Instrukcja obsługi Philips MCD139B/37

Streszczenie treści zawartej na stronie nr. 1

1
Quick Start Guide
2
User Manual
MCD139B
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
DISC AUX TUNER DISPLAY
OSD
A-B MODE CLOCK SLEEP/TIMER
SYSTEM MENU DISC MENU
OK
CR2025
AUDIO MUTE
+
VOL
1 2 3 GOTO
4 5 6 ZOOM
7 8 9 DSC
PROG 0 SUBTITLE DBB
Remote control with one Remove the insulation plastic tab
Composite video cable DIN cable
CR2025 battery loaded
before use
FM wire antenna
Quick start guide User manual
MCD139B QSG_Eng-37 1 20/12/06, 17:33

Streszczenie treści zawartej na stronie nr. 2

1 Connect the speaker wires of the right speaker and subwoofer to the Important! left speaker. – This set can only be operated after the supplied DIN cable has been connected. 2 Connect the supplied FM wire antenna. Tips – See the User Manual for other TV 3 connection options. Connect the left speaker and the DVD player by using the supplied –For connecting to a Progressive Scan DIN cable. TV, refer to the user manual for proper connections and detailed setup. 4 Connect the DVD player to your TV

Streszczenie treści zawartej na stronie nr. 3

CLOCK Setting the clock DISC AUX TUNER DISPLAY 1 OSD A-B MODE CLOCK SLEEP/TIMER In standby or power on mode, press and hold CLOCK on the remote control. SYSTEM MENU DISC MENU The clock digits flash on the display. 2 OK Press ¡ / ™ repeatedly to set the hours. AUDIO MUTE + VOL 3 Press à / á repeatedly to set the minutes. GOTO 1 2 3 4 5 6 ZOOM 7 8 9 DSC PROG SUBTITLE 4 0 DBB Press CLOCK again to store the setting. Setting DVD menu options IMPORTANT! If the progressive scan feature is activated but

Streszczenie treści zawartej na stronie nr. 4

Playing a disc 1 Push OPEN /CLOSEç to open the disc door. 2 3 Load in a disc with the label side facing up, then close the disc door. To switch on the system, 3 press STANDBY ONB/ Playback will start automatically. If not, pressÉÅ. SOURCE on the set, or DISC/TUNER/AUX on the remote. 4 To stop playback, press 9. Programming and tuning to radio stations 1 Press SOURCE (TUNER on the remote) to select tuner source (FM). 2 Press PROGAM on the set for more than two seconds to program all available st