Streszczenie treści zawartej na stronie nr. 1
SUMMARY/SETUP MANUAL
VCC-HD5400
VCC-HD5400P
Megapixel Camera
THIS INSTALLATION SHOULD BE MADE Before installing and using the camera, please read
BY A QUALIFIED SERVICE PERSON AND this manual carefully.
SHOULD CONFORM TO ALL LOCAL Be sure to keep it handy for later reference.
CODES. In addition, be sure to read carefully the electronic
manual (INSTRUCTION MANUAL) contained in the
supplied CD-ROM to ensure correct operation of
the camera.
Important
• Be careful when opening holes for install
Streszczenie treści zawartej na stronie nr. 2
Contents Name and Function of Each Component .....................................................................2 Basic Connections .......................................................................................................5 Installation ....................................................................................................................9 Control/Address Settings ...........................................................................................11 Address Set
Streszczenie treści zawartej na stronie nr. 3
Name and Function of Each Component For the cable type, see the “cable label” attached to the cable bundle. For the detailed connection procedure, refer to the “Basic Connections” section. ( Page 5) 24VAC GND ~ ~ 12VDC - + 24 VAC /12 VDC Power cable Alarm cables • Alarm input cable: Connect an e xternal switch, infrared sensor, or other device to detect alarm conditions such as the entry of an intruder. • Alarm output cable: Connect a buzzer, lamp, or other alarm device. Dip switch (
Streszczenie treści zawartej na stronie nr. 4
Name and Function of Each Component - - Control cable By connecting a system controller (sold separately), the camera can be controlled remotely. Wire gutter cover If you wire on the ceiling surface, remove the wiring gutter cover. Audio jacks Audio output terminal (black: 3.5-mm mini jack) Use this jack to connect to the audio input jacks of a powered speaker system or a monitor. Audio input terminal (white: 3.5-mm mini jack) Use this jack to connect an external microphone to lis
Streszczenie treści zawartej na stronie nr. 5
Name and Function of Each Component Side Cover Fall-prevention screw SD Card slot Power indicator This indicator lights up when the camera is powered on. When the camera is on, this indicator blinks to indicate the following camera statuses: • Deactivation of recording to SD memory card in progress • Firmware update in progress • An SD memory card error occurred (Fast blink) SD CARD button • Disable recording: The power indicator blinks when this button is pressed, and stays lit when the
Streszczenie treści zawartej na stronie nr. 6
Basic Connections VCC-HD5400 High-definition monitor HDMI HDD *3 USB PC LAN BROWN ALARM_IN1 RED ALARM_IN2 ORANGE ALARM_IN3 Alarm cable ALARM_IN4 YELLOW BLACK GND WHITE ALARM_OUT1 External ALARM_OUT2 GRAY peripheral device BLACK GND Microphone WHITE AUDIO IN *2 *1 BLACK AUDIO OUT Speaker Audio cable DC12 AC24 ~ RED + ~ ~ AC24 BLACK - ~ WHITE GND NC GND Power cable + DC12 - GRAY RS485(A) YELLOW RS485(B) WHITE GND System controller Control cable *1 Monitor Video cable • Before attempting
Streszczenie treści zawartej na stronie nr. 7
VCC-HD5400P High-definition monitor HDMI HDD USB *3 PC LAN BROWN ALARM_IN1 *1 RED ALARM_IN2 ORANGE ALARM_IN3 ALARM_IN4 YELLOW BLACK GND WHITE ALARM_OUT1 Alarm ALARM_OUT2 GRAY cable External BLACK GND *2 peripheral device Microphone WHITE AUDIO IN BLACK AUDIO OUT Speaker Audio cable *1 GRAY RS485(A) YELLOW RS485(B) WHITE GND Control cable *2 *1 Video cable Monitor System controller DC12 AC24 ~ RED + ~ ~ BLACK - ~ AC24 GND WHITE NC GND Power cable + DC12 - Connecting an External Hard
Streszczenie treści zawartej na stronie nr. 8
Basic Connections Network Connection This camera is designed so that you can use all of its functions via network operation. By connecting the network (LAN) socket of the camera to your PC using a LAN cable, you can configure and operate it from the Web browser installed on your PC. Internet Internet connection LAN connection Modem PC PC Router Switching hub • Use a LAN cable no longer than 100 m (109.4 yards) with the shield type CAT5 or higher. • Use a straight-type cable if connecting to L
Streszczenie treści zawartej na stronie nr. 9
Basic Connections Alarm Cable Connection Use a thicker cable than 24AWG for connection. (Maximum length 600 m/656 yds.) Outputting alarm signals (ALARM OUT1-2) Connect a buzzer, lamp, or other alarm device to the alarm output cable. Alarm can be output via two channels. ( Electronic manual) • After connecting an alarm device, configure the output conditions for the corresponding alarm output cable via network operation on the ALARM SETTINGS screen. • Configuration of alarm output terminal is
Streszczenie treści zawartej na stronie nr. 10
Installation Using the supplied pattern sheet, drill the holes for the cables and screws. • Pull out the cables from the ceiling. Attach the supplied mounting plate to the ceiling using commercially-available screws. (Screw: M4/No. 8 or equivalent) Length: 40 mm/1.6 in or more, Head: φ 8.3 mm/0.3 in • Loosen the screw (A) and remove the cable holder (B). (B) (A) Hook the safety cable attached on the camera base to the mounting plate. Connect the cables from the ceiling to the camera cables. (
Streszczenie treści zawartej na stronie nr. 11
Installation Ceiling Pattern sheet (supplied) (D) (D) Mount the camera by aligning the triangular marks ( ), then rotate the camera in the arrow (D) direction. • Make sure the camera is securely mounted. Open the side cover and tighten the fall-prevention screw (E) using the supplied hexagonal wrench (F). • When fi nished, make sure to put the cover back. (F) (E) • The surface of the camera can be hot during operation, but it is not a malfunction. When you touch the heated portion of th
Streszczenie treści zawartej na stronie nr. 12
Control/Address Settings When you connect the camera to a controller, it is necessary to configure the interface board control switch and address switch. ■ Control switch This is used to configure transmission rate and protocol, etc. • Switches 2 and 3 are not used. ON ON • Settings in bold typeface in the table below show the factory default configurations. 65 65 44 32 32 1 1 Baud Rate Configure the transmission rate of connected devices to the transmission rate of the camera. Transmi
Streszczenie treści zawartej na stronie nr. 13
Address Settings Table In the table, the circle mark “ ” means ON. Set switches as shown in the table. When protocol is “SSP (SANYO)”: • Configurable addresses: 1 to 127 ON • Switch 8 is configured to “OFF”. When protocol is “PELCO”: • Configurable addresses: 1 to 255 1 234 5 6 7 8 • To configure the address to a number between 128 and 255, set the switch 8 to “ON”. Address (Camera No.) Address (Camera No.) Address (Camera No.) Switch No. Switch No. Switch No. Protocol Protocol Protocol SANYO
Streszczenie treści zawartej na stronie nr. 14
Network Settings Preparing Your Computer for Network Operation Check your operating environment. ( Page 1) Connect the camera to the network to which your PC is also connected. Configue the network information on your PC. Configure information such as the IP address of your PC. Install the “H.264 Plug-in” from the supplied CD-ROM onto your PC. You are now ready to monitor the surveillance video in the H.264 format. Start Internet Explorer. The supported Web browser is Internet Explorer Ver
Streszczenie treści zawartej na stronie nr. 15
Specifications ■ Camera Image pickup device 1/2.5" CMOS sensor Effective pixels 16:9 1920 (H) × 1080 (V), 4:3 1600 (H) × 1200 (V) Lowest image 50IRE: 2.0 lx (F1.8, in color mode with high gain) illumination 50IRE: 0.1 lx (F1.8 in black-and-white mode with high gain) Video S/N ratio 50 dB or higher (when AGC is ‘OFF’) Lens Focal Length: f=6.3 - 63 mm, F number: F1.8 - 2.5 Optical zoom 10x, electronic zoom 16x (up to 160x when used in combination with the optical zoom) Rotational scope Pan: 360°
Streszczenie treści zawartej na stronie nr. 16
Specifications ■ Network Image/video compression H.264/JPEG Video size (H.264) (16:9) 1920×1080, 1280×720, 640×360, 320×180 (4:3) 1600×1200, 1280×960, 1024×768, 640×480, 320×240 Video size (JPEG) (16:9)1920×1080, 1280×720, 1024×576, 640×360 (4:3) 1600×1200, 1280×960, 1024×768, 800×600, 640×480, 320×240 Picture quality QUALITY mode: BASIC, NORMAL, ENHANCED, FINE, SUPER FINE BITRATE mode: User-specified bit rate Interface 10BASE-T/100BASE-TX Protocol TCP/IP, UDP, HTTP, HTTPS, SMTP, NTP, DHCP, FTP,
Streszczenie treści zawartej na stronie nr. 17
Copyright Notice The instruction manual and the software are copyrighted by SANYO Electric Co., Ltd. No materials contained in the manual and the software may, wholly or partially, be copied, modified, reproduced, or distributed in any format without the prior permission of the copyright holder. Microsoft, Windows, ActiveX and Internet Explorer are registered trademarks or trademarks of Microsoft Corporation in the United States and other countries. ® ® The official name for “Windows” used in
