Instrukcja obsługi Havis-Shields KK-K9-C14-K-32

Streszczenie treści zawartej na stronie nr. 1

INSTALLATION INSTRUCTIONS KK-K9-C14-K-32
32” K9 TRANSPORTATION SYSTEM
2000-2006 CHEVROLET TAHOE / GMC YUKON (4 Door)

TOOLS REQUIRED:
Power drill Open-end wrench set
Drill bit set Wire cutters / Crimping tool
Standard & metric socket sets Ratcheting wrench
Phillips screwdriver

HARDWARE:
QTY DESCRIPTION PART #
20 ¼-20 x ½” Stainless Carriage Bolts GSM32022
30 ¼-20 x ¾” Stainless Carriage Bolts GSM32024
50 ¼-20 Hex Flange Serrated Nuts Zinc GSM30023
6 ¼” x 1” Hex Head

Streszczenie treści zawartej na stronie nr. 2

Passenger-side 32” K9 tunnel Main housing Switch box Mounting Legs/Plates Driver-side Rear housing extension plate (Not Shown) tunnel Attach in subassembly to Main Housing Floor INSTALLATION: 1. REMOVE INTERIOR: • Remove rear seats and seat belts. • Remove top, side, and bottom plastic rear trim caps 2. REMOVE REAR OEM DOOR PANELS: • Remove speaker, door handle, and lock • Remove switch assembly from plastic housing (leave plug on switch) Note: If vehicle has electric

Streszczenie treści zawartej na stronie nr. 3

3. INSTALL MOUNTING LEGS: • Using ¼-20 x ¾” Carriage bolts attach mounting legs to hold down plates. • Loosely attach hold down plates to floor using existing seat mounting studs and nuts used to hold down seats. Rear housing extension should Note: Use one OEM nut as a spacer under the plate. be attached at this time 4. SLIDE IN K9 MAIN HOUSING: • Slide in main housing • Mark & drill 5/16” holes in K9 unit floor where mounting legs and floor come together. • Mount legs to hou

Streszczenie treści zawartej na stronie nr. 4

6. HOUSING FINAL STEP • Center housing so tunnels are even on both sides. • Mount rear housing adapter plate. This piece is 5” long and the width of the housing. • Drill and mount plate to housing using ¼ x ¾” Stainless Carriage bolts and serrated nuts. Note: Carriage bolt head must be on floor side of housing. Note: Be sure to check under vehicle for obstructions. ***The (1) far passenger side hole is located overtop of refrigerant lines. Be sure to not attach the extension pl

Streszczenie treści zawartej na stronie nr. 5

• Re-attach window guard to top mounting bracket. 8. FINAL STEPS: • Mount dome light switch as desired. A switch box is provided so switch can be mounted to K9 housing in various locations. (Side of tunnel housing at top works best). Wire to 12-volt power source. • Silicone sheet metal seams and gaps. Proper sealing of compartment will eliminate water from getting under the K9 unit. Seal seams with silicone. • Allow silicone to dry overnight before placing in rubber floor mat.