to turn the system off before you replace or add the HDD. If not, the HDD may poorly operate or the life may be reduced. AT-Bus Interface Cable and Power Supply Cable are connected to AT-Bus Interface Mode setup and cable connection Connector are connected by referring to following drawing to ensure the HDD mounted on product can properly operate. Set a HDD mode and connect cables after mounting the HDD to product. Below is shown drawin
Streszczenie treści zawartej na stronie nr. 10
GB II. Connection with Other Devices 2
Streszczenie treści zawartej na stronie nr. 11
DIGITAL VIDEO RECORDER GB GB Connection with Multiplexer Connection to External Devices 1 2 (e.g. connection to SDM-160) CAMERA 1 2 3 . . TRIGGER OUT . MICROPHONE 16 ALARM IN CAMERA RX SIREN LIGHT MONITOR GND OUT SHR-3010 VIDEO RECORDER AC IN SDM-160 DIGITAL MULTIPLEXER VIDEO IN VIDEO OUT SDM-160 is a Multiplexer for NTSC, and SDM-160P is a Multiplexer for PAL. For details on the functions of SDM-160, please refer to the user’s guide of SDM-160. VIDEO OUT LAN AUDIO
Streszczenie treści zawartej na stronie nr. 12
DIGITAL VIDEO RECORDER GB GB System Connection for Alarm Recording Connection with PC for Use 3 4 Connection with RS-232C A. Communication Method 1 2 3 4 5 6 7 8 9 10 11 1 2 3 4 5 Data Code: ASCII Code Protocol: 8 bit Data, 1 Stop bit, None Parity Transmission speed: 4800, 9600, 19200, 38400 bps B. RS-232C terminal (D-SUB 9 Pin) and Pin specifications 51 9 6 1 ALARM IN 1 GND Pin No Pin Specifications 2 ALARM RESET 2 TRIGGER IN 2
Streszczenie treści zawartej na stronie nr. 13
DIGITAL VIDEO RECORDER GB GB D. Code value by key Connection with RS-485 Response Remote control is allowed through connection with RS-485 (up to 1.2km). Function Byte 1 Byte 2 Byte 3 Byte 4 Byte 5 Byte 6, 7, 8 Byte 9 (Byte 5) [SET COMMAND] A. Communication method MENU 0xA0 Src.Addr Dest.Addr. 0x0A 0x01 0xFF Check Sum 0x01 Data transmission method: Start-Stop Synchronized Serial Interface SEARCH 0xA0 Src.Addr Dest.Addr. 0x0A 0x02 0xFF Check Sum 0x02 Protocol: 8 bit Data, 1 Stop bit, None Par
Streszczenie treści zawartej na stronie nr. 14
GB III. Basic Method to use 3
Streszczenie treści zawartej na stronie nr. 15
DIGITAL VIDEO RECORDER GB GB Booting the System 1 Power On There is a power switch on the upper right hand side behind the system. Pull the power Recognizing incoming video signal switch up to boot the system. Then, the LED on front of the system is turned on, a blue SHR-3010 system can automatically recognize whether the video signal connected at the input port screen with the following message will appear and the system is booted. is NTSC or PAL signal upon booting the system. When you turn t
Streszczenie treści zawartej na stronie nr. 16
DIGITAL VIDEO RECORDER GB GB Basic Screen Viewing 2 And the system will automatically keep on searching for a hard disk drive as shown below. Viewing Full Screen If you attach a hard disk drive at this time, the system will recognize the hard disk drive, the Here comes the description of all the icons and status in the screen. boot process will end, and a live screen will appear. 2001-08-22 18:19:12 SYSTEM UNSTABLE OR HDD NOT EXIST RESET HDD DEVICE(S) >TRY TO FIND HDD >HDD NOT FOUND √X2 2001-09-
Streszczenie treści zawartej na stronie nr. 17
DIGITAL VIDEO RECORDER GB GB Live Screen Viewing The normal Live screen looks like this. 2001-09-15 07:14:55 1 2001-08-22 18:19:12 It shows the current date and time as configured by the system. If system is in the recording state icon will blink. However, it does not blink in the You can change the display position of date and time. You shall designate the position Live Screen state. in the top right or left corner by yourself. (Just choose LEFT or RIGHT in the 1 If the system is in a stat
Streszczenie treści zawartej na stronie nr. 18
DIGITAL VIDEO RECORDER GB GB Viewing Screen during recording Playback screen Viewing The normal recording screen looks like this. The normal Playback screen looks like this. 1 2001-08-22 18:19:12 2001-09-24 00:23:44 The upper pointer shows the relative location of the recorded data being stored inside If the system is executing the recording function, icon blinks. the hard disk and the lower pointer shows the relative location of the data currently being played back. If the system is in t
Streszczenie treści zawartej na stronie nr. 19
DIGITAL VIDEO RECORDER GB GB Menu View 3 Menu Enter Change of Settings Press a MENU button. Then, following screen appears. Move to desired menu item by using an UP( ) or a DOWN( ) button. ➁ You can change settings by pressing the SET/STILL( ) button. MAIN MENU ➂ Press the UP( ) or DOWN( ) button in order to change settings. CLOCK/DISPLAY MODE SETUP ➃ Settings will be changed if pressing the SET/STILL( ) button after selecting RECORD MODE SETUP ALARM RECORD S
Streszczenie treści zawartej na stronie nr. 20
DIGITAL VIDEO RECORDER GB GB ➃ Similarly, press the UP( ) or DOWN( ) button so current minute is displayed. Example of menu setting (in case of changing time) Then if pressing the LEFT( ) or RIGHT( ) button, the cursor is changed so hour or Press the MENU button and then press the SET/STILL( ) button when the cursor second is changed. For example, press the RIGHT( ) button to change seconds and points out the CLOCK/DISPLAY MODE SETUP. Then following screen app
