Streszczenie treści zawartej na stronie nr. 1
900 MHz Digital Spread
Spectrum Cordless Phone
with Dual Caller ID, Dual Keypad,
and Speakerphone
Owner’s Manual
Please read before using this equipment.
Streszczenie treści zawartej na stronie nr. 2
Important Information This phone has been tested and found to • caller's number only comply with all applicable UL and FCC stan- • caller's name only dards. • caller's name and number. WARNING: To reduce the risk of fire or shock hazard, do not expose this product to rain READ THIS BEFORE or moisture. INSTALLATION CAUTION We have designed your phone to conform to RISK OF ELECTRIC SHOCK. federal regulations, and you can connect it to ! DO NOT OPEN. most telephone lines. However, each phone CAU
Streszczenie treści zawartej na stronie nr. 3
Important: dures that could affect the operation of this telephone. The telephone company notifies • Cordless phones such as this one you of these changes in advance, so you can require AC power to operate. When the take the necessary steps to prevent interrup- AC power is off, you cannot dial out or tion of your telephone service. receive incoming calls using your phone. For this reason, the phone LIGHTNING should not be your only telephone. To be safe, you should also have a phone that Your te
Streszczenie treści zawartej na stronie nr. 4
these openings must not be blocked or IMPORTANT SAFETY covered. The openings should never be INSTRUCTIONS blocked by placing the product on a bed, sofa, rug, or other similar surface. This When using your telephone equipment, ba- product should never be placed near or sic safety precautions should always be fol- over a radiator or heat register. This lowed to reduce the risk of fire, electric shock product should not be placed in a built-in and injury to persons, including the following: instal
Streszczenie treści zawartej na stronie nr. 5
• If liquid has been spilled into the prod- and may cause damage to the eyes or uct. skin. It may be toxic if swallowed. • If the product has been exposed to rain 4. Exercise care in handling the battery or water. pack in order not to short it with conduct- ing materials such as rings, bracelets, • If the product does not operate normally and keys. The battery or conductor may by following the operating instructions. overheat and cause burns. Adjust only those controls that are cov- ered by the
Streszczenie treści zawartej na stronie nr. 6
Contents Features .................................................................................................................................. 8 Installation .............................................................................................................................. 9 Mounting the Phone .......................................................................................................... 9 On a Desktop ................................................................
Streszczenie treści zawartej na stronie nr. 7
Caller ID Messages ................................................................................................. 23 Adding/Deleting the Area Code ...................................................................................... 23 Dialing Numbers from a Caller ID Record ...................................................................... 23 Storing a Caller ID Record to Memory ............................................................................ 24 Deleting Caller ID Records ..
Streszczenie treści zawartej na stronie nr. 8
Features Headset Jack Your RadioShack Digital 900 MHz Dual Key- — lets you connect an option- pad Cordless Speakerphone operates on the al headset for handsfree convenience. 900 MHz band, which means less interfer- Volume Controls — let you adjust the vol- ence, clearer sound, and greater range than ume you hear through the handset and 46/49 MHz cordless telephones. The Caller speakerphone. ID records each caller's telephone number (and name, if available in your area) and the Ringer Volume
Streszczenie treści zawartej na stronie nr. 9
Installation Note: The base's display is protected during adapter from AC power before you dis- shipment by a piece of film. Carefully peel off connect it from the phone. this film before using your phone for the first Your telephone connects directly to a modu- time. lar telephone line jack. If your telephone wir- ing does not have a modular jack, you can MOUNTING THE PHONE update the wiring yourself using jacks and adapters (available at your local RadioShack You can place the phone's base
Streszczenie treści zawartej na stronie nr. 10
5. Route the adapter’s cord through the plate studs and slide the phone down- strain relief slot on the bottom of the ward to secure it. bracket. 6. Plug the adapter into a standard AC out- let. 7. Lift the base’s antenna to a vertical posi- tion. On a Wall Plate or Wall 6. Plug the adapter into a standard AC out- 1. Insert the bracket’s tabs into the base’s let. lower tab slots, then press down on the bracket’s clips and insert them into the 7. Lift the base’s antenna to a vertical posi- clip s
Streszczenie treści zawartej na stronie nr. 11
the handset to the base for about 5 sec- CONNECTING, CHARGING, onds. AND REPLACING THE BATTERY PACK • Using a pencil eraser, clean the charg- ing contacts on the handset and base The phone comes with a rechargeable nick- about once a month. el-cadmium (Ni-Cd) battery pack in the hand- set. Before using your phone, you must • If the battery pack becomes weak during connect the battery pack, then charge it for a call, the handset beeps every 3 sec- about 24 hours. onds and Be Be Be Bemý mý mý mý
Streszczenie treści zawartej na stronie nr. 12
If you have trouble replacing the battery set to pulse mode or to set to tone mode. * pack, take the phone to your local Ra- The phone beeps and displays Fk Fk Fk Fkbbbbiiii[[[[ýýýý::::____WWWWbbbb____dddd]]]] dioShack store for assistance. or Je Je Je Jedddd[[[[ýýýý::::____WWWWbbbb____dddd]]]], then the display clears. Important: The EPA certified Note: The phone exits the setting mode if a ® RBRC Battery Recycling Seal call or page is received, or if you press TALK on the nickel-cadmium (Ni-C
Streszczenie treści zawartej na stronie nr. 13
the handset also rings (unless you set the With the Opt setting, you can use the ad- handset’s ringer to off). vanced Caller ID/Call Waiting options. See “Call Waiting Options Service” on Page 21. TURNING AUTO TALK ON/ STORING YOUR AREA OFF CODE Your phone is preset so you must press TALK when you lift the handset from the base You can store your local area code in the to answer a call. With auto talk turned on, phone’s Caller ID record so it does not show you can answer a call by just lifting
Streszczenie treści zawartej na stronie nr. 14
Operation Note: SPEAKER To use the speakerphone, you must To end a speakerphone call, press use the base keypad; to use the handset, again. you must use the handset keypad. RECEIVING A CALL MAKING A CALL When the phone receives a call, ?d ?d ?d ?dYec Yec Yec Yec____dddd]]]] 9W 9W 9W 9Wbbbbbbbb appears. If you subscribe to Caller ID service Using the Handset from your telephone company, the number and name (if available) also appear. To make a call, lift the handset and press TALK . JW JW JW
Streszczenie treści zawartej na stronie nr. 15
an error beep. Move closer to the base and conversation. 9ed\ 9ed\ 9ed\ 9ed\[h[dY[ [h[dY[ [h[dY[ [h[dY[ appears on the try again. base's display and CHARGE/IN USE lights. During the call, one person can hang up and USING MUTE let the call continue at the other keypad. Or, both people can hang up to end the call. To talk to someone in the room while using the speakerphone without the person on the Note: If you hear a high-pitched noise from other end of the phone line hearing your con- the base's
Streszczenie treści zawartej na stronie nr. 16
• The redial memory holds up to 32 digits, In either case, if the called party does not an- so you can redial any long-distance swer within 1 minute, the paging stops. number as well as local numbers. Press SELECT/INTCM or INTCM again to re- start paging. • The redial memory also holds pause entries (see “Entering a Pause” on To end an intercom call, press TALK on the Page19). handset, press SPEAKER on the base, or hang up the handset. USING TONE SERVICES ON If a call comes in during an interco
Streszczenie treści zawartej na stronie nr. 17
press SPEAKER. The call is released from handset. You can also make or answer calls hold and transferred to the handset and the by pressing the SPEAKER button located on display changes to >WdZi[j >WdZi[j >WdZi[j >WdZi[j _d _d _d _d Ki[ Ki[ Ki[ Ki[. To bring the base. the base back into the conversation for a You can use a handset holder (available three-way conference, press SPEAKER from your local RadioShack store) to hang again. the handset on your belt for greater conve- nience. OUT OF RANGE
Streszczenie treści zawartej na stronie nr. 18
Follow these steps to store a number and next position, then press 2 twice so 8 8 8 8 name in the handset. appears. 1. Lift the handset. To enter a space, press FLASH7 7 7 7 twice without entering any character. 2. Hold down MEM until C[c C[c C[c C[ce ee ehoý hoý hoý hoýI I I Ijeh[ jeh[ jeh[ jeh[ and a list of memory location numbers (and To enter a number, repeatedly press the names, if any) appear. corresponding number key until the number appears. 3. Select an empty memory location (or the on
Streszczenie treści zawartej na stronie nr. 19
desired option then press SELECT/ Storing a Number in the Base INTCM to choose it. Follow these steps to store numbers in the Menu Options: base: • ;Z_jý ;Z_jý ;Z_jý ;Z_jý C C C C[cehodd [cehodd [cehodd [cehodd — edit the record as 1. Hold down MEMORY until Ij Ij Ij Ijeh[ eh[ eh[ eh[ DkcX[h DkcX[h DkcX[h DkcX[h described in Steps 5 through 8 of “Stor- appears on the base's display. ing a Name and Number in the Hand- 2. Enter the phone number and any tone or set’s Memory” on Page 17. pause entrie
Streszczenie treści zawartej na stronie nr. 20
To dial a number stored in the base's memo- Reviewing Memory Numbers ry, press MEMORY. I[ I[ I[ I[b[Yj b[Yj b[Yj b[Yj BeYWj_ed BeYWj_ed BeYWj_ed BeYWj_ed appears. Handset Press a number key (0–9); the display shows the number contained in the selected memo- To review your memory numbers stored in ry location. Press SPEAKER to dial the num- the handset, press MEM. The list of memory ber on the display. location numbers (&'&'&'&'–(& (& (& (&) and the name stored with each number (orý2 ý2 ý2 ý2C C
