Instrukcja obsługi Dakota Digital LAT-NR162

Streszczenie treści zawartej na stronie nr. 1

INSTALLATION INSTRUCTIONS
LAT-NR162
LED Tail Lights for ’66 Impala/Caprice and ’67 Caprice

MAN#650160

Kit Includes:

Installation:
’66 Impala ’66 Caprice ’67 Caprice



1. Remove the original bulb connector from the back side of the housing.
2. Remove the light bulb.
3. Remove the tail light housing from the car. There are nuts inside the trunk on the back side of
the housing.
4. Remove the chrome trim plate and tail light lens. These screws ar

Streszczenie treści zawartej na stronie nr. 2

6. Remove the screw and aluminum back plate from the new LED assembly. The center hole in the ’67 Caprice is smaller and offset so there is a special back plate supplied for this application. LED assembly Standard back plate ’67 Caprice center hole back plate. 7. Insert the new LED assembly through the hole where the original bulb and connector were located. Use caution when feeding the wires through to avoid damaging the wire insulation. 8.

Streszczenie treści zawartej na stronie nr. 3

10. Place the original lens gasket into place and replace the tail light lens. 11. Replace the chrome trim and then tighten the screws down carefully. 12. Install the tail light assembly back into the car. You are now ready to wire the lights into the vehicle’s wire harness. MAN#650160

Streszczenie treści zawartej na stronie nr. 4

13. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 14. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For the bes