Instrukcja obsługi Xerox 255 ST

Streszczenie treści zawartej na stronie nr. 1

240/
4. Enable the network interface and protocol.
Before You Start c) The Touch Screen will be used for the
remainder of the data entry.
a) Press the TCP/IP Settings button.
If your printer is equipped with a
3. Enter the Network Setup menus.
interface, use the Token Ring Quick Install
b) Press the Protocol and Media button.
Card supplied in this Quick Install Card set to
a) Wait for the screen to refresh and
set the Ring Speed and Source Routing settings
c) Press the Enable button, once

Streszczenie treści zawartej na stronie nr. 2

240/ b) Go to a workstation and... c) One at a time press the soft buttons ouch Screen for each octet of on the T the Touch Screen for each octet of the 1. Create a new printer and load print drivers the broadcast address and enter the Subnet Mask and enter the numbers from the CD-ROM. numbers from the keypad. When from the keypad. Repeat this process finished press the Save button on the for the IP Gateway address. When 2. Create a printer share and its access touch screen and you will