Instrukcja obsługi Ikelite SX10 IS

Streszczenie treści zawartej na stronie nr. 1

P Pl le ea as se e R Re ea ad d
Ikelite Digital Housing
We suggest that you read this instruction booklet thoroughly
before use. If you are new to underwater photography, be sure
i n s t r u c t i o n m a n u a l
to read the General and Photo Tips sections.
#6148.01 for Canon SX10 IS
We also suggest that you read your camera manual thoroughly
to have a full understanding of each camera function.
I In ni it ti ia al l C Ca am me er ra a S Se et tu up p
1. Set ISO to 80.
2. Set camera mode d

Streszczenie treści zawartej na stronie nr. 2

- - I In ns st ta al ll li in ng g t th he e C Ca am me er ra a ( (c co on nt t. .) ) C Cl lo os si in ng g t th he e H Ho ou us si in ng g housing back 5. Using a coin or screwdriver (preferred), secure the camera with 1. Place housing face down in your the mounting bolt which threads into the camera’s tripod lap or on flat surface. socket ( (D Di ia ag gr ra am m B B) ). 2. Check to see that there is an o-ring on the housing back and that it is clean and in its proper C CA AU UT TI IO ON N: :

Streszczenie treści zawartej na stronie nr. 3

SUBSTROBE w/Lite DS DS 160 Full Guage 3 2 -2 Fuel Off TTL Ready Light U Us si in ng g N No on n- -I Ik ke el li it te e o or r I Ik ke el li it te e N No on n- -D DS S S Su ub bs st tr ro ob be es s U Us si in ng g S St tr ro ob be es s ( (c co on nt t. .) ) ( (S Su ub bs st tr ro ob be e 5 50 0, , 1 10 00 0A A, , 2 20 00 0, , 4 40 00 0) ) w wi it th h t th hi is s H Ho ou us si in ng g. . S Su ub bs st tr ro ob be e D DS S1 16 60 0 The Conversion Circuitry is automatically disabled when used T

Streszczenie treści zawartej na stronie nr. 4

B Ba as se e Q Qu ui ic ck k R Re el le ea as se e: : M Ma ai in nt te en na an nc ce e ( (c co on nt t. .) ) 4. Keep the back o-ring clean and lightly lubricated. To lubricate, The Housing Base may be removed from the Housing remove the o-ring from the back. Put a small amount of lkelite Tray/Handles by following the diagram below. Reverse this lubricant on your fingers. Pull the o-ring through your fingers procedure to install. to apply a light coating of lubricant. Only apply enough B ASE

Streszczenie treści zawartej na stronie nr. 5

lubricate shaft P Ph ho ot to o T Ti ip ps s 1. The number one rule in underwater photography is eliminate housing as much water between camera and subject as possible. Get as close as you can to the subject, then use the zoom. If you are using flash, subjects beyond 6 feet (1.8m)will not have pull out to expose shaft much color. 2. The camera’s built-in flash is very close to the camera lens. The flash can light up any suspended particles in the water and they Diagram D can be recorded in your