Streszczenie treści zawartej na stronie nr. 1
EXCELLENCE
by
H-CMD7080
DVD/CD/MP3-RECEIVER DVD/CD/MP3-
Instruction manual
Streszczenie treści zawartej na stronie nr. 2
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents ...............................................................................................................................................3 Important safeguards .....................................................................
Streszczenie treści zawartej na stronie nr. 3
Important safeguards Using the device at temperature below -10º may cause the breakage of the device. Before using please heat up the passenger compartment to the recommended temperature! Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit. Do not attempt to disassemble the unit. Laser beams from
Streszczenie treści zawartej na stronie nr. 4
Accessories Receiver 1 pc Remote controller 1 pc Panel protective case 1 pc USB cable 1 pc Mounting parts: Release keys 2 pc Screw 20 1 pc Bolt 6 4 pc Washer 3 pc Mounting strap 1 pc Customer information 1 pc Warranty card 1 pc Instruction manual 1 pc 5
Streszczenie treści zawartej na stronie nr. 5
Installation/connection Attention: Remove the transport CD stopper (2 screws) before use. Din front-mount (method 1) After inserting the holder into the dashboard, select the appropriate tab and bend them inwards to secure the holder in place. 1. Dashboard 2. Nut (5mm) 3. Spring washer 4. Screw (5 x 25mm) 5. Screw 6. Strap 7. Plain washer Removing the unit frame Insert fingers into the groove in the front of frame and pull out to remove the frame. (When reattaching the frame, point the side wit
Streszczenie treści zawartej na stronie nr. 6
Din rear-mount (method 2) Installation using the screw holes at both sides of the unit. 1. Select a position where the screw holes of the main unit are fitted for aligned, and tighten the screws at 2 positions at each sides. Use either truss screws (5 x 8mm) or flush surface screws (4 x 8mm), depending on the shape of the screw holes in the bracket. 2. Screw. 3. Factory radio mounting bracket. 4. Dashboard or Console. 5. Hook (Remove this parts). Note: The mounting box, outer trim ring, and the
Streszczenie treści zawartej na stronie nr. 7
Attaching the control panel 1. Insert the right side of the control panel into the main unit (pic. 3). 2. Press the control panel on to the left side of middle of it until a “click” sound is heard (pic. 4). Pic. 4 Pic. 3 Caution: Do not insert the control panel from the left side. It can damage the control panel. The control panel can easily be damaged by shocks. After removing it, place it in a protective case and be careful not to drop it or subject it to strong shocks. The rear connector t
Streszczenie treści zawartej na stronie nr. 8
Electrical connection Caution: Do not interchange the connection of the wiring! For some car models you may need to modify wiring of the supplied power cord. Contact your authorized car dealer before installing this unit. Note: Parking wire is not used. 2 cable is connected to a Hands-Free device (not included). 9
Streszczenie treści zawartej na stronie nr. 9
Panel controls Front panel 1. PWR/MUTE button 2. IR sensor 3. DISP/DUAL button 4. MODE button 5. OPEN button 6. USB jack 7. T-UP button 8. T-DN button 9. BND/LOUD button 10. AS/PS button 11. 6/DIR+ button 12. 5/DIR- button 13. 4/RDM button 14. 3/INT button 15. 2/RPT button 16. 1/PLAY/PAUSE button 17. AF/MONO button 18. LOC button 19. PTY/SCN button 20. TA/DSP button 21. VOL knob/SEL button 22. AUX IN socket (under rubber cover) 10
Streszczenie treści zawartej na stronie nr. 10
Remote control 1. DUAL button 2. STANDBY button 3. OSD button 4. SETUP button 5. Cursor buttons 6. PREVIOUS/NEXT button 7. ANGLE button 8. VOL+/- button 9. SEL button 10. GOTO/AUDIO button 11. FUNC button 12. PROG/PTY button 13. BAND/RDM button 14. Number buttons 15. TITLE button 16. DSP button 17. MODE button 18. MUTE button 19. MENU button 20. ENTER button 21. INT button 22. PLAY/PAUSE button 25. A-B/ZOOM button 23. STOP/PBC button 26. P.SCAN/RPT button 24. SUBTITLE button 27. TA button 11
Streszczenie treści zawartej na stronie nr. 11
Changing the battery 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the remote control. Warning: Store the battery where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately. Do not recharge, short, disassemble or heat the battery or dispose it in a fire. Do not expose or bring into contact the battery
Streszczenie treści zawartej na stronie nr. 12
Back of the front panel Press OPEN button on the front panel to flip it down. 1. Disc slot; 2. SD/MMC card socket; 3. EJECT button; 4. Panel status indicator; 5. RESET button. Note: Pressing RESET button will erase the clock setting and stored stations. Panel status indicator lights up when you slide the panel down; flashes when you remove the panel. 13
Streszczenie treści zawartej na stronie nr. 13
General operations Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press OPEN button on the panel to open the panel and press RESET button to restore the unit to the original factory settings. Power button Press any button on the panel or STANDBY button on the RC to turn on the unit. Press and hold PWR button on the panel or STANDBY button on the RC to switch the unit off. Note: After the unit is off, the volume level and radio cu
Streszczenie treści zawartej na stronie nr. 14
Setting other characteristics During TUNER mode press SEL button and hold for 2 seconds, shortly and repeatedly press SEL button to select the setting: TA SEEK => PI MUTE => RETUNE L => MASK DPI =>TA VOL => EAN TA =>BEEP. TA SEEK/TA ALARM To choose the TA mode, press SEL button for 2 seconds, then press it repeatedly until the display shows TA SEEK or TA ALARM. Rotate the knob to choose between the TA SEEK and TA ALARM. After choosing, please leave the unit idle to activate. In TA SEEK mode, the
Streszczenie treści zawartej na stronie nr. 15
Turn BEEP ON if you want the pressing of buttons to be sounded. Press SEL Button until the display shows nd BEEP, then use the VOL+/- Button to turn BEEP sound on or off or 2 (you hear BEEP sound when you press the button over 1.5 seconds). Turning the sound off Press MUTE button to turn the sound off. Press it again or press VOL+/- buttons on the RC or rotate VOL knob on the panel to turn the sound on. Mode setting Press MODE button on the panel repeatedly to select: TUNER => DVD (if inserted)
Streszczenie treści zawartej na stronie nr. 16
Digital tuner operations Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. RDS overview PI: Program Identification Code – for identifying code. PS: Program Service Name Broadcast – station name data expressed in alphanumerically character. TP: Traffic Program Identification – for traffic information broadcasting station. TA: Traffic Announcement Identification – show
Streszczenie treści zawartej na stronie nr. 17
- Select a band (if needed) - Select a station by pressing T-DN/T-UP buttons on the panel or PREVIOUS/NEXT buttons on the RC. - Hold a Preset button (1-6), which you want store the station for at least 2 seconds. To recall a station: - Select a band (if needed) - Press a Preset button (1-6) briefly to recall the stored station. FUNC button Press FUNC button to enable AF mode. Press and hold to choose MONO or STEREO. LOC button In urban settings, most stations are strong enough and stations are
Streszczenie treści zawartej na stronie nr. 18
3. When TA or TP RDS signal is available from the current station, TP icon is turned on. When TA/TP is enabled (on), but no traffic announcement is transmitted, TP icon is off and TA icon keeps blinking. AF (Alternative Frequencies) function Press AF/MONO button on the panel shortly to turn on or turn off the AF function. If the AF function is on the display will show “AF”. When AF switching mode is selected, but RDS information is not received yet the “AF” will be flashing. The RDS program will
Streszczenie treści zawartej na stronie nr. 19
Disc glossary PBC (PlayBack Control) PBC is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image. Title The title is the important part of DVD disc. The memory volume of the disc is rather big, that makes possible to record several films on one disc. For example, if a disc contains three films, they may be divide
Streszczenie treści zawartej na stronie nr. 20
DVD/SD/MMC/USB operations Discs for playback This unit can play disc types: DVD/DVD±R/±RW/CD/CD-R/CD-RW. Compatible with formats: DVD/SVCD/VCD/DVD Audio/CDDA/MP3/CD/WMA/ HDCD/Picture-CD/ Photo-CD/JPEG. The following file types are supported: Audio files: MP3 (*.mp3) WMA (*.wma) Video files: MP4 (*.avi, DIVX3.11/4.0/5.0/6.0 and XVID) MPEG 2(*.vob) MPEG 1(*.dat) Picture file: JPEG (*.jpg) ISO 9660 or ISO 9660 +Joliet format - Max. 30 characters Max. Track n
